Benzyl Alcohol-Treated CH3NH3PbBr3 Nanocrystals Exhibiting High Luminescence, Stability, and Ultralow Amplified Spontaneous Emission Thresholds.

We report the high yield synthesis of about 11 nm sized CH3NH3PbBr3 nanocrystals with near-unity photoluminescence quantum yield. The nanocrystals are formed in the presence of surface-binding ligands through their direct precipitation in a benzyl alcohol/toluene phase. The benzyl alcohol plays a pivotal role in steering the surface ligands binding motifs on the NC surface, resulting in enhanced surface-trap passivation and near-unity PLQY values. We further demonstrate that thin films from purified CH3NH3PbBr3 nanocrystals are stable >4 months in air, exhibit high optical gain (about 520 cm-1), and display stable, ultralow amplified spontaneous emission thresholds of 13.9 ± 1.3 and 569.7 ± 6 µJ cm-2 at one-photon (400 nm) and two-photon (800 nm) absorption, respectively. To the best of our knowledge, the latter signifies a 5-fold reduction of the lowest reported threshold value for halide perovskite nanocrystals to date, which makes them ideal candidates for light-emitting and low-threshold lasing applications.

Photoluminescence Quenching in Self-Assembled CsPbBr3 Quantum Dots on Few-Layer Black Phosphorus Sheets.

An ordered self-assembly of CsPbBr3 quantum dots (QDs) was generated on the surface of few-layer black phosphorus (FLBP). Strong quenching of the QD fluorescence was observed, and analyzed by time-resolved photoluminescence (TR-PL) studies, DFT calculations, and photoconductivity measurements. Charge transfer by type I band alignment is suggested to be the cause of the observed effects.

Understanding the Origins of Nucleophilic Hydride Reactivity of a Sodium Hydride-Iodide Composite.

Sodium hydride (NaH) has been commonly used as a Brønsted base in chemical syntheses, while it has rarely been employed to add hydride (H(-) ) to unsaturated electrophiles. We previously developed a procedure to activate NaH through the addition of a soluble iodide source and found that the new NaH-NaI composite can effect even stereoselective nucleophilic hydride reductions of nitriles, imines, and carbonyl compounds. In this work, we report that mixing NaH with NaI or LiI in tetrahydrofuran (THF) as a solvent provides a new inorganic composite, which consists of NaI interspersed with activated NaH, as revealed by powder X-ray diffraction, and both solid-state NMR and X-ray photoelectron spectroscopies. DFT calculations imply that this remarkably simple inorganic composite, which is comprised of NaH and NaI, gains nucleophilic hydridic character similar to covalent hydrides, resulting in unprecedented and unique hydride donor chemical reactivity.

Seed Power: Natural Seed and Electrospun Poly(vinyl difluoride) (PVDF) Nanofiber Based Triboelectric Nanogenerators with High Output Power Density.

A triboelectric nanogenerator (TENG) based on natural seeds and electrospun poly(vinyl difluoride) (PVDF) fibers is reported. The nanofibers are specifically used to enhance the triboelectric effects. A mustard (flax) seed based TENG renders an impressively high electrical output with an average open circuit voltage of 84 V (126 V) and maximum power density 334 mW m-2 (324 mW m-2) under an impact force of 40 N at 25 Hz. Basil seeds are relatively weaker in power delivery. By comparing the seed crust properties and TENG performances, we analyze the powering capability in terms of the cellulose content in the crust, dielectric constant, and surface morphological features.

Inducing Isotropic Growth in Multidimensional Cesium Lead Halide Perovskite Nanocrystals.

A new two-step synthetic protocol to yield monodisperse spherical zero-dimensional (0D) Cs4 PbX6 nanocrystals (NCs) and three-dimensional (3D) CsPbX3 NCs is described. The first step of the reaction involves the colloidal synthesis of spherical PbX2 seed NCs, which are subsequently converted to Cs4 PbX6 and CsPbX3 NCs through hot injection of a Cs precursor at the desired reaction temperatures. By employing less reactive Pb and halide precursors, the reaction time was extended from several seconds to about five minutes, thereby allowing greater control during the crystallization and growth stages. The adjustment of halide ratios allows color tuning over a wide spectral range (411-669 nm) for CsPbX3 NCs, with high photoluminescence quantum yields (6-65 %) and narrow emission line widths (ca. 13-30 nm). We envisage our spherical NCs to become a starting point for shell growth (e.g., ZnS, CdS, PbS) by overcoming the difficulty of shell growth around thermodynamically unfavorable (i.e., high surface free energy) cuboid-shaped NCs.

Enhanced Exciton and Photon Confinement in Ruddlesden-Popper Perovskite Microplatelets for Highly Stable Low-Threshold Polarized Lasing.

At the heart of electrically driven semiconductors lasers lies their gain medium that typically comprises epitaxially grown double heterostuctures or multiple quantum wells. The simultaneous spatial confinement of charge carriers and photons afforded by the smaller bandgaps and higher refractive index of the active layers as compared to the cladding layers in these structures is essential for the optical-gain enhancement favorable for device operation. Emulating these inorganic gain media, superb properties of highly stable low-threshold (as low as ≈8 µJ cm-2 ) linearly polarized lasing from solution-processed Ruddlesden-Popper (RP) perovskite microplatelets are realized. Detailed investigations using microarea transient spectroscopies together with finite-difference time-domain simulations validate that the mixed lower-dimensional RP perovskites (functioning as cladding layers) within the microplatelets provide both enhanced exciton and photon confinement for the higher-dimensional RP perovskites (functioning as the active gain media). Furthermore, structure-lasing-threshold relationship (i.e., correlating the content of lower-dimensional RP perovskites in a single microplatelet) vital for design and performance optimization is established. Dual-wavelength lasing from these quasi-2D RP perovskite microplatelets can also be achieved. These unique properties distinguish RP perovskite microplatelets as a new family of self-assembled multilayer planar waveguide gain media favorable for developing efficient lasers.

Modulating Excitonic Recombination Effects through One-Step Synthesis of Perovskite Nanoparticles for Light-Emitting Diodes.

The primary advantages of halide perovskites for light-emitting diodes (LEDs) are solution processability, direct band gap, good charge-carrier diffusion lengths, low trap density, and reasonable carrier mobility. The luminescence in 3 D halide perovskite thin films originates from free electron-hole bimolecular recombination. However, the slow bimolecular recombination rate is a fundamental performance limitation. Perovskite nanoparticles could result in improved performance but processability and cumbersome synthetic procedures remain challenges. Herein, these constraints are overcome by tailoring the 3 D perovskite as a near monodisperse nanoparticle film prepared through a one-step in situ deposition method. Replacing methyl ammonium bromide (CH3 NH3 Br, MABr) partially by octyl ammonium bromide [CH3 (CH2 )7 NH3 Br, OABr] in defined mole ratios in the perovskite precursor proved crucial for the nanoparticle formation. Films consisting of the in situ formed nanoparticles displayed signatures associated with excitonic recombination, rather than that of bimolecular recombination associated with 3 D perovskites. This transition was accompanied by enhanced photoluminescence quantum yield (PLQY≈20.5 % vs. 3.40 %). Perovskite LEDs fabricated from the nanoparticle films exhibit a one order of magnitude improvement in current efficiency and doubling in luminance efficiency. The material processing systematics derived from this study provides the means to control perovskite morphologies through the selection and mixing of appropriate additives.

Corrigendum: Slow cooling and highly efficient extraction of hot carriers in colloidal perovskite nanocrystals.

This corrects the article DOI: 10.1038/ncomms14350.

Slow cooling and highly efficient extraction of hot carriers in colloidal perovskite nanocrystals.

Hot-carrier solar cells can overcome the Schottky-Queisser limit by harvesting excess energy from hot carriers. Inorganic semiconductor nanocrystals are considered prime candidates. However, hot-carrier harvesting is compromised by competitive relaxation pathways (for example, intraband Auger process and defects) that overwhelm their phonon bottlenecks. Here we show colloidal halide perovskite nanocrystals transcend these limitations and exhibit around two orders slower hot-carrier cooling times and around four times larger hot-carrier temperatures than their bulk-film counterparts. Under low pump excitation, hot-carrier cooling mediated by a phonon bottleneck is surprisingly slower in smaller nanocrystals (contrasting with conventional nanocrystals). At high pump fluence, Auger heating dominates hot-carrier cooling, which is slower in larger nanocrystals (hitherto unobserved in conventional nanocrystals). Importantly, we demonstrate efficient room temperature hot-electrons extraction (up to ∼83%) by an energy-selective electron acceptor layer within 1 ps from surface-treated perovskite NCs thin films. These insights enable fresh approaches for extremely thin absorber and concentrator-type hot-carrier solar cells.

Enhancing electrocatalytic hydrogen evolution by nickel salicylaldimine complexes with alkali metal cations in aqueous media.

New salicylaldimine nickel complexes, comprising only earth-abundant elements, have been developed for electrocatalytic hydrogen evolution in aqueous media. The second-sphere ether functionalities on the periphery of the complexes enhance the electrocatalytic activity in the presence of alkali metal cations. The electrocatalysts demonstrate improved performances especially in the economical and sustainable seawater reaction medium.

Highly stable, luminescent core-shell type methylammonium-octylammonium lead bromide layered perovskite nanoparticles.

A new protocol for the synthesis of a highly stable (over 2 months under ambient conditions) solution-processed core-shell type structure of mixed methylammonium-octylammonium lead bromide perovskite nanoparticles (5-12 nm), having spherical shape, color tunability in the blue to green spectral region (438-521 nm) and a high photoluminescence quantum yield (PLQY) of up to 92% is described. The color tunability, high PLQY and stability are due to the quantum confinement imparted by the crystal engineering associated with core-shell nanoparticle formation during growth.

Mesoporous cerium oxide nanospheres for the visible-light driven photocatalytic degradation of dyes.

A facile, solvothermal synthesis of mesoporous cerium oxide nanospheres is reported for the purpose of the photocatalytic degradation of organic dyes and future applications in sustainable energy research. The earth-abundant, relatively affordable, mixed valence cerium oxide sample, which consists of predominantly Ce7O12, has been characterized by powder X-ray diffraction, X-ray photoelectron and UV-vis spectroscopy, and transmission electron microscopy. Together with N2 sorption experiments, the data confirms that the new cerium oxide material is mesoporous and absorbs visible light. The photocatalytic degradation of rhodamin B is investigated with a series of radical scavengers, suggesting that the mechanism of photocatalytic activity under visible-light irradiation involves predominantly hydroxyl radicals as the active species.

Enhanced conversion efficiency in dye-sensitized solar cells based on hydrothermally synthesized TiO2-MWCNT nanocomposites.

A 50% enhancement in the conversion efficiency (4.9-7.37%) is realized in dye-sensitized solar cells using hydrothermally synthesized TiO(2)-multiwalled carbon nanotube (MWCNT) nanocomposites as compared to hydrothermally synthesized TiO(2) without MWCNT and Degussa P25. Several characterizations have been employed to reveal the nature of the modification imparted to the MWCNTs under hydrothermal processing conditions and the resulting TiO(2)-MWCNT conjugation through -COOH groups. Efficient charge transfer in the nanocomposite and efficient electron transport by MWCNT (significantly higher incident-photon-to-current conversion efficiency) are suggested to be the possible reasons for the enhancement.