RESUMEN
The excellent catalytic activity of metallic MoS2 edges for the hydrogen evolution reaction (HER) has led to substantial efforts towards increasing the edge concentration. The 2H basal plane is less active for the HER because it is less conducting and therefore possesses less efficient charge transfer kinetics. Here we show that the activity of the 2H basal planes of monolayer MoS2 nanosheets can be made comparable to state-of-the-art catalytic properties of metallic edges and the 1T phase by improving the electrical coupling between the substrate and the catalyst so that electron injection from the electrode and transport to the catalyst active site is facilitated. Phase-engineered low-resistance contacts on monolayer 2H-phase MoS2 basal plane lead to higher efficiency of charge injection in the nanosheets so that its intrinsic activity towards the HER can be measured. We demonstrate that onset potentials and Tafel slopes of â¼-0.1 V and â¼50 mV per decade can be achieved from 2H-phase catalysts where only the basal plane is exposed. We show that efficient charge injection and the presence of naturally occurring sulfur vacancies are responsible for the observed increase in catalytic activity of the 2H basal plane. Our results provide new insights into the role of contact resistance and charge transport on the performance of two-dimensional MoS2 nanosheet catalysts for the HER.
RESUMEN
Ultrathin molybdenum disulphide (MoS2) has emerged as an interesting layered semiconductor because of its finite energy bandgap and the absence of dangling bonds. However, metals deposited on the semiconducting 2H phase usually form high-resistance (0.7 kΩ µm-10 kΩ µm) contacts, leading to Schottky-limited transport. In this study, we demonstrate that the metallic 1T phase of MoS2 can be locally induced on semiconducting 2H phase nanosheets, thus decreasing contact resistances to 200-300 Ω µm at zero gate bias. Field-effect transistors (FETs) with 1T phase electrodes fabricated and tested in air exhibit mobility values of ~50 cm(2) V(-1) s(-1), subthreshold swing values below 100 mV per decade, on/off ratios of >10(7), drive currents approaching ~100 µA µm(-1), and excellent current saturation. The deposition of different metals has limited influence on the FET performance, suggesting that the 1T/2H interface controls carrier injection into the channel. An increased reproducibility of the electrical characteristics is also obtained with our strategy based on phase engineering of MoS2.
RESUMEN
Hydrogen evolution reaction is catalysed efficiently with precious metals, such as platinum; however, transition metal dichalcogenides have recently emerged as a promising class of materials for electrocatalysis, but these materials still have low activity and durability when compared with precious metals. Here we report a simple one-step scalable approach, where MoOx/MoS2 core-shell nanowires and molybdenum disulfide sheets are exposed to dilute aqueous hydrazine at room temperature, which results in marked improvement in electrocatalytic performance. The nanowires exhibit â¼100 mV improvement in overpotential following exposure to dilute hydrazine, while also showing a 10-fold increase in current density and a significant change in Tafel slope. In situ electrical, gate-dependent measurements and spectroscopic investigations reveal that hydrazine acts as an electron dopant in molybdenum disulfide, increasing its conductivity, while also reducing the MoOx core in the core-shell nanowires, which leads to improved electrocatalytic performance.
RESUMEN
Chemical functionalization of low-dimensional materials such as nanotubes, nanowires and graphene leads to profound changes in their properties and is essential for solubilizing them in common solvents. Covalent attachment of functional groups is generally achieved at defect sites, which facilitate electron transfer. Here, we describe a simple and general method for covalent functionalization of two-dimensional transition metal dichalcogenide nanosheets (MoS2, WS2 and MoSe2), which does not rely on defect engineering. The functionalization reaction is instead facilitated by electron transfer between the electron-rich metallic 1T phase and an organohalide reactant, resulting in functional groups that are covalently attached to the chalcogen atoms of the transition metal dichalcogenide. The attachment of functional groups leads to dramatic changes in the optoelectronic properties of the material. For example, we show that it renders the metallic 1T phase semiconducting, and gives it strong and tunable photoluminescence and gate modulation in field-effect transistors.
RESUMEN
Graphene oxide (GO) has emerged as a multifunctional material that can be synthesized in bulk quantities and can be solution processed to form large-area atomic layered photoactive, flexible thin films for optoelectronic devices. This is largely due to the potential ability to tune electrical and optical properties of GO using functional groups. For the successful application of GO, it is key to understand the evolution of its optoelectronic properties as the GO undergoes a phase transition from its insulating and optically active state to the electrically conducting state with progressive reduction. In this paper, we use a combination of electrostatic force microscopy (EFM) and optical spectroscopy to monitor the emergence of the optoelectronic properties of GO with progressive reduction. EFM measurements enable, for the first time, direct visualization of charge propagation along the conducting pathways that emerge on progressively reduced graphene oxide (rGO) and demonstrate that with the increasing degree of reduction, injected charges can rapidly migrate over a distance of several micrometers, irrespective of their polarities. Direct imaging reveals the presence of an insurmountable potential barrier between reduced GO (rGO) and GO, which plays the decisive role in the charge transport. We complement charge imaging with theoretical modeling using quantum chemistry calculations that further demonstrate that the role of barrier in regulating the charge transport. Furthermore, by correlating the EFM measurements with photoluminescence imaging and electrical conductivity studies, we identify a bifunctional state in GO, where the optical properties are preserved along with good electrical conductivity, providing design principles for the development of GO-based, low-cost, thin-film optoelectronic applications.
RESUMEN
A fundamental understanding of the intrinsic optoelectronic properties of atomically thin transition-metal dichalcogenides (TMDs) is crucial for its integration into high performance semiconductor devices. Here, we investigate the transport properties of chemical vapor deposition (CVD) grown monolayer molybdenum disulfide (MoS2) under photoexcitation using correlated scanning photocurrent microscopy and photoluminescence imaging. We examined the effect of local phase transformation underneath the metal electrodes on the generation of photocurrent across the channel length with diffraction-limited spatial resolution. While maximum photocurrent generation occurs at the Schottky contacts of semiconducting (2H-phase) MoS2, after the metallic phase transformation (1T-phase), the photocurrent peak is observed toward the center of the device channel, suggesting a strong reduction of native Schottky barriers. Analysis using the bias and position dependence of the photocurrent indicates that the Schottky barrier heights are a few millielectron volts for 1T- and â¼ 200 meV for 2H-contacted devices. We also demonstrate that a reduction of native Schottky barriers in a 1T device enhances the photoresponsivity by more than 1 order of magnitude, a crucial parameter in achieving high-performance optoelectronic devices. The obtained results pave a way for the fundamental understanding of intrinsic optoelectronic properties of atomically thin TMDs where ohmic contacts are necessary for achieving high-efficiency devices with low power consumption.
RESUMEN
Atomic layers of two-dimensional (2D) materials have recently been the focus of extensive research. This follows from the footsteps of graphene, which has shown great potential for ultrathin optoelectronic devices. In this paper, we present a comprehensive study on the synthesis, characterization, and thin film photodetector application of atomic layers of InSe. Correlation between resonance Raman spectroscopy and photoconductivity measurements allows us to systematically track the evolution of the electronic band structure of 2D InSe as its thickness approaches few atomic layers. Analysis of photoconductivity spectra suggests that few-layered InSe has an indirect band gap of 1.4 eV, which is 200 meV higher than bulk InSe due to the suppressed interlayer electron orbital coupling. Temperature-dependent photocurrent measurements reveal that the suppressed interlayer interaction also results in more localized pz-like orbitals, and these orbitals couple strongly with the in-plane E' and Eâ³ phonons. Finally, we measured a strong photoresponse of 34.7 mA/W and fast response time of 488 µs for a few layered InSe, suggesting that it is a good material for thin film optoelectronic applications.
RESUMEN
Human neural stem cells (hNSCs) cultured on graphene-nanoparticle hybrid structures show a unique behavior wherein the axons from the differentiating hNSCs show enhanced growth and alignment. We show that the axonal alignment is primarily due to the presence of graphene and the underlying nanoparticle monolayer causes enhanced neuronal differentiation of the hNSCs, thus having great implications of these hybrid-nanostructures for neuro-regenerative medicine.