Formation of oriented nanostructures in diamond using metallic nanoparticles.

A simple, fast and cost-effective etching technique to create oriented nanostructures such as pyramidal and cylindrical shaped nanopores in diamond membranes by self-assembled metallic nanoparticles is proposed. In this process, a diamond film is annealed with thin metallic layers in a hydrogen atmosphere. Carbon from the diamond surface is dissolved into nanoparticles generated from the metal film, then evacuated in the form of hydrocarbons and, consequently, the nanoparticles enter the crystal volume. In order to understand and optimize the etching process, the role of different parameters such as type of catalyst (Ni, Co, Pt, and Au), hydrogen gas, temperature and time of annealing, and microstructure of diamond (polycrystalline and nanocrystalline) were investigated. With this technique, nanopores with lateral sizes in the range of 10-100 nm, and as deep as about 600 nm, in diamond membranes were produced without any need for a lithography process, which opens the opportunities for fabricating porous diamond membranes for chemical sensing applications.

Hydrogen-induced passivation of boron acceptors in monocrystalline and polycrystalline diamond.

This paper presents a review of the properties induced by the presence of hydrogen in monocrystalline boron-doped diamond (BDD) and proposes a comparison with results obtained on polycrystalline materials. Hydrogen diffusion, luminescence and electrical properties show the passivation of boron acceptors in diamond by the formation of (B,H) complexes, in both monocrystalline and polycrystalline forms, but at a different level. This behaviour raises open questions concerning the role of structural defects in the passivation of boron impurities by hydrogenation. Based on the assessment of the high thermal stability of (B,H) complexes, this approach leads to a route to provide patterned diamond conductive structures for micro as well as for nanotechnology applications.

Highly sensitive thermal conductivity measurements of suspended membranes (SiN and diamond) using a 3ω-Völklein method.

A suspended system for measuring the thermal properties of membranes is presented. The sensitive thermal measurement is based on the 3ω dynamic method coupled to a Völklein geometry. The device obtained using micro-machining processes allows the measurement of the in-plane thermal conductivity of a membrane with a sensitivity of less than 10 nW/K (+∕-5 × 10(-3) Wm(-1) K(-1) at room temperature) and a very high resolution (ΔK/K = 10(-3)). A transducer (heater/thermometer) centered on the membrane is used to create an oscillation of the heat flux and to measure the temperature oscillation at the third harmonic using a Wheatstone bridge set-up. Power as low as 0.1 nW has been measured at room temperature. The method has been applied to measure thermal properties of low stress silicon nitride and polycrystalline diamond membranes with thickness ranging from 100 nm to 400 nm. The thermal conductivity measured on the polycrystalline diamond membrane support a significant grain size effect on the thermal transport.

GaN-Based Solar-Ultraviolet Detection Instrument.

We report on the fabrication of a solar-UV monitoring system that uses GaN-based photodetectors. GaN photoconductors, p-n junction photodiodes, and Schottky barrier photodiodes have been fabricated and characterized as UV sensors. The best performances are obtained in Schottky photodiodes, which show a linear response, a flat responsivity of 100 mA/W, a visible rejection ratio higher than 10(3), and a noise-equivalent power of 1 nW/Hz(-1/2). Preliminary data on Al(x)Ga(1-x)N (x = 0.15, 0.22) detectors are also presented. Using GaN Schottky diodes, we fabricate and evaluate a complete solar-UV detection head.