RESUMEN
Lateral memristors configured with inert Pt contacts and mixed phase tin oxide layers have exhibited immediate, forming-free, low-power bidirectional resistance switching. Activity dependent conductance and relaxation in the low resistance state resembled short term potentiation in biological synapses. After scanning probe microscopy, x-ray photoelectron spectroscopy and electrical measurements, the device characteristics were attributed to Joule heating induced decomposition of the minority SnO phase and formation of a SnO2 conducting filament with higher effective n-type doping. Finally, the devices recognized input voltage pulse sequences and spectral data by returning unique conductance states, suggesting suitability for bio-inspired pattern recognition systems.
RESUMEN
Hexagonal boron nitride (hBN) is a promising material for a range of applications including deep-ultraviolet light emission. Despite extensive experimental studies, some fundamental aspects of hBN remain unknown, such as the type of stacking faults likely to be present and their influence on electronic properties. In this paper, different stacking configurations of hBN are investigated using CASTEP, a pseudopotential density functional theory code. AB-b stacking faults, in which B atoms are positioned directly on top of one another while N atoms are located above the center of BN hexagons, are shown to be likely in conventional AB stacked hBN. Bandstructure calculations predict a single direct bandgap structure that may be responsible for the discrepancies in bandgap type observed experimentally. Calculations of the near edge structure showed that different stackings of hBN are distinguishable using measurements of core-loss edges in X-ray absorption and electron energy loss spectroscopy. AB stacking was found to best reproduce features in the experimental B and N K-edges. The calculations also show that splitting of the 1s to π* peak in the B K-edge, recently observed experimentally, may be accounted for by the presence of AB-b stacking faults.
RESUMEN
Polydimethyl glutarimide (PMGI) layers with sub-micron thicknesses have been modified in a 2.5 kV Ar plasma immersion ion implantation (PIII) process to introduce free radical covalent binding sites. The surface roughness of the PMGI increased after the PIII treatment but no through-layer defects were observed. When applied to the treated PMGI, horseradish peroxidase (HRP) enzyme remained bound to the surface after extended immersion in sodium dodecyl sulfate solution (SDS). Hence, covalent binding between the activated surface and enzyme was confirmed. This covalent binding was achieved up to 24-h after the PIII process. The treated PMGI was then incorporated as a gate dielectric layer within a lateral three-terminal electrolyte-gated device. The device output characteristics resembled those of post-synaptic outputs; as successive (pre-synaptic) voltage pulses were applied to the gate, paired pulse depression and spike rate dependent plasticity were observed in the source-drain (post-synaptic) current. These characteristics were altered by the presence of HRP immobilised on the plasma-modified PMGI gate dielectric layer thus providing readout detection. These results and preliminary device characteristics show the potential for the plasma functionalized PMGI as a sensitive and reproducible biosensing technology.