Analytical Platform To Characterize Dopant Solution Concentrations, Charge Carrier Densities in Films and Interfaces, and Physical Diffusion in Polymers Utilizing Remote Field-Effect Transistors.

Characterizing doping effects in a conductive polymer and physical diffusion in a passive polymer were performed using a remote-gate field-effect transistor (RG FET) detection system that was able to measure the electrical potential perturbation of a polymer film coupled to the gate of a silicon FET. Poly(3-hexylthiophene) (P3HT) film doped using various concentrations of 2,3,5,6-tetrafluoro-7,7,8,8-tetracyanoquinodimethane (F4TCNQ) solutions imposed additional positive potentials on the P3HT RG, resulting in a lower threshold voltage ( Vth) on the n-channel silicon FET. Changes in Vth were related to the induced hole concentrations and hole mobility in P3HT films by using our Vth shifting model for the RG FET. We discovered that the electron-donating P3HT and even inorganic materials, indium tin oxide and gold, showed similar electrical potential perturbations dependent on the concentration of F4TCNQ in overlying solutions as the dopant radical anions maximally covered the surfaces. This suggests that there are limited electroactive sites for F4TCNQ binding on electron donor surfaces which results in a similar number of positive charges in film materials forming dipoles with the F4TCNQ radical counteranions. The effect of electron acceptors such as 7,7,8,8-tetracyanoquinodimethane and tetracyanoethylene was compared to that of F4TCNQ in terms of Vth shift using our analytical tool, with differences attributed to acceptor size and reduction potential. Meanwhile, this FET analysis tool offered a means of monitoring the physical diffusion of small molecules, exemplified by F4TCNQ, in the passive polymer polystyrene, driven by concentration gradients. The technique allows for nondestructive, nonspectroscopic, ambient characterization of electron donor-acceptor interactions at surfaces.

Sensitive organic electrochemical transistor biosensors: Comparing single and dual gate functionalization and different COOH-functionalized bioreceptor layers.

We developed new measurement configurations based on organic electrochemical transistors (OECTs). Three types of COOH-functionalized bioreceptor layers were deposited on indium tin oxide (ITO) electrodes on poly(ethylene terephthalate) (PET) substrates and their performance was tested using single gate functionalization organic electrochemical transistor (S-OECT) and dual gate functionalization organic electrochemical transistor (D-OECT) configurations. The three layers included one p-type semiconductor, one insulator, and one self-assembled layer, and the dual gates were connected in series through buffer solutions, so the solution-electrode interfaces had the opposite polarities. We investigated the sensitivities of these systems using the human IgG antigen-human IgG antibody receptor pair for main experiments, and drifts of antibody-functionalized gates without analytes as control experiments. Drifts without analyte can obscure the real sensitivity. We show that the D-OECT has the capability to cancel the drifts, and is also beneficial for showing the sensitivity more exactly. This configuration has the ability to increase the accuracy of antibody-antigen interaction detection, and further decrease or eliminate the effect of ions in the buffer solution. We also prove that the D-OECT can work well with different bioreceptor materials, which indicates that the system can be further applied to different conditions.

Maximized Hole Trapping in a Polystyrene Transistor Dielectric from a Highly Branched Iminobis(aminoarene) Side Chain.

We synthesized highly branched and electron-donating side chain subunits and attached them to polystyrene (PS) used as a dielectric layer in a pentacene field-effect transistor. The influence of these groups on dielectric function, charge retention, and threshold voltage shifts (ΔVth) depending on their positions in dielectric multilayers was determined. We compared the observations made on an N-perphenylated iminobisaniline side chain with those from the same side chains modified with ZnO nanoparticles and with an adduct formed from tetracyanoethylene (TCNE). We also synthesized an analogue in which six methoxy groups are present instead of two amine nitrogens. At 6 mol % side chain, hopping transport was sufficient to cause shorting of the gate, while at 2 mol %, charge trapping was observable as transistor threshold voltage shifts (ΔVth). We created three types of devices: with the substituted PS layer as single-layer dielectric, on top of a cross-linked PS layer but in contact with the pentacene (bilayers), and sandwiched between two PS layers in trilayers. Especially large bias stress effects and ΔVth, larger than those in the case of the hexamethoxy and previously studied dimethoxy analogues, were observed in the second case, and the effects increased with the increasing electron-donating properties of the modified side chains. The highest ΔVth was consistent with a majority of the side chains stabilizing the trapped charge. Trilayer devices showed decreased charge storage capability compared to previous work in which we used less donating side chains but in higher concentrations. The ZnO and TCNE modifications resulted in slightly more and less negative ΔVth, respectively, when the side chain polystyrene was not in contact with the pentacene and isolated from the gate electrode. The results indicate a likely maximum combination of molecular charge stabilizing activity and side chain concentration that still allows gate dielectric function.

Design and Synthesis of Air-Stable p-Channel-Conjugated Polymers for High Signal-to-Drift Nitrogen Dioxide and Ammonia Sensing.

The development of high-performance-conjugated polymer-based gas sensors involves detailed structural tailoring such that high sensitivities are achieved without compromising the stability of the fabricated devices. In this work, we systematically developed a series of diketopyrrolopyrrole (DPP)-based polymer semiconductors by modifying the polymer backbone to achieve and rationalize enhancements in gas sensitivities and electronic stability in air. NO2- and NH3-responsive polymer-based organic field-effect transistors (OFETs) are described with improved air stability compared to all-thiophene conjugated polymers. Five DPP-fluorene-based polymers were synthesized and compared to two control polymers and used as active layers to detect a concentration of NO2 at least as low as 0.5 ppm. The hypothesis that the less electron-donating fluorene main-chain subunit would lead to increased signal/drift compared to thiophene and carbazole subunits was tested. The sensitivities exhibited a bias voltage-dependent behavior. The proportional on-current change of OFETs using a dithienyl DPP-fluorene polymer reached ∼614% for an exposure to 20 ppm of NO2 for 5 min, testing at a bias voltage of -33 V, among the higher reported NO2 sensitivities for conjugated polymers. Electronic and morphological studies reveal that introduction of the fluorene unit in the DPP backbone decreases the ease of backbone oxidation and induces traps in the thin films. The combination of thin-film morphology and oxidation potentials governs the gas-absorbing properties of these materials. The ratio of responses on exposure to NO2 and NH3 compared to drifts while taking the device through repeated gate voltage sweeps is the highest for two polymers incorporating electron-donating linkers connecting the DPP and thiophene units in the backbone, in this category of organic semiconductors. The responses to NO2 were much larger than that to NH3, indicating increased susceptibility to oxidizing vs reducing gases, and that the capability of oxidizing gases to induce additional charge density has a more dramatic electronic effect than when reducing gases create traps. This work demonstrates the capability of achieving improved stability with the retention of high sensitivity in conjugated polymer-based OFET sensors by modulating redox and morphological properties of polymer semiconductors by structural control.