RESUMEN
Limosilactobacillus (L.) fermentum is widely utilized for its beneficial properties, but lysogenic phages can integrate into its genome and can be induced to enter the lysis cycle under certain conditions, thus accomplishing lysis of host cells, resulting in severe economic losses. In this study, a lysogenic phage, LFP03, was induced from L. fermentum IMAU 32510 by UV irradiation for 70 s. The electron microscopy showed that this phage belonged to Caudoviricetes class. Its genome size was 39,556 bp with a GC content of 46.08%, which includes 20 functional proteins. Compared with other L. fermentum phages, the genome of phage LFP03 exhibited deletions, inversions and translocations. Biological analysis showed that its optimal multiplicity of infection was 0.1, with a burst size of 133.5 ± 4.9 PFU/infective cell. Phage LFP03 was sensitive to temperature and pH value, with a survival rate of 48.98% at 50 °C. It could be completely inactivated under pH 2. The adsorption ability of this phage was minimally affected by temperature and pH value, with adsorption rates reaching 80% under all treated conditions. Divalent cations could accelerate phage adsorption, while chloramphenicol expressed little influence. This study might expand the related knowledge of L. fermentum phages, and provide some theoretical basis for improving the stability of related products and establishing phage control measures.
RESUMEN
In this study, the surface of aluminum powder was uniformly coated with in situ reduced graphene oxide (r-GO) sheets (Al/r-GO). The Ni powder, Al2O3 powder, and Al/r-GO powders were mixed uniformly in a mass ratio of 20:6:4. In situ rGO-reinforced Ni-Al intermetallic composite coatings were successfully prepared using low-pressure cold spraying and subsequent heat treatment. The microstructure and phase of the composite coatings were characterized using X-ray diffraction (XRD), Raman spectroscopy, and scanning electron microscopy (SEM). The high-temperature wear test was conducted at 200 °C, 400 °C, and 600 °C to understand the mechanism. The results indicate that the in situ rGO-reinforced Ni-Al intermetallic composite coatings exhibit a 33.3% lower friction coefficient and 26% lower wear rate in comparison to pure Ni-Al intermetallic coatings, which could be attributed to the generation of an easy-shearing transferred film between the coating and grinding ball.
RESUMEN
Limosilactobacillus fermentum is a bacterium widely used in food production, medicine, and industrial fermentation. However, fermentation could fail due to phage contamination. L. fermentum bacteriophage LFP02 can be induced from L. fermentum IMAU 32579 using mitomycin C. To better understand the characteristics of this phage, its physiological and genomic characteristics were evaluated. The results showed that its optimal multiplicity of infection was 0.01, and the burst size was 148.03 ± 2.65 pfu/infective center. Compared to temperature, pH had a more obvious influence on phage viability, although its adsorption capacity was not affected by the divalent cations (Ca2+ and Mg2+) or chloramphenicol. Its genome size was 43,789 bp and the GC content was 46.06%, including 53 functional proteins. Compared to other L. fermentum phages, phage LFP02 had chromosome deletion, insertion, and inversion, which demonstrated that it was a novel phage. This study could expand the knowledge of the biological characteristics of L. fermentum bacteriophages and provide some theoretical basis for bacteriophage prevention during fermentation.