RESUMEN
UH3 is the first discovered material with ferromagnetism based purely on the 5f electronic states, known for more than half century. Although the U metal is Pauli paramagnet, the reduced 5f-5f overlap in compounds allows for moment formation and ordering, typically if the U-U spacing exceeds the Hill limit, i.e. about 340 pm. The stable form of UH3, known as ß-UH3, has rather high TC ≈ 170 K. Such high value is rather unusual, considering dU-U = 331 pm. Properties of metastable α-UH3 with dU-U = 360 pm could be never well established. Using the fact that α-UH3 is in fact bcc U with interstitials filled by H, we attempted to synthesize α-UH3 starting from the γ-U alloys, with the bcc structure retained to room temperature by doping combined with ultrafast cooling. While up to 15% Zr a contamination by ß-UH3 was obtained, 20% Zr yielded single phase α-UH3. The TC value remains high and very similar to ß-UH3. One can see an increase up to 187 K for 15% Zr, followed by a weak decrease. Magnetic moments remain close to 1 µB/U atom. An insight is provided by ab-initio calculations, revealing a a charge transfer towards H-1s states, depopulating the U-6d and 7s states, leaving almost pure 5f character around the Fermi level. The 5f magnetism exhibits a high coercivity (µ0Hc up to 5.5 T) and large spontaneous volume magnetostriction of 3.2*10-3. Even higher increase of TC, reaching up to 203 K, can be achieved in analogous Mo stabilized hydrides, which yield an amorphous structure. The compounds represent, together with known hydrides of U6Fe and U6Co, a new group of robust 5f ferromagnets with small dU-U but high TC. Although common hydrides are fine powders, some of the new hydrides described as (UH3)(1-x)T x (T = Zr or Mo) remain monolithic, which allows to study transport and thermodynamic properties.
RESUMEN
Rare-earth (R)-iron alloys are a backbone of permanent magnets. Recent increase in price of rare earths has pushed the industry to seek ways to reduce the R-content in the hard magnetic materials. For this reason strong magnets with the ThMn12 type of structure came into focus. Functional properties of R(Fe,T)12 (T-element stabilizes the structure) compounds or their interstitially modified derivatives, R(Fe,T)12-X (X is an atom of hydrogen or nitrogen) are determined by the crystal-electric-field (CEF) and exchange interaction (EI) parameters. We have calculated the parameters using high-field magnetization data. We choose the ferrimagnetic Tm-containing compounds, which are most sensitive to magnetic field and demonstrate that TmFe11Ti-H reaches the ferromagnetic state in the magnetic field of 52 T. Knowledge of exact CEF and EI parameters and their variation in the compounds modified by the interstitial atoms is a cornerstone of the quest for hard magnetic materials with low rare-earth content.
RESUMEN
Pure hydride of the α-UH3 type without any ß-UH3 admixture was prepared by high-pressure hydrogenation of bcc U stabilized by Zr. Such material, characterized by a general formula (UH3)1-x Zr x , is stable in air at ambient and elevated temperatures. H release is observed between 400-450 °C similar to ß-UH3. Its stability allowed to measure magnetic properties, specific heat, and electrical resistivity in a wide temperature range. Despite rather different crystal structure and inter-U spacing, the electronic properties are almost identical to ß-UH3. Its ferromagnetic ground state with Curie temperature TC ≈ 180 K (weakly and non-monotonously dependent on Zr concentration) and U moments of 1.0 µB indicate why mixtures of α- and ß-UH3 exhibited only one transition. Magnetic ordering leads to a large spontaneous magnetostriction ωs = 3.2*10-3, which can be explained by the increase of the spin moment between the paramagnetic (Disordered Local Moment) and the ferromagnetic state. The role of orbital moments in magnetism is indicated by fully relativistic electronic structure calculations.