RESUMEN
OBJECTIVES: Flucloxacillin has the most narrow spectrum to treat staphylococcal infections, but has a large variability in bioavailability which hampers its intravenous (iv) to oral switch. To identify patients with adequate absorption, the use of an oral absorption test (OAT) measuring total plasma concentrations of flucloxacillin before and after an oral dose of 1 gram flucloxacillin, was previously published. The current pilot study aims to evaluate the fraction of patients with adequate absorption using a similar OAT; to assess the therapeutic consequences and to identify potential factors associated with adequate absorption. METHODS: Demographic data of adult patients treated with iv flucloxacillin and requiring prolonged therapy were collected retrospectively between May 2020 and November 2021 at Ghent University Hospital. A previously published OAT protocol was used, with addition of a protocol for intermittent dosing of iv flucloxacillin. Adequate absorption was defined as an increase in plasma concentration of at least 10 mg/L. RESULTS: The flucloxacillin OAT was performed in 99 patients, of which 62% were men, with a median age of 58 years and 95% received intermittent dosing of iv flucloxacillin. Of the 99 patients, 55% had a result indicating an adequate absorption and 49% of all patients were switched to oral flucloxacillin afterwards. Inadequate absorption was found to be associated with higher Body Mass Index and higher flucloxacillin baseline concentration, while co-administration of acetylsalicylic acid was associated with an adequate absorption. CONCLUSIONS: Based on the OAT, 49% of all patients were switched to oral flucloxacillin instead of broader-spectrum anti-staphylococcal antibiotics. This implicates that an OAT could be a valuable antimicrobial stewardship measure by restricting the use of broad-spectrum antibiotics. For each of the associations found, a hypothesis was formulated about the underlying reason or mechanism; these should be confirmed in future studies with prospective and multicentric design.