Non-diffractive computational ghost imaging.

Computational ghost imaging (CGI) enables an image to be recorded using a single-pixel detector. The image can be reconstructed from correlations between the scene and a series of known projected intensity patterns. In this work we investigate the performance of CGI using pseudo non-diffracting (ND) speckle patterns. We demonstrate an extended depth-of-field that is ∼ 2-3 times greater than that achievable with conventional speckle, when only computing each intensity pattern to a single depth. In addition, the average speckle grain size of ND speckle is reduced by a factor of ∼ 1.5 relative to conventional speckle, which enhances the lateral Rayleigh-limit resolving power of our reconstructed images. However, the point-spread function (PSF) of our imaging system takes the form of a Bessel beam, which manifests itself as long-range correlations between speckle grains in the projected patterns. We discuss the trade-off between enhancement of the depth-of-field and the lateral resolution when using ND speckle, at the expense of a reduction in image contrast. Our work demonstrates that the tailoring of lateral and axial correlations in projected intensity patterns permits PSF engineering in CGI.

The effects of heavy load carriage on physiological responses to graded exercise.

PURPOSE: Many emergency response occupations require heavy load carriage with backpacks. The purpose of this experiment was to study the effects of heavy load carriage on physiological responses and performance during graded exercise. METHODS: Fifty males (age: 28 ± 6 years, height: 182.8 ± 6.2 cm, mass: 85.4 ± 12.1 kg) provided written informed consent before completing two randomly ordered graded exercise tests to measure ventilatory threshold and peak oxygen consumption (˙VO2peak). During the loaded test, each subject carried a correctly sized and fitted 80 L backpack weighing 25 kg. Mass, volume and load distribution were consistent between all packs. Modified Balke treadmill tests were completed by walking at 1.5 m s(−1) with stage increases of 2% grade until exhaustion. RESULTS: Analysis revealed a small but significant decrease in ˙VO2 at ventilatory threshold (3.9%) and peak exercise (2.5%) under load. Power output at ventilatory threshold and ˙VO2peak were significantly decreased by 23.6 and 11.1%, respectively, and test duration was reduced by 29.8% in the loaded condition. CONCLUSIONS: While heavy load carriage had relatively small effects on physiological responses at ventilator threshold and peak exercise, the reductions in power output and test duration were more substantial. Despite the absolute mass of the pack and the large range of subject size, the only change in performance associated with body size was test duration. These results have implications for evaluation of fitness for duty in occupations where heavy load carriage is required.

'Lissajous-like' trajectories in optical tweezers.

When a microscopic particle moves through a low Reynolds number fluid, it creates a flow-field which exerts hydrodynamic forces on surrounding particles. In this work we study the 'Lissajous-like' trajectories of an optically trapped 'probe' microsphere as it is subjected to time-varying oscillatory hydrodynamic flow-fields created by a nearby moving particle (the 'actuator'). We show a breaking of time-reversal symmetry in the motion of the probe when the driving motion of the actuator is itself time-reversal symmetric. This symmetry breaking results in a fluid-pumping effect, which arises due to the action of both a time-dependent hydrodynamic flow and a position-dependent optical restoring force, which together determine the trajectory of the probe particle. We study this situation experimentally, and show that the form of the trajectories observed is in good agreement with Stokesian dynamics simulations. Our results are related to the techniques of active micro-rheology and flow measurement, and also highlight how the mere presence of an optical trap can perturb the environment it is in place to measure.

Four-directional stereo-microscopy for 3D particle tracking with real-time error evaluation.

High-speed video stereo-microscopy relies on illumination from two distinct angles to create two views of a sample from different directions. The 3D trajectory of a microscopic object can then be reconstructed using parallax to combine 2D measurements of its position in each image. In this work, we evaluate the accuracy of 3D particle tracking using this technique, by extending the number of views from two to four directions. This allows us to record two independent sets of measurements of the 3D coordinates of tracked objects, and comparison of these enables measurement and minimisation of the tracking error in all dimensions. We demonstrate the method by tracking the motion of an optically trapped microsphere of 5 µm in diameter, and find an accuracy of 2-5 nm laterally, and 5-10 nm axially, representing a relative error of less than 2.5% of its range of motion in each dimension.

A multi-modal stereo microscope based on a spatial light modulator.

Spatial Light Modulators (SLMs) can emulate the classic microscopy techniques, including differential interference (DIC) contrast and (spiral) phase contrast. Their programmability entails the benefit of flexibility or the option to multiplex images, for single-shot quantitative imaging or for simultaneous multi-plane imaging (depth-of-field multiplexing). We report the development of a microscope sharing many of the previously demonstrated capabilities, within a holographic implementation of a stereo microscope. Furthermore, we use the SLM to combine stereo microscopy with a refocusing filter and with a darkfield filter. The instrument is built around a custom inverted microscope and equipped with an SLM which gives various imaging modes laterally displaced on the same camera chip. In addition, there is a wide angle camera for visualisation of a larger region of the sample.

Measuring nanoscale forces with living probes.

Optical trapping techniques have been used to investigate fundamental biological processes ranging from the identification of the processive mechanisms of kinesin and myosin to understanding the mechanics of DNA. To date, these investigations have relied almost exclusively on the use of isotropic probes based on colloidal microspheres. However, there are many potential advantages in utilizing more complex probe morphologies: use of multiple trapping points enables control of the interaction volume; increasing the distance between the optical trap and the sample minimizes photodamage in sensitive biological materials; and geometric anisotropy introduces the potential for asymmetric surface chemistry and multifunctional probes. Here we demonstrate that living cells of the freshwater diatom Nitzschia subacicularis Hustedt can be exploited as advanced probes for holographic optical tweezing applications. We characterize the optical and material properties associated with the high shape anisotropy of the silica frustule, examine the trapping behavior of the living algal cells, and demonstrate how the diatoms can be calibrated for use as force sensors and as force probes in the presence of rat B-cell hybridoma (11B11) cells.

Distribution of sialic acids on mucins and gels: a defense mechanism.

Moist mucosal epithelial interfaces that are exposed to external environments are dominated by sugar epitopes, some of which (e.g., sialic acids) are involved in host defense. In this study, we determined the abundance and distribution of two sialic acids to assess differences in their availability to an exogenous probe in isolated mucins and mucous gels. We used atomic force microscopy to obtain force maps of human preocular mucous and purified ocular mucins by probing and locating the interactions between tip-tethered lectins Maackia amurensis and Sambucus nigra and their respective receptors, α-2,3 and α-2,6 N-acetylneuraminic (sialic) acids. The rupture force distributions were not affected by neighboring sugar-bearing molecules. Energy contours for both lectin-sugar bonds were fitted to a two-barrier model, suggesting a conformational change before dissociation. In contrast to data from purified mucin molecules, the preocular gels presented numerous large clusters (19,000 ± 4000 nm(2)) of α-2,6 sialic acids, but very few small clusters (2000 ± 500 nm(2)) of α-2,3 epitopes. This indicates that mucins, which are rich in α-2,3 sialic acids, are only partially exposed at the surface of the mucous gel. Microorganisms that recognize α-2,3 sialic acids will encounter only isolated ligands, and the adhesion of other microorganisms will be enhanced by large islands of neighboring α-2,6 sialic acids. We have unveiled an additional level of mucosal surface heterogeneity, specifically in the distribution of pro- and antiadhesive sialic acids that protect underlying epithelia from viruses and bacteria.

An optically actuated surface scanning probe.

We demonstrate the use of an extended, optically trapped probe that is capable of imaging surface topography with nanometre precision, whilst applying ultra-low, femto-Newton sized forces. This degree of precision and sensitivity is acquired through three distinct strategies. First, the probe itself is shaped in such a way as to soften the trap along the sensing axis and stiffen it in transverse directions. Next, these characteristics are enhanced by selectively position clamping independent motions of the probe. Finally, force clamping is used to refine the surface contact response. Detailed analyses are presented for each of these mechanisms. To test our sensor, we scan it laterally over a calibration sample consisting of a series of graduated steps, and demonstrate a height resolution of ∼ 11 nm. Using equipartition theory, we estimate that an average force of only ∼ 140 fN is exerted on the sample during the scan, making this technique ideal for the investigation of delicate biological samples.

Position clamping of optically trapped microscopic non-spherical probes.

We investigate the degree of control that can be exercised over an optically trapped microscopic non-spherical force probe. By position clamping translational and rotational modes in different ways, we are able to dramatically improve the position resolution of our probe with no reduction in sensitivity. We also demonstrate control over rotational-translational coupling, and exhibit a mechanism whereby the average centre of rotation of the probe can be displaced away from its centre.

Surface imaging using holographic optical tweezers.

We present an imaging technique using an optically trapped cigar-shaped probe controlled using holographic optical tweezers. The probe is raster scanned over a surface, allowing an image to be taken in a manner analogous to scanning probe microscopy (SPM), with automatic closed loop feedback control provided by analysis of the probe position recorded using a high speed CMOS camera. The probe is held using two optical traps centred at least 10 µm from the ends, minimizing laser illumination of the tip, so reducing the chance of optical damage to delicate samples. The technique imparts less force on samples than contact SPM techniques, and allows highly curved and strongly scattering samples to be imaged, which present difficulties for imaging using photonic force microscopy. To calibrate our technique, we first image a known sample--the interface between two 8 µm polystyrene beads. We then demonstrate the advantages of this technique by imaging the surface of the soft alga Pseudopediastrum. The scattering force of our laser applied directly onto this sample is enough to remove it from the surface, but we can use our technique to image the algal surface with minimal disruption while it is alive, not adhered and in physiological conditions. The resolution is currently equivalent to confocal microscopy, but as our technique is not diffraction limited, there is scope for significant improvement by reducing the tip diameter and limiting the thermal motion of the probe.

Transitional behavior in hydrodynamically coupled oscillators.

In this article we consider the complete set of synchronized and phase-locked states available to pairs of hydrodynamically coupled colloidal rotors, consisting of spherical beads driven about circular paths in the same, and in opposing senses. Oscillators such as these have previously been used as coarse grained, minimal models of beating cilia. Two mechanisms are known to be important in establishing synchrony. The first involves perturbation of the driving force, and the second involves deformation of the rotor trajectory. We demonstrate that these mechanisms are of similar strength, in the regime of interest, and interact to determine observed behavior. Combining analysis and simulation with experiments performed using holographic optical tweezers, we show how varying the amplitude of the driving force perturbation leads to a transition from synchronized to phase-locked states. Analogies with biological systems are discussed, as are implications for the design of biomimetic devices.

A compact holographic optical tweezers instrument.

Holographic optical tweezers have found many applications including the construction of complex micron-scale 3D structures and the control of tools and probes for position, force, and viscosity measurement. We have developed a compact, stable, holographic optical tweezers instrument which can be easily transported and is compatible with a wide range of microscopy techniques, making it a valuable tool for collaborative research. The instrument measures approximately 30×30×35 cm and is designed around a custom inverted microscope, incorporating a fibre laser operating at 1070 nm. We designed the control software to be easily accessible for the non-specialist, and have further improved its ease of use with a multi-touch iPad interface. A high-speed camera allows multiple trapped objects to be tracked simultaneously. We demonstrate that the compact instrument is stable to 0.5 nm for a 10 s measurement time by plotting the Allan variance of the measured position of a trapped 2 µm silica bead. We also present a range of objects that have been successfully manipulated.

A multimedia perioperative record keeper for clinical research.

OBJECTIVE: To develop a multimedia perioperative recordkeeper that provides: 1. synchronous, real-time acquisition of multimedia data, 2. on-line access to the patient's chart data, and 3. advanced data analysis capabilities through integrated, multimedia database and analysis applications. DESIGN: To minimize cost and development time, the system design utilized industry standard hardware components and graphical. software development tools. The system was configured to use a Pentium PC complemented with a variety of hardware interfaces to external data sources. These sources included physiologic monitors with data in digital, analog, video, and audio as well as paper-based formats. DEVELOPMENT: The development process was guided by trials in over 80 clinical cases and by the critiques from numerous users. As a result of this process, a suite of custom software applications were created to meet the design goals. The Perioperative Data Acquisition application manages data collection from a variety of physiological monitors. The Charter application provides for rapid creation of an electronic medical record from the patient's paper-based chart and investigator's notes. The Multimedia Medical Database application provides a relational database for the organization and management of multimedia data. The Triscreen application provides an integrated data analysis environment with simultaneous, full-motion data display. CONCLUSION: With recent technological advances in PC power, data acquisition hardware, and software development tools, the clinical researcher now has the ability to collect and examine a more complete perioperative record. It is hoped that the description of the MPR and its development process will assist and encourage others to advance these tools for perioperative research.

Sonographic investigation of flow patterns in the perfused human placenta and their modulation by vasoactive agents with enhanced visualization by the ultrasound contrast agent Albunex.

PURPOSE: Our objective was to demonstrate sonographically the flow distribution in the circulation of human placentae as well as the sensitivity of the human fetal capillary bed to vasoconstriction and dilatation. METHODS: Five human full-term placental lobules were maintained in vitro with fetal and maternal flow. Commercial ultrasound scanners were used for imaging. Albunex (1 ml bolus) was administered to the fetal "artery" to monitor patterns of flow. U46619 (1 ml, 10(-6) M; a thromboxane agonist and potent vasoconstrictor) and/or nitroglycerin (a potent vasodilator) were added to the fetal artery. RESULTS: Following the addition of U46619, mean "fetal pressures" rapidly rose from 23.2 +/- 0.8 to 118 +/- 2. 9 mm Hg (mean +/- standard error of mean; p < 0.001); venous flow rates decreased. As demonstrated by color Doppler imaging, flow markedly changed from a pattern of general distribution throughout the lobule to flow only near the chorionic plate. Color persistence was 94.4 +/- 6.5 seconds with Albunex after nitroglycerin and 39.8 +/- 3.4 seconds with Albunex after injection of U46619 (p < 0.001). Nitroglycerin had no effect when injected by itself but returned "constricted" flow to a "normal" pattern when injected after U46619. CONCLUSIONS: The contrast medium Albunex improved visualization of the fetal circulation throughout the lobule. Flow in the human placental capillary bed can be regionally manipulated throughout the placental lobule by vasomodulators and monitored by Albunex-enhanced sonographic examination.