RESUMEN
PURPOSE: Total joint arthroplasty (TJA) has often been used to treat thumb carpometacarpal (CMC) osteoarthritis (OA). However, guidelines for the CMC prosthesis shape remain unclear. This study aimed to identify the effective shape of a ball-and-socket prosthesis in restoring the range of thumb motion after TJA. METHODS: The participants were 10 healthy young adult men (22-32 years; 26.8 ± 3.57 [mean ± SD]). CT scans were performed in eight static limb positions during abduction and flexion. We defined three design variables (offset R, height H, and neck rotation angle Φ) as the variables that determine the basic shape of the ball-and-socket prosthesis. The ideal values of these design variables were examined based on the results of a 3D motion analysis, which evaluated the change in the posture of the first metacarpal (r, h, and φ corresponding to R, H, and Φ, respectively) relative to the center of rotation (COR) during abduction and flexion. We also simulated the effect of these design variables on the range of thumb motion after TJA using 3D CAD. RESULTS: We found that the values of r and h averaged over all limb positions were 6.92 ± 1.60 mm and 51.02 ± 1.67 mm, respectively, showing that these values remained constant regardless of limb position. In contrast, φ changed significantly. The simulation results indicated that Φ affected the range of thumb motion after TJA, and Φ = 0° relatively reproduced all limb positions compared to other values. CONCLUSION: Our results suggested that the desirable values of R and H were the average of r and h over several limb positions and that Φ = 0° was effective in restoring the range of thumb motion after TJA. Our results will provide surgeons with new guidelines for selecting a prosthesis.