Bioconcentration studies with the freshwater amphipod Hyalella azteca: are the results predictive of bioconcentration in fish?

Bioconcentration factors (BCF) for regulatory purposes are usually determined by fish flow-through tests according to technical guidance document OECD 305. Fish bioconcentration studies are time consuming, expensive, and use many laboratory animals. The aim of this study was to investigate whether the freshwater amphipod Hyalella azteca can be used as an alternative test organism for bioconcentration studies. Fourteen substances of different hydrophobicity (log Kow 2.4-7.6) were tested under flow-through conditions to determine steady state and kinetic bioconcentration factors (BCFss and BCFk). The results were compared with fish BCF estimates for the same substances described in the literature to show the relationship between both values. Bioconcentration studies with the freshwater amphipod H. azteca resulted in BCF estimates which show a strong correlation with fish BCF values (r2 = 0.69). Hyalella BCF values can be assessed in accordance with the regulatory B criterion (BCF > 2000, i.e., REACH) and thereby enable the prediction of B or non-B classification in the standard fish test. Therefore, H. azteca has a high potential to be used as alternative test organism to fish for bioconcentration studies.

Acute and chronic aquatic toxicity of ammonium perfluorooctanoate (APFO) to freshwater organisms.

Recent concerns have been raised concerning the widespread distribution of perfluorinated compounds in environmental matrices and biota. The compounds of interest include ammonium perfluorooctanoate (APFO, the ammonium salt of perfluorooctanoic acid, PFOA). APFO is used primarily as a processing aid in the production of fluoropolymers and fluoroelastomers. The environmental presence of perfluorooctanoate (PFO(-), the anion of APFO) and its entry into the environment as APFO make quality aquatic toxicity data necessary to assess the aquatic hazard and risk of APFO. We conducted acute and chronic freshwater aquatic toxicity studies with algae, Pseudokirchneriella subcapitata, the water flea, Daphnia magna, and embryo-larval rainbow trout, Oncorhynchus mykiss, using OECD test guidelines and a single, well-characterized sample of APFO. Acute 48-96 h LC/EC(50) values were greater than 400mg/l APFO and the lowest chronic NOEC was 12.5mg/l for inhibition of the growth rate and biomass of the freshwater alga. Un-ionized ammonia was calculated to be a potential significant contributor to the observed toxicity of APFO. Based on environmental concentrations of PFO(-) from various aquatic ecosystems, the PNEC value from this study, and unionized ammonia contributions to observed toxicity, APFO demonstrates little or no risk for acute or chronic toxicity to freshwater and marine aquatic organisms at relevant environmental concentrations.

Evaluating the ready biodegradability of two poorly water-soluble substances: comparative approach of bioavailability improvement methods (BIMs).

Difficulties encountered in estimating the biodegradation of poorly water-soluble substances are often linked to their limited bioavailability to microorganisms. Many original bioavailability improvement methods (BIMs) have been described, but no global approach was proposed for a standardized comparison of these. The latter would be a valuable tool as part of a wider strategy for evaluating poorly water-soluble substances. The purpose of this study was to define an evaluation strategy following the assessment of different BIMs adapted to poorly water-soluble substances with ready biodegradability tests. The study was performed with two poorly water-soluble chemicals-a solid, anthraquinone, and a liquid, isodecyl neopentanoate-and five BIMs were compared to the direct addition method (reference method), i.e., (i) ultrasonic dispersion, (ii) adsorption onto silica gel, (iii) dispersion using an emulsifier, (iv) dispersion with silicone oil, and (v) dispersion with emulsifier and silicone oil. A two-phase evaluation strategy of solid and liquid chemicals was developed involving the selection of the most relevant BIMs for enhancing the biodegradability of tested substances. A description is given of a BIM classification ratio (R BIM), which enables a comparison to be made between the different test chemical sample preparation methods used in the various tests. Thereby, using this comparison, the BIMs giving rise to the greatest biodegradability were ultrasonic dispersion and dispersion with silicone oil or with silicone oil and emulsifier for the tested solid chemical, adsorption onto silica gel, and ultrasonic dispersion for the liquid one.

High throughput and miniaturised systems for biodegradability assessments.

The society demands safer products with a better ecological profile. Regulatory criteria have been developed to prevent risks for human health and the environment, for example, within the framework of the European regulation REACH (Regulation (EC) No 1907, 2006). This has driven industry to consider the development of high throughput screening methodologies for assessing chemical biodegradability. These new screening methodologies must be scalable for miniaturisation, reproducible and as reliable as existing procedures for enhanced biodegradability assessment. Here, we evaluate two alternative systems that can be scaled for high throughput screening and conveniently miniaturised to limit costs in comparison with traditional testing. These systems are based on two dyes as follows: an invasive fluorescent dyes that serves as a cellular activity marker (a resazurin-like dye reagent) and a noninvasive fluorescent oxygen optosensor dye (an optical sensor). The advantages and limitations of these platforms for biodegradability assessment are presented. Our results confirm the feasibility of these systems for evaluating and screening chemicals for ready biodegradability. The optosensor is a miniaturised version of a component already used in traditional ready biodegradability testing, whereas the resazurin dye offers an interesting new screening mechanism for chemical concentrations greater than 10 mg/l that are not amenable to traditional closed bottle tests. The use of these approaches allows generalisation of high throughput screening methodologies to meet the need of developing new compounds with a favourable ecological profile and also assessment for regulatory purpose.