RESUMEN
The aim of this research was to investigate the effect of climatic conditions and their impact on seasonal variations of physico-chemical characteristics of Saanen goat milk produced over a period of 4 years. Lactation period (early, mid and late) and year were considered as factors that influence physico-chemical composition of milk. Pearson's coefficient of correlation was calculated between the physico-chemical characteristics of milk (fat, proteins, lactose, non-fat dry matter, density, freezing point, pH, titrable acidity) and climatic condition parameters (air temperature, temperature humidity index-THI, solar radiation duration, relative humidity). Results showed that all physico-chemical characteristics of Saanen goat milk varied significantly throughout the lactation period and years. The decrease of fat, protein, non-fat dry matter and lactose content in goat milk during the mid-lactation period was more pronounced than was previously reported in the literature. The highest values for these characteristics were recorded in the late lactation period. Observed variations were explained by negative correlation between THI and the physico-chemical characteristics of Saanen goat milk. This indicated that Saanen goats were very prone to heat stress, which implied the decrease of physico-chemical characteristics during hot summers.
RESUMEN
Caprine and bovine milks have a similar overall gross composition, but vary considerably in the ratios of their casein components. These differences in colloidal casein micelles could affect directly or indirectly the heat stability of caprine and bovine milks at their natural pH. In the present work, the differences in colloidal stability of caprine and bovine milk have been studied by analysing the effect of heat treatment and skimming on precipitation of proteins. Raw and heated milk samples (70 °C/5 min, 80°C/5 min and 90°C/5 min) were centrifuged at 600, 2000, and 4500 g . The amount of precipitate formed after skimming was measured and the protein composition of both precipitates and supernatants analysed using the SDS-PAGE (sodium dodecyl sulphate polyacrylamide gel electrophoresis) and densitometry. In caprine milk, the heat treatment prior to skimming had a statistically significant effect on protein precipitation. Centrifugal force had a statistically significant effect on amount of precipitate for both milks, but the amount was 2 to 4 times higher for caprine milk. When defatting the milk for electrophoresis, a centrifugal force of 600 g appeared to be the most appropriate, in order to avoid protein loss and a possible error in the interpretation of results. Results of this study could also serve as the basis for further investigations on adjusting the skimming conditions for caprine milk in industrial dairy processing environment.
Asunto(s)
Bovinos , Manipulación de Alimentos/métodos , Cabras , Calor , Leche/química , Animales , Caseínas/análisis , Caseínas/química , Centrifugación , Precipitación Química , Coloides/química , Estabilidad de Medicamentos , Electroforesis en Gel de Poliacrilamida , Grasas/análisis , Femenino , Proteínas de la Leche/análisis , Proteínas de la Leche/química , Especificidad de la EspecieRESUMEN
The objective of this study was to identify the requirements needed for selling dairy products through e-commerce, as well as current gaps and challenges that exist for small scale dairy processors (SSDPs), and need to be addressed in order to comply with those requirements. A mixed method research design was used for training needs assessment. Qualitative (in-depth interview with 7 online platform representatives (OPRs)) and quantitative approach (survey questionnaire with 58 SSDPs) were conducted. Interview transcripts were coded and codes were grouped into seven themes. Hierarchical cluster analysis was applied to 146 answers from 58 SSDPs. They were divided into 4 clusters. Mean sums of responses between clusters were compared by Mann-Whitney U test. OPRs suggested that SSDPs should be provided with tools and resources to help them achieve food safety and quality targets, as well as practical knowledge and skills. They reported that it is crucial to find a solution for the cold chain transportation, for maintaining consistent product quality. Survey results showed that SSDPs use kitchen equipment (79.3%) and kitchen cleaning products (81.0%) for dairy processing. In total, 43.1% process raw milk and only 24.1% have product label on the package. Only members of cluster 3 and 4 sell their products online (73.7% and 90.0%, respectively), mostly using their own social media platforms (57.9% and 60.0%, respectively), transporting products to end buyers by themselves in hand refrigerators (47.4% and 70.0%, respectively). By analyzing the differences among clusters of SSDPs, trainings can be tailored to the characteristics and knowledge gaps of each group.
RESUMEN
Goat cheeses from high heat treated milk (HHTM: 80 °C/5 min (E1) and 90 °C/5 min (E2)), could be regarded as new products, compared to their analogues made from commonly pasteurized milk (65 °C/30 min (C)). Descriptive analysis and consumer tests with a hedonic scale and JAR scale were part of the product development process. The use of scanning electron microscopy enabled deeper insight into the flavor and texture of the cheeses. In all cheese variants, goaty flavor was mildly pronounced. Young HHTM cheeses also had a pronounced whey and cooked/milky flavor. Consumers found such flavor 'too intensive'. Unlike the control variant, HHTM cheeses were not described as 'too hard'. Such improvement in texture was found to be a result of fine, highly branched microstructure, sustained over the course of ripening time and highly incorporated milk fat globules inside the cheese mass. Cluster analysis showed that the largest group of consumers (47.5%) preferred E2 cheese. Although consumers found that most of the cheeses were 'too salty', this excess did not decrease their overall acceptance. Neither microstructure analysis nor descriptive sensory analysis of goat white brined cheeses produced from high heat treated milk has been done before.
RESUMEN
Rennet coagulation of goat milk heated to 65 °C/30 min (Gc), 80 °C/5 min (G8) and 90 °C/5 min (G9) was studied. A rheometer equipped with a vane geometry tool was used to measure milk coagulation parameters and viscoelastic properties of rennet gels. Yield parameters: curd yield, laboratory curd yield and curd yield efficiency were measured and calculated. Scanning electron microscopy of rennet gels was conducted. Storage moduli (G') of gels at the moment of cutting were 19.9 ± 1.71 Pa (Gc), 11.9 ± 1.96 Pa (G8) and 7.3 ± 1.46 Pa (G9). Aggregation rate and curd firmness decreased with the increase of milk heating temperature, while coagulation time did not change significantly. High heat treatment of goat milk had a significant effect on both laboratory curd yield and curd yield. However, laboratory curd yield (27.7 ± 1.84%) of the G9 treatment was unreasonably high compared to curd yield (15.4 ± 0.60%). The microstructure of G9 was notably different compared to Gc and G8, with a denser and more compact microstructure, smaller paracasein micelles and void spaces in a form of cracks indicating weaker cross links. The findings of this study might serve as the bases for the development of different cheese types produced from high-heat-treated goat milk.