Décollement geometry controls on shallow very low frequency earthquakes.

Recent studies have documented the occurrence of shallow very low frequency earthquakes (VLFE) in subduction zones. The heterogeneity of the materials or stresses that act on the plate interface results in the variable slip rate. Stress on the décollement can be controlled by the décollement geometry and the regional stress, which is also able to control the material properties. We determined the distribution of stress along the shallow portion of the décollement in the Nankai Trough using a three-dimensional (3D) seismic survey and regional stress analysis to construct maps of normalized slip tendency (Ts') and dilation tendency (Td). Alignments of VLFEs trend parallel to the trends of [Formula: see text] and [Formula: see text]. On the other hand, very low [Formula: see text] and [Formula: see text] areas probably act as barriers that limit the number of VLFEs that can migrate towards the trench. Because the [Formula: see text] and [Formula: see text] distributions are derived only from the décollement geometry and the regional stress without incorporating any data on sediment properties, the consistency between the trends suggests that the décollement geometry is the primary control on VLFE activity.

Localized fluid discharge by tensile cracking during the post-seismic period in subduction zones.

It is thought that extensional structures (extensional cracks and normal faults) generated during the post-seismic period create fluid pathways that enhance the drainage of the subducting plate interface, thus reducing the pore pressure and increasing fault strength. However, it remains to be elucidated how much pore fluid pressure decreases by the extension crack formation. Here we examined (i) the pore fluid pressure decrease, and (ii) the degree fault strength recovery by the extension crack formation during the post-seismic period by analyzing extension quartz veins exposed around the Nobeoka Thrust, southwestern Japan. The Nobeoka Trust is an on-land analog of the modern splay fault at shallow depths (~ 8 km) in the Nankai Trough. The poro-elastic model of extensional quartz vein formation indicates that the formation of extensional cracks only releases up to ~ 7-8% of the total pore fluid pressure at ~ 8 km depth. The pore pressure around the Nobeoka Thrust was close to lithostatic pressure during the entire seismic cycle. The estimated effective frictional coefficient along the Nobeoka Thrust after this small fluid-loss by the extensional crack formation does not exceed 0.15. Hence, the pore fluid pressure reduction due to the post-seismic extensional cracks contributes little to increase the fault strength of the megasplay fault.

An inhomogeneous across-slab conduit controlled by intraslab stress heterogeneity in the Nankai subduction zone.

Nonvolcanic, deep low-frequency tremors and slow-slip events occur simultaneously in the transition zone from locked to continuously creeping fault in the down-dip portion of the Nankai Trough subduction zone, southwestern Japan. The occurrence of these slow earthquakes is discontinuous along the trench and attributed to the effect of high pore pressures at the plate boundary. Here, we show that spatial variations in intraslab stress may control fluid migration from the subducted Philippine Sea slab to the plate boundary. The triaxial normal faulting stress, detected by stress tensor inversion using focal mechanisms in the slab, controls anisotropically permeability that trends NNW-SSE subhorizontally from the subducted Philippine Sea slab to the plate boundary. The inhomogeneous permeability controlled by spatial stress heterogeneities in the subducted Philippine Sea slab controls the intraslab fluid pathway. This hypothesis is consistent with the spatial heterogeneity of slow earthquakes and 3He/4He ratio distributions.