RESUMEN
We herein propose a multiwalled carbon nanotube (MWCNT) doping method into liquid crystal (LC) alignment polyimides (PIs) with low resistivity for resolving both issues of voltage holding and image sticking in low-frequency-driven fringe-field switching (FFS) LC modes using negative dielectric LCs (n-LCs). By utilizing strong ion trapping ability of MWCNTs, the FFS n-LC cell aligned by low resistivity PIs with 0.05 wt% MWCNT doping exhibited an excellent voltage holding ratio of 99% under an extremely low operation frequency of 0.5 Hz and approximately 23.6 times better surface discharging property than that aligned by high resistivity PIs.
RESUMEN
We proposed and analyzed an optically isotropic nano-droplet liquid crystal (LC) doped with high k nanoparticles (NPs), exhibiting enhanced Kerr effects, which could be operated with reduced driving voltages. For enhancing the contrast ratio together with the light efficiencies, the LC droplet sizes were adjusted to be shorter than the wavelength of visible light to reduce depolarization effects by optical scattering of the LC droplets. Based on the optical analysis of the depolarization effects, the influence of the relationship between the LC droplet size and the NP doping ratio on the Kerr effect change was investigated.
RESUMEN
We analyzed a transient blinking phenomenon in a fringe-field switching liquid crystal (LC) mode that occurred at the moment of frame change even in the optimized DC offset condition for minimum image flicker. Based on the positional dynamic behaviors of LCs by using a high-speed camera, we found that the transient blink is highly related to the asymmetric responses of the splay-bend transitions caused by the flexoelectric (FE) effect. To remove the transient blink, the elastic property adjustment of LCs was an effective solution because the FE switching dynamics between the splay-enhanced and bend-enhanced deformations are highly dependent on the elastic constants of LCs, which is the cause of momentary brightness drop.
RESUMEN
In this paper, we propose a color transparent liquid crystal (LC) mode that can control the properties of the color gamut and transparency in a single panel. To achieve high transmittance in the transparent LC mode, a reactive mesogen (RM) with embedded color dichroic dyes was applied instead of a color filter. Basically, the LC mode applied a 3-terminal electrode structure to switch between the transparent LC mode and the conventional color LC mode. Depending on the direction of the applied voltage, we can operate both the color mode and the transparent mode in a single panel, and modulate the transparency and color purity of the cell through appropriate voltage control. In the experiments, we confirmed that the transmittance and the color gamut of the cell were 39.4% and 2% in the transparent LC mode and 14.9% and 34% in the color LC mode, respectively. Modulation of the color gamut and transparency between each LC mode are also demonstrated in the paper.
RESUMEN
We propose a long-pitch cholesteric liquid crystal (ChLC) device capable of operation in both the dynamic mode and the memory mode. Fast switching between the homeotropic state and the focal conic state allows the display of moving pictures at a low operating voltage. In addition, we can write text messages on the proposed ChLC device by applying an external pressure locally to switch it from the focal conic state to the planar state.
RESUMEN
The outdoor readability of the most popular portable liquid crystal display (LCDs) viz. fringe field switching has been addressed both in single and dual cell gap transflective devices. The devices use dual orientation, such as, homogeneous alignment in transmissive (T) part and 64° twisted alignment in reflective (R) part. The dark states of the proposed devices are achieved by controlling phase retardation in T part and polarization rotation in R part and the white state is realized by rotating optic axis of liquid crystal and removing phase retardation in T and R parts, respectively. The devices show high light efficiency without requiring any optical compensation films, exhibiting strong potential for portable display applications.
Asunto(s)
Presentación de Datos , Cristales Líquidos/química , Refractometría/instrumentación , Campos Electromagnéticos , Diseño de Equipo , Análisis de Falla de Equipo , Cristales Líquidos/efectos de la radiaciónRESUMEN
We propose a switchable achromatic reflector using a long-pitch cholesteric liquid crystal (CLC) whose Bragg reflection wavelength is chosen to be infrared by controlling the pitch of the CLC so that the planar texture is transparent over the entire visible wavelength. By using the light scattering of the focal conic texture, achromatic reflection can be achieved. Both textures are stable at zero electric field and the operating voltage of the proposed CLC device is much lower than that of conventional CLC devices. The proposed switchable reflector, which can be operated at a low voltage with low power, can be applied to reflective displays and to light shutters. By coupling with a reflective polarizer the efficiency of light scattering at the focal conic texture can be enhanced.
Asunto(s)
Simulación por Computador , Luz , Cristales Líquidos/química , Refractometría/instrumentación , Diseño de EquipoRESUMEN
Conventional transflective liquid crystal displays (LCDs) with single cell-gap requires optical compensation films or patterned retarders to balance the optical path-length difference between transmissive and reflective regions. In this paper, novel single cell-gap transflective LCDs driven by fringe electric field without using the compensation film or in-cell retarder have been proposed. The liquid crystal director is aligned parallel to analyzer but makes an angle of 45° with respect to analyzer in reflective region. In addition, the surface pretilt angle in the reflective region is controlled by vertical field and polymerization of an UV curable reactive mesogen at the same time and thus, the effective cell retardation in the reflective region becomes smaller than that in transmissive region. Consequently, without using any compensation film or in-cell retarder, the single cell-gap and single-gamma transflective LCD with high performance is realized.
RESUMEN
All conventional viewing angle switchable liquid crystal displays with pixel division have drawback in light efficiency because the sub-pixel that controls viewing angle does not transmit the incident light at normal direction. In this paper, we propose new viewing angle controllable homogeneously aligned liquid crystal display in which the pixel is composed of red, green, blue, and white pixels. The colored pixels are driven by fringe-field switching and the white pixel is driven by complex field. In wide-viewing angle mode, the liquid crystal (LC) directors in all pixels rotate in plane, contributing to high transmittance. In narrow-viewing angle mode, the LC directors in color pixels rotate in plane for light transmission while the LC directors in white pixel can rotate or tilt upward by simultaneous fringe and vertical electric field. The high tilted LC directors generate light leakage in oblique directions which can be utilized for viewing angle control and also transmission at normal direction for image expression. The proposed device overcomes the long standing problem of transmittance sacrifice in the conventional devices.
RESUMEN
We report on the synthesis and characterization of bent-core liquid crystal (LC) compounds and the preparation of mixtures that provide an optically isotropic antiferroelectric (OI-AFLC) liquid crystal display mode over a very wide temperature interval and well below room temperature. From the collection of compounds synthesized during this study, we recognized that several ternary mixtures displayed a modulated SmCaPA phase down to below -40 °C and up to about 100 °C on both heating and cooling, as well as optical tilt angles in the transformed state of approximately 45° (optically isotropic state). The materials were fully characterized and their liquid crystal as well as electro-optical properties analyzed by polarized optical microscopy, differential scanning calorimetry, synchrotron X-ray diffraction, dielectric spectroscopy, and electro-optical tests.
RESUMEN
We propose an optical configuration of a horizontal-switching liquid-crystal cell, consisting of a splayed liquid-crystal cell and uniaxial films, to improve the viewing angle characteristics by compensating for the phase dispersion in a diagonal direction. The optical design of the proposed configuration was performed on a Poincaré sphere with geometric calculations. By fabricating in-plane switching cells with the introduced configuration, we demonstrated their optical performances. As a result, we found that the diagonal viewing angle of the proposed horizontal-switching cell could be increased by 80% compared to a symmetrical viewing cone.