A Minimal Sensor Inertial Measurement Unit System Is Replicable and Capable of Estimating Bilateral Lower-Limb Kinematics in a Stationary Bodyweight Squat and a Countermovement Jump.

This study aimed to validate a 7-sensor inertial measurement unit system against optical motion capture to estimate bilateral lower-limb kinematics. Hip, knee, and ankle sagittal plane peak angles and range of motion (ROM) were compared during bodyweight squats and countermovement jumps in 18 participants. In the bodyweight squats, left peak hip flexion (intraclass correlation coefficient [ICC] = .51), knee extension (ICC = .68) and ankle plantar flexion (ICC = .55), and hip (ICC = .63) and knee (ICC = .52) ROM had moderate agreement, and right knee ROM had good agreement (ICC = .77). Relatively higher agreement was observed in the countermovement jumps compared to the bodyweight squats, moderate to good agreement in right peak knee flexion (ICC = .73), and right (ICC = .75) and left (ICC = .83) knee ROM. Moderate agreement was observed for right ankle plantar flexion (ICC = .63) and ROM (ICC = .51). Moderate agreement (ICC > .50) was observed in all variables in the left limb except hip extension, knee flexion, and dorsiflexion. In general, there was poor agreement for peak flexion angles, and at least moderate agreement for joint ROM. Future work will aim to optimize methodologies to increase usability and confidence in data interpretation by minimizing variance in system-based differences and may also benefit from expanding planes of movement.

Validation of Spatiotemporal and Kinematic Measures in Functional Exercises Using a Minimal Modeling Inertial Sensor Methodology.

This study proposes a minimal modeling magnetic, angular rate and gravity (MARG) methodology for assessing spatiotemporal and kinematic measures of functional fitness exercises. Thirteen healthy persons performed repetitions of the squat, box squat, sandbag pickup, shuffle-walk, and bear crawl. Sagittal plane hip, knee, and ankle range of motion (ROM) and stride length, stride time, and stance time measures were compared for the MARG method and an optical motion capture (OMC) system. The root mean square error (RMSE), mean absolute percentage error (MAPE), and Bland-Altman plots and limits of agreement were used to assess agreement between methods. Hip and knee ROM showed good to excellent agreement with the OMC system during the squat, box squat, and sandbag pickup (RMSE: 4.4-9.8°), while ankle ROM agreement ranged from good to unacceptable (RMSE: 2.7-7.2°). Unacceptable hip and knee ROM agreement was observed for the shuffle-walk and bear crawl (RMSE: 3.3-8.6°). The stride length, stride time, and stance time showed good to excellent agreement between methods (MAPE: (3.2 ± 2.8)%-(8.2 ± 7.9)%). Although the proposed MARG-based method is a valid means of assessing spatiotemporal and kinematic measures during various exercises, further development is required to assess the joint kinematics of small ROM, high velocity movements.

Inertial-Based Human Motion Capture: A Technical Summary of Current Processing Methodologies for Spatiotemporal and Kinematic Measures.

Inertial-based motion capture (IMC) has been suggested to overcome many of the limitations of traditional motion capture systems. The validity of IMC is, however, suggested to be dependent on the methodologies used to process the raw data collected by the inertial device. The aim of this technical summary is to provide researchers and developers with a starting point from which to further develop the current IMC data processing methodologies used to estimate human spatiotemporal and kinematic measures. The main workflow pertaining to the estimation of spatiotemporal and kinematic measures was presented, and a general overview of previous methodologies used for each stage of data processing was provided. For the estimation of spatiotemporal measures, which includes stride length, stride rate, and stance/swing duration, measurement thresholding and zero-velocity update approaches were discussed as the most common methodologies used to estimate such measures. The methodologies used for the estimation of joint kinematics were found to be broad, with the combination of Kalman filtering or complimentary filtering and various sensor to segment alignment techniques including anatomical alignment, static calibration, and functional calibration methods identified as being most common. The effect of soft tissue artefacts, device placement, biomechanical modelling methods, and ferromagnetic interference within the environment, on the accuracy and validity of IMC, was also discussed. Where a range of methods have previously been used to estimate human spatiotemporal and kinematic measures, further development is required to reduce estimation errors, improve the validity of spatiotemporal and kinematic estimations, and standardize data processing practices. It is anticipated that this technical summary will reduce the time researchers and developers require to establish the fundamental methodological components of IMC prior to commencing further development of IMC methodologies, thus increasing the rate of development and utilisation of IMC.

The Biomechanical Characteristics of the Strongman Yoke Walk.

The yoke walk is a popular strongman exercise where athletes carry a heavily loaded frame balanced across the back of their shoulders over a set distance as quickly as possible. The aim of this study was to use ecologically realistic training loads and carry distances to (1) establish the preliminary biomechanical characteristics of the yoke walk; (2) identify any biomechanical differences between male and female athletes performing the yoke walk; and (3) determine spatiotemporal and kinematic differences between stages (intervals) of the yoke walk. Kinematic and spatiotemporal measures of hip and knee joint angle, and mean velocity, stride length, stride rate and stance duration of each 5 m interval were taken whilst 19 strongman athletes performed three sets of a 20 m yoke walk at 85% of their pre-determined 20 m yoke walk one repetition maximum. The yoke walk was characterised by flexion of the hip and slight to neutral flexion of the knee at heel strike, slight to neutral extension of the hip and flexion of the knee at toe-off and moderate hip and knee range of motion (ROM), with high stride rate and stance duration, and short stride length. Between-interval comparisons revealed increased stride length, stride rate and lower limb ROM, and decreased stance duration at greater velocity. Although no main between-sex differences were observed, two-way interactions revealed female athletes exhibited greater knee extension at toe-off and reduced hip ROM during the initial (0-5 m) when compared with the final three intervals (5-20 m), and covered a greater distance before reaching maximal normalised stride length than males. The findings from this study may better inform strongman coaches, athletes and strength and conditioning coaches with the biomechanical knowledge to: provide athletes with recommendation on how to perform the yoke walk based on the technique used by experienced strongman athletes; better prescribe exercises to target training adaptations required for improved yoke walk performance; and better coach the yoke walk as a training tool for non-strongman athletes.

The biomechanical characteristics of the strongman atlas stone lift.

BACKGROUND: The atlas stone lift is a popular strongman exercise where athletes are required to pick up a large, spherical, concrete stone and pass it over a bar or place it on to a ledge. The aim of this study was to use ecologically realistic training loads and set formats to (1) establish the preliminary biomechanical characteristics of athletes performing the atlas stone lift; (2) identify any biomechanical differences between male and female athletes performing the atlas stone lift; and (3) determine temporal and kinematic differences between repetitions of a set of atlas stones of incremental mass. METHODS: Kinematic measures of hip, knee and ankle joint angle, and temporal measures of phase and repetition duration were collected whilst 20 experienced strongman athletes (female: n = 8, male: n = 12) performed three sets of four stone lifts of incremental mass (up to 85% one repetition maximum) over a fixed-height bar. RESULTS: The atlas stone lift was categorised in to five phases: the recovery, initial grip, first pull, lap and second pull phase. The atlas stone lift could be biomechanically characterised by maximal hip and moderate knee flexion and ankle dorsiflexion at the beginning of the first pull; moderate hip and knee flexion and moderate ankle plantarflexion at the beginning of the lap phase; moderate hip and maximal knee flexion and ankle dorsiflexion at the beginning of the second pull phase; and maximal hip, knee extension and ankle plantarflexion at lift completion. When compared with male athletes, female athletes most notably exhibited: greater hip flexion at the beginning of the first pull, lap and second pull phase and at lift completion; and a shorter second pull phase duration. Independent of sex, first pull and lap phase hip and ankle range of motion (ROM) were generally smaller in repetition one than the final three repetitions, while phase and total repetition duration increased throughout the set. Two-way interactions between sex and repetition were identified. Male athletes displayed smaller hip ROM during the second pull phase of the first three repetitions when compared with the final repetition and smaller hip extension at lift completion during the first two repetitions when compared with the final two repetitions. Female athletes did not display these between-repetition differences. CONCLUSIONS: Some of the between-sex biomechanical differences observed were suggested to be the result of between-sex anthropometric differences. Between-repetition differences observed may be attributed to the increase in stone mass and acute fatigue. The biomechanical characteristics of the atlas stone lift shared similarities with the previously researched Romanian deadlift and front squat. Strongman athletes, coaches and strength and conditioning coaches are recommended to take advantage of these similarities to achieve greater training adaptations and thus performance in the atlas stone lift and its similar movements.

A systematic review of the biomechanical research methods used in strongman studies.

As the sport of strongman is becoming increasingly popular, and such exercises are being commonly used by strength and conditioning coaches for a wide range of athletic groups, a greater understanding of the biomechanics of strongman exercises is warranted. To improve the quality of research, this systematic review summarised the research methodology used in biomechanical studies of strongman exercises and identified potential improvements to current approaches. A search of 5 databases found 10 articles adherent to the pre-defined inclusion criteria. The studies assessed 8 strongman exercises and included male participants of relatively similar body mass but varying training backgrounds. Due to the complexity of strongman exercises and the challenges in collecting advanced biomechanical data in the field, most studies used simplified measurement/analysis methods (e.g., 2D motion capture). Future strongman biomechanical studies should: assess under/un-researched strongman exercises; include a greater number of experienced and female strongman athletes; utilise more advanced (e.g., 3D motion capture and/or inertial sensor) technology so to provide a broader range and greater quality of data. Such approaches will provide strength and conditioning coaches, strongman coaches and athletes with a greater understanding of strongman exercises, thereby further improving exercise prescription, athlete performance and minimising risk of injury.

Correction to: The biomechanics and applications of strongman exercises: a systematic review.

The original article [1] contained an error whereby the symbol '☼' originally included in and below Tables 2-5 did not display properly.

The Biomechanics and Applications of Strongman Exercises: a Systematic Review.

BACKGROUND: The sport of strongman is becoming increasingly popular, catering for females, lightweight, and Masters competitors, with strongman exercises also being used by strength and conditioning coaches for a range of athletic groups. Thus, a systematic review was conducted to examine researchers' current understanding of the biomechanics of strongman exercises, with a view to improve strongman athlete performance, provide biomechanical evidence supporting the transferability of strongman exercises to strength and conditioning/rehabilitation programs, and identify gaps in the current knowledge of the biomechanics of strongman exercises. METHODS: A two-level search term strategy was used to search five databases for studies relevant to strongman exercises and biomechanics. RESULTS: Eleven articles adherent to the inclusion criteria were returned from the search. The studies provided preliminary biomechanical analysis of various strongman exercises including the key biomechanical performance determinants of the farmer's walk, heavy sled pull, and tire flip. Higher performing athletes in the farmer's walk and heavy sled pull were characterized by a greater stride length and stride rate and reduced ground contact time, while higher performing athletes in the tire flip were characterized by a reduced second pull phase time when compared with lower performing athletes. Qualitative comparison of carrying/walking, pulling and static lifting strongman, traditional weight training exercises (TWTE), and common everyday activities (CEA), like loaded carriage and resisted sprinting, were discussed to further researchers' understanding of the determinants of various strongman exercises and their applications to strength and conditioning practice. A lack of basic quantitative biomechanical data of the yoke walk, unilateral load carriage, vehicle pull, atlas stone lift and tire flip, and biomechanical performance determinants of the log lift were identified. CONCLUSIONS: This review has demonstrated the likely applicability and benefit of current and future strongman exercise biomechanics research to strongman athletes and coaches, strength and conditioning coaches considering using strongman exercises in a training program, and tactical operators (e.g., military, army) and other manual labor occupations. Future research may provide a greater understanding of the biomechanical determinants of performance, potential training adaptations, and risks expected when performing and/or incorporating strongman exercises into strength and conditioning or injury rehabilitation programs.