RESUMEN
Two-dimensional materials have shown immense promise for gas-sensing applications due to their remarkable surface-to-volume ratios and tunable chemical properties. However, despite their potential, the utilization of ReSe2 as a gas-sensing material for nitrogen-containing molecules, including NO2, NO, and NH3, has remained unexplored. The choice of doping atoms in ReSe2 plays a pivotal role in enhancing the gas adsorption and gas-sensing capabilities. Herein, the adsorption properties of nitrogen-containing gas molecules on metal and non-metal single-atom (Au, Pt, Ni, P, and S)-doped ReSe2 monolayers have been evaluated systematically via ab initio calculations based on density functional theory. The findings strongly suggest that intrinsic ReSe2 has better selectivity toward NO2 than toward NO and NH3. Moreover, our results provide compelling evidence that all of the dopants, with the exception of S, significantly enhance both the adsorption strength and charge transfer between ReSe2 and the investigated molecules. Notably, P-decorated ReSe2 showed the highest adsorption energy for NO2 and NO (-1.93 and -1.52 eV, respectively) with charge transfer above 0.5e, while Ni-decorated ReSe2 exhibited the highest adsorption energy for NH3 (-0.76 eV). In addition, on the basis of transition theory, we found that only Au-ReSe2 and Ni-ReSe2 can serve as reusable chemiresisitve gas sensors for reliable detection of NO and NH3, respectively. Hence, our findings indicate that gas-sensing applications can be significantly improved by utilizing a single-atom-doped ReSe2 monolayer.
RESUMEN
Flexible ammonia (NH3) gas sensors have gained increasing attention for their potential in medical diagnostics and health monitoring, as they serve as a biomarker for kidney disease. Utilizing the pre-designable and porous properties of covalent organic frameworks (COFs) is an innovative way to address the demand for high-performance NH3 sensing. However, COF particles frequently encounter aggregation, low conductivity, and mechanical rigidity, reducing the effectiveness of portable NH3 detection. To overcome these challenges, we propose a practical approach using polyvinyl alcohol-carrageenan (κPVA) as a template for in the situ growth of two-dimensional COF film and particles to produce a flexible hydrogel gas sensor (COF/κPVA). The synergistic effect of COF and κPVA enhances the gas sensing, water retention, and mechanical properties. The COF/κPVA hydrogel shows a 54.4% response to 1 ppm NH3 with a root mean square error of less than 5% and full recovery compared to the low response and no recovery of bare κPVA. Owing to the dual effects of the COF film and the particles anchoring the water molecules, the COF/κPVA hydrogel remained stable after 70 h in atmospheric conditions, in contrast, the bare κPVA hydrogel was completely dehydrated. Our work might pave the way for highly sensitive hydrogel gas sensors, which have intriguing applications in flexible electronic devices for gas sensing.
RESUMEN
Particulate air pollution is a global environmental problem, with PM2.5 being the primary pollutant. One of the most effective ways to remove particles from the air is through filtration. Therefore, high-performance air filters are urgently needed to combat the harm caused by PM2.5. This study uses an electrospinning technique to prepare high-efficiency polyvinylidene fluoride/graphene oxide/polyimide nanofiber membranes. These composite nanofiber membranes demonstrate high filtration efficiency (99.6%), low pressure drop (123 Pa), remarkable thermal stability (450 °C), and excellent mechanical strength (7 MPa). Considering the advantages, these highly efficient nanofiber membranes can find advanced applications in industrial and civil infrastructures.
RESUMEN
Rapid and ultrasensitive detection of toxic gases at room temperature is highly desired in health protection but presents grand challenges in the sensing materials reported so far. Here, we present a gas sensor based on novel zero dimensional (0D)/two dimensional (2D) indium oxide (In2O3)/titanium carbide (Ti3C2Tx) Schottky heterostructures with a high surface area and rich oxygen vacancies for parts per billion (ppb) level nitrogen dioxide (NO2) detection at room temperature. The In2O3/Ti3C2Tx gas sensor exhibits a fast response time (4 s), good response (193.45% to 250 ppb NO2), high selectivity, and excellent cycling stability. The rich surface oxygen vacancies play the role of active sites for the adsorption of NO2 molecules, and the Schottky junctions effectively adjust the charge-transfer behavior through the conduction tunnel in the sensing material. Furthermore, In2O3 nanoparticles almost fully cover the Ti3C2Tx nanosheets which can avoid the oxidation of Ti3C2Tx, thus contributing to the good cycling stability of the sensing materials. This work sheds light on the sensing mechanism of heterojunction nanostructures and provides an efficient pathway to construct high-performance gas sensors through the rational design of active sites.
Asunto(s)
Indio , Dióxido de Nitrógeno , Temperatura , Titanio , Dióxido de Nitrógeno/análisis , Dióxido de Nitrógeno/química , Titanio/química , Indio/química , PorosidadRESUMEN
Real-time and accurate biomarker detection is highly desired in point-of-care diagnosis, food freshness monitoring, and hazardous leakage warning. However, achieving such an objective with existing technologies is still challenging. Herein, we demonstrate a wireless inductor-capacitor (LC) chemical sensor based on platinum-doped partially deprotonated-polypyrrole (Pt-PPy+ and PPy0) for real-time and accurate ammonia (NH3) detection. With the chemically wide-range tunability of PPy in conductivity to modulate the impedance, the LC sensor exhibits an up-to-180% improvement in return loss (S11). The Pt-PPy+ and PPy0 shows the p-type semiconductor nature with greatly-manifested adsorption-charge transfer dynamics toward NH3, leading to an unprecedented NH3 sensing range. The S11 and frequency of the Pt-PPy+ and PPy0-based sensor exhibit discriminative response behaviors to humidity and NH3, enabling the without-external-calibration compensation and accurate NH3 detection. A portable system combining the proposed wireless chemical sensor and a handheld instrument is validated, which aids in rationalizing strategies for individuals toward various scenarios.