Synthesis of Bioctacene-Incorporated Nanographene with Near-Infrared Chiroptical Properties.

We report the synthesis of a hexabenzoperihexacene (HBPH) with two incorporated octacene substructures, which was unambiguously characterized by single-crystal X-ray analysis. The theoretical isomerization barrier of the (P,P)-/(P,M)-forms was estimated to be 38.4 kcal mol-1 , and resolution was achieved by chiral HPLC. Notably, the enantiomers exhibited opposite circular dichroism responses up to the near-infrared (NIR) region (830 nm) with a high gabs value of 0.017 at 616 nm. Moreover, HBPH demonstrated NIR emission with a maximum at 798 nm and an absolute PLQY of 41 %. The excited-state photophysical properties of HBPH were investigated by ultrafast transient absorption spectroscopy, revealing an intriguing feature that was attributed to the rotational and/or conformational dynamics of HBPH after excitation. These results provide new insight into the design of chiral nanographene with NIR optical properties for potential chiroptical applications.

Cove-Edged Nanographenes with Localized Double Bonds.

The efficient synthesis and electronic properties of two large-size cove-edged nanographenes (NGs), CN1 and CN2, are presented. X-ray crystallographic analysis reveals a contorted backbone for both molecules owing to the steric repulsion at the inner cove position. Noticeably, the dominant structures of these molecules contain four (for CN1) or six (for CN2) localized C=C double bonds embedded in nine (for CN1) or twelve (for CN2) aromatic sextet rings according to Clar's formula, which is supported by bond length analysis and theoretical (NICS, ACID) calculations. Furthermore, Raman spectra exhibit a band associated with the longitudinal CC stretching mode of olefinic double bonds. Owing to the existence of the additional olefinic bonds, both compounds show a small band gap (1.84 eV for CN1 and 1.37 eV for CN2). They also display moderate fluorescence quantum yield (35 % for CN1 and 50 % for CN2) owing to the contorted geometry, which can suppress aggregation in solution.

Synthesis of zigzag- and fjord-edged nanographene with dual amplified spontaneous emission.

We report the synthesis of a dibenzodinaphthocoronene (DBDNC) derivative as a novel nanographene with armchair, zigzag, and fjord edges, which was characterized by NMR and X-ray crystallography as well as infrared (IR) and Raman spectroscopies. Ultrafast transient absorption (TA) spectroscopy revealed the presence of stimulated emission signals at 655 nm and 710 nm with a relatively long lifetime, which resulted in dual amplified spontaneous emission (ASE) bands under ns-pulsed excitation, indicating the promise of DBNDC as a near-infrared (NIR) fluorophore for photonics. Our results provide new insight into the design of nanographene with intriguing optical properties by incorporating fjord edges.

Excited states engineering enables efficient near-infrared lasing in nanographenes.

The spectral overlap between stimulated emission (SE) and absorption from dark states (i.e. charges and triplets) especially in the near-infrared (NIR), represents one of the most effective gain loss channels in organic semiconductors. Recently, bottom-up synthesis of atomically precise graphene nanostructures, or nanographenes (NGs), has opened a new route for the development of environmentally and chemically stable materials with optical gain properties. However, also in this case, the interplay between gain and absorption losses has hindered the attainment of efficient lasing action in the NIR. Here, we demonstrate that the introduction of two fluoranthene imide groups to the NG core leads to a more red-shifted emission than the precursor NG molecule (685 vs. 615 nm) and also with a larger Stokes shift (45 nm vs. 2 nm, 1026 cm-1vs. 53 cm-1, respectively). Photophysical results indicate that, besides the minimisation of ground state absorption losses, such substitution permits to suppress the detrimental excited state absorption in the NIR, which likely arises from a dark state with charge-transfer character and triplets. This has enabled NIR lasing (720 nm) from all-solution processed distributed feedback devices with one order of magnitude lower thresholds than those of previously reported NIR-emitting NGs. This study represents an advance in the field of NGs and, in general, organic semiconductor photonics, towards the development of cheap and stable NIR lasers.

N,N'-Bis(3-methylphenyl)-N,N'-dyphenylbenzidine Based Distributed Feedback Lasers with Holographically Fabricated Polymeric Resonators.

The molecule N,N'-bis(3-methylphenyl)-N,N'-dyphenylbenzidine (TPD) has been widely used in optoelectronic applications, mainly for its hole-transporting properties, but also for its capability to emit blue light and amplified spontaneous emission, which is important for the development of organic lasers. Here, we report deep-blue-emitting distributed feedback (DFB) lasers based on TPD dispersed in polystyrene (PS), as active media, and dichromated gelatin layers with holographically engraved relief gratings, as laser resonators. The effect of the device architecture (with the resonator located below or on top of the active layer) is investigated with a dye (TPD) that can be doped into PS at higher rates (up to 60 wt%), than with previously used dyes (<5 wt%). This has enabled changing the index contrast between film and resonator, which has an important effect on the laser performance. With regards to thresholds, both architectures behave similarly for TPD concentrations above 20 wt%, while for lower concentrations, top-layer resonator devices show lower values (around half). Remarkably, the operational durability of top-layer resonator devices is larger (in a factor of around 2), independently of the TPD concentration. This is a consequence of the protection offered by the resonator against dye photo-oxidation when the device is illuminated with pulsed UV light.

Simultaneous Determination of Refractive Index and Thickness of Submicron Optical Polymer Films from Transmission Spectra.

High-transparency polymers, called optical polymers (OPs), are used in many thin-film devices, for which the knowledge of film thickness (h) and refractive index (n) is generally required. Spectrophotometry is a cost-effective, simple and fast non-destructive method often used to determine these parameters simultaneously, but its application is limited to films where h > 500 nm. Here, a simple spectrophotometric method is reported to obtain simultaneously the n and h of a sub-micron OP film (down to values of a few tenths of a nm) from its transmission spectrum. The method is valid for any OP where the n dispersion curve follows a two-coefficient Cauchy function and complies with a certain equation involving n at two different wavelengths. Remarkably, such an equation is determined through the analysis of n data for a wide set of commercial OPs, and its general validity is demonstrated. Films of various OPs (pristine or doped with fluorescent compounds), typically used in applications such as thin-film organic lasers, are prepared, and n and h are simultaneously determined with the proposed procedure. The success of the method is confirmed with variable-angle spectroscopic ellipsometry.

Dual Amplified Spontaneous Emission and Lasing from Nanographene Films.

Chemically synthesized zigzag-edged nanographenes (NG) have recently demonstrated great success as the active laser units in solution-processed organic distributed feedback (DFB) lasers. Here, we report the first observation of dual amplified spontaneous emission (ASE) from a large-size NG derivative (with 12 benzenoid rings) dispersed in a polystyrene film. ASE is observed simultaneously at the 685 and 739 nm wavelengths, which correspond to different transitions of the photoluminescence spectrum. Ultrafast pump-probe spectroscopy has been used to ascertain the underlying photophysical processes taking place in the films. DFB lasers, based on these materials and top-layer nanostructured polymeric resonators (i.e., one or two-dimensional surface relief gratings), have been fabricated and characterized. Lasers emitting close to either one of the two possible ASE wavelengths, or simultaneously at both of them, have been prepared by proper selection of the resonator parameters.

Solution-processed nanographene distributed feedback lasers.

The chemical synthesis of nanographene molecules constitutes the bottom-up approach toward graphene, simultaneously providing rational chemical design, structure-property control and exploitation of their semiconducting and luminescence properties. Here, we report nanographene-based lasers from three zigzag-edged polycyclic aromatics. The devices consist of a passive polymer film hosting the nanographenes and a top-layer polymeric distributed feedback resonator. Both the active material and the laser resonator are processed from solution, key for the purpose of obtaining low-cost devices with mechanical flexibility. The prepared lasers show narrow linewidth ( < 0.13 nm) emission at different spectral regions covering a large segment of the visible spectrum, and up to the vicinity of the near-infrared. They show outstandingly long operational lifetimes (above 105 pump pulses) and very low thresholds. These results represent a significant step forward in the field of graphene and broaden its versatility in low-cost devices implying light emission, such as lasers.