Reuse of polymeric waste for the treatment of marine water polluted by diesel.

Accidental diesel spills can occur in marine environments such as harbors, leading to adverse effects on the environmental compartment and humans. This study proposes the surgical mask as an affordable and sustainable adsorbent for the remediation of diesel-contaminated seawater to cope with the polymeric waste generated monthly in hospital facilities. This approach can also be helpful considering a possible future pandemic, alleviating the pressure on the waste management system by avoiding improper mask incineration and landfilling, as instead occurred during the previous COVID-19. Batch adsorption-desorption experiments revealed a complete diesel removal from seawater after 120 min with the intact laceless mask, which showed an adsorption capacity of up to 3.43 g/g. The adsorption curve was better predicted via Weber and Morris's kinetic (R2 = 0.876) and, in general, with Temkin isotherm (R2 = 0.965-0.996) probably due to the occurrence of chemisorption with intraparticle diffusion as one of the rates-determining steps. A hysteresis index of 0.23-0.36 was obtained from the desorption isotherms, suggesting that diesel adsorption onto surgical masks was faster than the desorption mechanism. Also, the effect of pH, ionic strength and temperature on diesel adsorption was examined. The results from the reusability tests indicated that the surgical mask can be regenerated for 5 consecutive cycles while decreasing the adsorption capacity by only approximately 11%.

Genetic effects in Helix aspersa near a coal plant revealed by the micronucleus test.

Coal plants can be a major source of mutagenic pollutants. In this study we used the common land snail Helix aspersa, to detect the mutagenic effect of pollution from a coal plant in central Italy applying the micronucleus test (MN) on snail's haemocytes and evaluating trace elements concentration (As Cd, Pb, Hg, and Zn) in soil and snails. Snails from a biological farm were exposed for 13 days in five locations at different distances from the plant. Wild snails collected in the same locations were also analysed. MN frequency in exposed snails was significantly higher in four locations within 10 km from to the plant, with respect to the control and the farthest location. Comparing the MN frequency between farmed and wild snails, a significantly higher frequency emerged for the exposed snails in all locations except the farthest, likely indicating adaptation or selection of the wild organisms due to chronic exposure to pollutants. In natural snails significantly higher MN frequencies with near the plant emerged as well. Trace elements analysis showed significant correlations between MN frequencies and both Zn and As concentrations in soil, for both exposed and wild snails, and Zn and Pb concentrations in exposed snails. Our results were consistent with those previously obtained when evaluating primary DNA damage in natural snails from the same area and show that the snails near the plant were affected by a permanent cytogenetic damage. Moreover, they confirm the suitability of snails for biomonitoring the presence of pollutants with mutagenic effect.

Cobalt-chromium alloys in dentistry: An evaluation of metal ion release.

STATEMENT OF PROBLEM: Metal ions released into the oral cavity from dental prosthesis alloys may damage the cellular metabolism or proliferation and cause hypersensitivity or allergies. The oral cavity environment is particularly prone to corrosion due to saliva, microorganisms, and pH variations. PURPOSE: The purpose of this in vitro study was to evaluate the ion release of chromium, cobalt, and iron from the Co-Cr alloys used for traditionally cast and computer-aided design/computer-aided manufacturing dental devices after interaction with oral bacteria and different pH conditions. MATERIAL AND METHODS: All specimens were prepared from currently available alloys, polished, and immersed in 3 different pH media (artificial saliva [pH 2.3] and 6.5% and 0.9% saline solution [pH 7.1]). Specimens were also incubated in the presence of the bacterium Eikenella corrodens. Solutions were analyzed with an atomic absorption spectrometer after 15 and 30 days in the chemical corrosion test and 30 days in the biocorrosion test to detect ions released in different solutions. An ANOVA test was used to evaluate statistically significant differences among the percentages of metal corrosion ion release values. RESULTS: The greatest amount of element release was seen after 30 days: 4.964 ppm of casting alloy, 2.642 ppm of milling alloy, and 2.351 ppm of laser metal sintering. CONCLUSIONS: With the exception of casting alloy under acidic conditions, no significant differences were found, even after exposure to bacteria.

Phytoremediation of a pyrene-contaminated soil by Cannabis sativa L. at different initial pyrene concentrations.

This study proposes the phytoremediation of a pyrene (PYR)-contaminated soil by Cannabis sativa L. The experimental campaign was conducted along a 60 days period using three different initial PYR concentrations (i.e., 50, 100 and 150 mg kg TS-1 of soil) in 300 mL volume pots under greenhouse conditions (18-25 °C and 45-55% humidity). After 60 days of hemp growth and flourishing, the highest PYR removal reached approximately 95% in planted soil, 35% higher than in the unplanted control. PYR accumulation was observed in both roots and aerial parts of the plant, with a higher PYR uptake at increasing initial PYR concentrations in soil. The initial PYR concentration affected the growth and, thus, the phytoremediation potential of C. sativa L., which was the result of different removal mechanisms. Overall, the lowest initial PYR concentration was the one that resulted in the highest PYR removal. The interaction between the plant roots and microorganisms in rhizosphere was likely associated with PYR removal in this study. The highest DHO activity of 66.26 µg INTF g-1 TS-1 was observed in the soil spiked with 50 mg PYR·kg TS-1.

Development of a rapid soil water content detection technique using active infrared thermal methods for in-field applications.

The aim of this study was to investigate the suitability of active infrared thermography and thermometry in combination with multivariate statistical partial least squares analysis as rapid soil water content detection techniques both in the laboratory and the field. Such techniques allow fast soil water content measurements helpful in both agricultural and environmental fields. These techniques, based on the theory of heat dissipation, were tested by directly measuring temperature dynamic variation of samples after heating. For the assessment of temperature dynamic variations data were collected during three intervals (3, 6 and 10 s). To account for the presence of specific heats differences between water and soil, the analyses were regulated using slopes to linearly describe their trends. For all analyses, the best model was achieved for a 10 s slope. Three different approaches were considered, two in the laboratory and one in the field. The first laboratory-based one was centred on active infrared thermography, considered measurement of temperature variation as independent variable and reported r = 0.74. The second laboratory-based one was focused on active infrared thermometry, added irradiation as independent variable and reported r = 0.76. The in-field experiment was performed by active infrared thermometry, heating bare soil by solar irradiance after exposure due to primary tillage. Some meteorological parameters were inserted as independent variables in the prediction model, which presented r = 0.61. In order to obtain more general and wide estimations in-field a Partial Least Squares Discriminant Analysis on three classes of percentage of soil water content was performed obtaining a high correct classification in the test (88.89%). The prediction error values were lower in the field with respect to laboratory analyses. Both techniques could be used in conjunction with a Geographic Information System for obtaining detailed information on soil heterogeneity.

Physiological response of Posidonia oceanica to heavy metal pollution along the Tyrrhenian coast.

Heavy metal (HM) pollution of marine coastal areas is a big concern worldwide. The marine phanerogam Posidonia oceanica (L.) Delile is widely considered to be a sensitive bioindicator of water pollution due to its ability to sequester trace elements from the environment. The analysis of specific biomarkers, like reactive oxygen species scavengers, could allow us to correlate the physiological response of P. oceanica meadows to water pollution. In this study, we analysed the activity of some antioxidant enzymes and the expression level of the corresponding genes in the leaves of P. oceanica plants harvested from four meadows distributed along the Tyrrhenian coast; lipid peroxidation and the expression level of two genes related to HM response, metallothionein-2b and chromethylase, were also measured. The results of biochemical and molecular analyses were correlated with the concentration of some HMs, such as Cr, Cd, Cu, Ni and Pb, measured in P. oceanica leaves. We found a very strong antioxidant response in plants from the Murelle meadow whose HM concentration was the lowest for most of the analysed HMs, particularly Cu.

Arsenic accumulation in edible vegetables and health risk reduction by groundwater treatment using an adsorption process.

The heavy metals transfer from the soil, where they accumulate, to the edible parts of the plants, and then, their entrance in the food chain can represent a source of concern for human health. Among heavy metals, arsenic is one of the most widespread in the soil of Lazio (central region of Italy), where the phytoavailable geogenic arsenic enters the food chain, with a dangerous exposition of the local population. In the first part of this work, plants of radish (Raphanus sativus L.) and lettuce (Lactuca sativa L.) were grown in protected culture in the experimental farm of CREA-AA, where they were daily treated with different concentrations of sodium arsenate dibasic heptahydrate in order to investigate differences in their arsenic accumulation capacities. In order to confirm the results achieved, in the second part of this study, the arsenic concentration was determined in commercial products obtained from contaminated areas of Lazio, and the potential exposition risk for human health through consumption of these widely consumed vegetables was estimated. The highest arsenic concentrations were found in the samples of lettuce. To evaluate the potential health risk from consumption of L. sativa and R. sativus, the estimated daily intake (EDI) for adults, adolescents, and elderly was calculated, finding that HRI (health risk index) index value for arsenic was low (< 1) in the case of chronic consumptions for all samples of radishes, and for the lettuces grown in the area of Viterbo. On the contrary, the lettuces obtained from Tuscania and Tarquinia presented very high concentrations of arsenic and a worrying HRI value. In order to reduce the risk of As toxicity in the people through consumption of the vegetables, the irrigation water should contain less than 0.1 mg As L-1. For this reason, the authors tested the application of red mud (RM) to remove As from groundwater before using it for the irrigation of radish and lettuce in greenhouse production.

Accumulation of heavy metals to assess the health status of swordfish in a comparative analysis of Mediterranean and Atlantic areas.

During the last few decades, the combined effects of natural and human activities acting on the Mediterranean Sea basin have caused a reduction in the swordfish (Xiphias gladius, L. 1758) population. In this project, we investigated the accumulation of lead (Pb), cadmium (Cd) and mercury (Hg) levels in the Atlantic and Mediterranean populations of swordfish during a five-year survey. In the marine environment, top predators such as swordfish accumulate high concentrations of toxic metals, and thus, potentially incur a high toxicological risk. Furthermore, heavy metals, such as chemical pollutants, have strong long-term effects on fish, and thus, constitute a high risk for the resource and humans that consume it. The aim of this work is to contribute to the assessment of the state of European swordfish population health. We analyzed muscle tissue from 56 specimens captured in Mediterranean and Atlantic areas for trace elements. Mean concentrations of Hg, Cd, and Pb were in the following ranges: 0.66-2.41, 0.04-0.16, and 0.97-1.36 mg/kg ww, respectively. These data suggest a need for continuous monitoring to avoid reductions in the population of this fish species of high commercial and ecological interest.