RESUMEN
Graphene placed on hexagonal-boron nitride (h-BN) experiences a superlattice (Moiré) potential, which leads to a strong reconstruction of graphene's electronic spectrum with new Dirac points emerging at sub-eV energies. Here we study the effect of such superlattices on graphene's Raman spectrum. In particular, the 2D Raman peak is found to be exquisitely sensitive to the misalignment between graphene and h-BN lattices, probably due to the presence of a strain distribution with the same periodicity of the Moiré potential. This feature can be used to identify graphene superlattices with a misalignment angle smaller than 2°.
RESUMEN
We present the first Raman spectroscopic study of Bernal bilayer graphene flakes under uniaxial tension. Apart from a purely mechanical behavior in flake regions where both layers are strained evenly, certain effects stem from inhomogeneous stress distribution across the layers. These phenomena such as the removal of inversion symmetry in bilayer graphene may have important implications in the band gap engineering, providing an alternative route to induce the formation of a band gap.
Asunto(s)
Grafito/química , Membranas Artificiales , Fonones , Estructura Molecular , Polímeros/química , Espectrometría RamanRESUMEN
We investigate the electronic properties of ultrathin hexagonal boron nitride (h-BN) crystalline layers with different conducting materials (graphite, graphene, and gold) on either side of the barrier layer. The tunnel current depends exponentially on the number of h-BN atomic layers, down to a monolayer thickness. Conductive atomic force microscopy scans across h-BN terraces of different thickness reveal a high level of uniformity in the tunnel current. Our results demonstrate that atomically thin h-BN acts as a defect-free dielectric with a high breakdown field. It offers great potential for applications in tunnel devices and in field-effect transistors with a high carrier density in the conducting channel.
Asunto(s)
Compuestos de Boro/química , Nanoestructuras/química , Nanoestructuras/ultraestructura , Semiconductores , Conductividad Eléctrica , Transporte de Electrón , Ensayo de Materiales , Tamaño de la PartículaRESUMEN
Devices made from graphene encapsulated in hexagonal boron-nitride exhibit pronounced negative bend resistance and an anomalous Hall effect, which are a direct consequence of room-temperature ballistic transport at a micrometer scale for a wide range of carrier concentrations. The encapsulation makes graphene practically insusceptible to the ambient atmosphere and, simultaneously, allows the use of boron nitride as an ultrathin top gate dielectric.
Asunto(s)
Compuestos de Boro/química , Grafito/química , Temperatura , Electrónica , Propiedades de SuperficieRESUMEN
A stoichiometric derivative of graphene with a fluorine atom attached to each carbon is reported. Raman, optical, structural, micromechanical, and transport studies show that the material is qualitatively different from the known graphene-based nonstoichiometric derivatives. Fluorographene is a high-quality insulator (resistivity >10(12) Ω) with an optical gap of 3 eV. It inherits the mechanical strength of graphene, exhibiting a Young's modulus of 100 N m(-1) and sustaining strains of 15%. Fluorographene is inert and stable up to 400 °C even in air, similar to Teflon.
Asunto(s)
Grafito/química , Politetrafluoroetileno/química , Halogenación , Microscopía Electrónica de Transmisión , Espectrometría RamanRESUMEN
Understanding magnetoresistance, the change in electrical resistance under an external magnetic field, at the atomic level is of great interest both fundamentally and technologically. Graphene and other two-dimensional layered materials provide an unprecedented opportunity to explore magnetoresistance at its nascent stage of structural formation. Here we report an extremely large local magnetoresistance of â¼2,000% at 400 K and a non-local magnetoresistance of >90,000% in an applied magnetic field of 9 T at 300 K in few-layer graphene/boron-nitride heterostructures. The local magnetoresistance is understood to arise from large differential transport parameters, such as the carrier mobility, across various layers of few-layer graphene upon a normal magnetic field, whereas the non-local magnetoresistance is due to the magnetic field induced Ettingshausen-Nernst effect. Non-local magnetoresistance suggests the possibility of a graphene-based gate tunable thermal switch. In addition, our results demonstrate that graphene heterostructures may be promising for magnetic field sensing applications.
RESUMEN
Atomically thin layers of materials, which are just a few atoms in thickness, present an attractive option for future electronic devices. Herein we characterize, optically and electronically, atomically thin tungsten disulphide (WS2), a layered semiconductor. We provide the distinctive Raman and photoluminescence signatures for single layers, and prepare field-effect transistors where atomically thin WS2 serves as the conductive channel. The transistors present mobilities µ = 10 cm(2) V(-1) s(-1) and exhibit ON/OFF ratios exceeding 100,000. Our results show that WS2 is an attractive option for applications in electronic and optoelectronic devices and pave the way for further studies in this two-dimensional material.
RESUMEN
Irradiation with high-energy ions has been widely suggested as a tool to engineer properties of graphene. Experiments show that it indeed has a strong effect on graphene's transport, magnetic and mechanical characteristics. However, to use ion irradiation as an engineering tool requires understanding of the type and detailed characteristics of the produced defects which is still lacking, as the use of high-resolution transmission microscopy (HRTEM)--the only technique allowing direct imaging of atomic-scale defects--often modifies or even creates defects during imaging, thus making it impossible to determine the intrinsic atomic structure. Here we show that encapsulating the studied graphene sample between two other (protective) graphene sheets allows non-invasive HRTEM imaging and reliable identification of atomic-scale defects. Using this simple technique, we demonstrate that proton irradiation of graphene produces reconstructed monovacancies, which explains the profound effect that such defects have on graphene's magnetic and transport properties. This finding resolves the existing uncertainty with regard to the effect of ion irradiation on the electronic structure of graphene.
RESUMEN
Recent dramatic progress in studying various two-dimensional (2D) atomic crystals and their heterostructures calls for better and more detailed understanding of their crystallography, reconstruction, stacking order, etc. For this, direct imaging and identification of each and every atom is essential. Transmission electron microscopy (TEM) and scanning transmission electron microscopy (STEM) are ideal and perhaps the only tools for such studies. However, the electron beam can in some cases induce dramatic structure changes, and radiation damage becomes an obstacle in obtaining the desired information in imaging and chemical analysis in the (S)TEM. This is the case of 2D materials such as molybdenum disulfide MoS2, but also of many biological specimens, molecules, and proteins. Thus, minimizing damage to the specimen is essential for optimum microscopic analysis. In this article we demonstrate, on the example of MoS2, that encapsulation of such crystals between two layers of graphene allows for a dramatic improvement in stability of the studied 2D crystal and permits careful control over the defect nature and formation in it. We present STEM data collected from single-layer MoS2 samples prepared for observation in the microscope through three distinct procedures. The fabricated single-layer MoS2 samples were either left bare (pristine), placed atop a single-layer of graphene, or finally encapsulated between single graphene layers. Their behavior under the electron beam is carefully compared, and we show that the MoS2 sample "sandwiched" between the graphene layers has the highest durability and lowest defect formation rate compared to the other two samples, for very similar experimental conditions.
RESUMEN
The deformation of nanocomposites containing graphene flakes with different numbers of layers has been investigated with the use of Raman spectroscopy. It has been found that there is a shift of the 2D band to lower wavenumber and that the rate of band shift per unit strain tends to decrease as the number of graphene layers increases. It has been demonstrated that band broadening takes place during tensile deformation for mono- and bilayer graphene but that band narrowing occurs when the number of graphene layers is more than two. It is also found that the characteristic asymmetric shape of the 2D Raman band for the graphene with three or more layers changes to a symmetrical shape above about 0.4% strain and that it reverts to an asymmetric shape on unloading. This change in Raman band shape and width has been interpreted as being due to a reversible loss of Bernal stacking in the few-layer graphene during deformation. It has been shown that the elastic strain energy released from the unloading of the inner graphene layers in the few-layer material (~0.2 meV/atom) is similar to the accepted value of the stacking fault energies of graphite and few layer graphene. It is further shown that this loss of Bernal stacking can be accommodated by the formation of arrays of partial dislocations and stacking faults on the basal plane. The effect of the reversible loss of Bernal stacking upon the electronic structure of few-layer graphene and the possibility of using it to modify the electronic structure of few-layer graphene are discussed.
RESUMEN
The celebrated electronic properties of graphene have opened the way for materials just one atom thick to be used in the post-silicon electronic era. An important milestone was the creation of heterostructures based on graphene and other two-dimensional crystals, which can be assembled into three-dimensional stacks with atomic layer precision. Such layered structures have already demonstrated a range of fascinating physical phenomena, and have also been used in demonstrating a prototype field-effect tunnelling transistor, which is regarded to be a candidate for post-CMOS (complementary metal-oxide semiconductor) technology. The range of possible materials that could be incorporated into such stacks is very large. Indeed, there are many other materials with layers linked by weak van der Waals forces that can be exfoliated and combined together to create novel highly tailored heterostructures. Here, we describe a new generation of field-effect vertical tunnelling transistors where two-dimensional tungsten disulphide serves as an atomically thin barrier between two layers of either mechanically exfoliated or chemical vapour deposition-grown graphene. The combination of tunnelling (under the barrier) and thermionic (over the barrier) transport allows for unprecedented current modulation exceeding 1 × 10(6) at room temperature and very high ON current. These devices can also operate on transparent and flexible substrates.
RESUMEN
The stress transfer between the internal layers of multilayer graphene within polymer-based nanocomposites has been investigated from the stress-induced shifts of the 2D Raman band. This has been undertaken through the study of the deformation of an ideal composite system where the graphene flakes were placed upon the surface of a polymer beam and then coated with an epoxy polymer. It is found that the rate of band shift per unit strain for a monolayer graphene flake is virtually independent of whether it has one or two polymer interfaces (i.e., with or without an epoxy top coating). In contrast, the rate of band shift is lower for an uncoated bilayer specimen than a coated one, indicating relatively poor stress transfer between the graphene layers. Mapping of the strain in the coated bilayer regions has shown that there is strain continuity between adjacent monolayer and bilayer regions, indicating that they give rise to similar levels of reinforcement. Strain-induced Raman band shifts have also been evaluated for separate flakes of graphene with different numbers of layers, and it is found that the band shift rate tends to decrease with an increase in the number of layers, indicating poor stress transfer between the inner graphene layers. This behavior has been modeled in terms of the efficiency of stress transfer between the inner graphene layers. Taking into account the packing geometry of polymer-based graphene nanocomposites and the need to accommodate the polymer coils, these findings enable the optimum number of graphene layers for the best reinforcement to be determined. It is demonstrated that, in general, multilayer graphene will give rise to higher levels of reinforcement than monolayer material, with the optimum number of layers depending upon the separation of the graphene flakes in the nanocomposite.
RESUMEN
We present a systematic experimental and theoretical study of the two-phonon (2D) Raman scattering in graphene under uniaxial tension. The external perturbation unveils that the 2D mode excited with 785 nm has a complex line-shape mainly due to the contribution of two distinct double resonance scattering processes (inner and outer) in the Raman signal. The splitting depends on the direction of the applied strain and the polarization of the incident light. The results give new insight into the nature of the 2D band and have significant implications for the use of graphene as reinforcement in composites since the 2D mode is crucial to assess how effectively graphene uptakes an applied stress or strain.
Asunto(s)
Grafito/química , Modelos Químicos , Modelos Moleculares , Nanoestructuras/química , Nanoestructuras/ultraestructura , Espectrometría Raman/métodos , Simulación por Computador , Luz , Ensayo de Materiales , Tamaño de la Partícula , Dispersión de RadiaciónRESUMEN
Central to most applications involving monolayer graphenes is its mechanical response under various stress states. To date most of the work reported is of theoretical nature and refers to tension and compression loading of model graphenes. Most of the experimental work is indeed limited to the bending of single flakes in air and the stretching of flakes up to typically approximately 1% using plastic substrates. Recently we have shown that by employing a cantilever beam we can subject single graphenes to various degrees of axial compression. Here we extend this work much further by measuring in detail both stress uptake and compression buckling strain in single flakes of different geometries. In all cases the mechanical response is monitored by simultaneous Raman measurements through the shift of either the G or 2D phonons of graphene. Despite the infinitely small thickness of the monolayers, the results show that graphenes embedded in plastic beams exhibit remarkable compression buckling strains. For large length (l)-to-width (w) ratios (> or =0.2) the buckling strain is of the order of -0.5% to -0.6%. However, for l/w < 0.2 no failure is observed for strains even higher than -1%. Calculations based on classical Euler analysis show that the buckling strain enhancement provided by the polymer lateral support is more than 6 orders of magnitude compared to that of suspended graphene in air.