Chemical free, bio-Intercalation of selenium nanoparticles for highly accelerated photo-responsive of organic contaminants debasement and their in-vitro anti-bacterial agents, anti-oxidants effect, cyto-toxic analysis.

This study investigates the use of Excoecaria agallocha leaves as a bio-template for the intercalation of Selenium nanoparticles (SeNPs). The synthesized SeNPs were characterized using techniques like SEM-EDX, TEM/HR-TEM, and XRD spectroscopic studies. The study found that SeNPs showed maximum cleaning ability at a dosage of 50 µl/mL, with 95% inhibition of DPPH radicals. However, cellular absorption was limited to 55% at concentrations of 300 µg/L over a 72-h period. The synthesized SeNPs also demonstrated a strong cytotoxic effect on MCF-7 breast cancer cell lines, indicating their potential as anti-cancer agents. Further research is needed to fully explore the potential of these novel nanocomposites.

Electrochemical biosensor detection on respiratory and flaviviruses.

Viruses have spread throughout the world and cause acute illness or death among millions of people. There is a growing concern about methods to control and combat early-stage viral infections to prevent the significant public health problem. However, conventional detection methods like polymerase chain reaction (PCR) requires sample purification and are time-consuming for further clinical diagnosis. Hence, establishing a portable device for rapid detection with enhanced sensitivity and selectivity for the specific virus to prevent further spread becomes an urgent need. Many research groups are focusing on the potential of the electrochemical sensor to become a key for developing point-of-care (POC) technologies for clinical analysis because it can solve most of the limitations of conventional diagnostic methods. Herein, this review discusses the current development of electrochemical sensors for the detection of respiratory virus infections and flaviviruses over the past 10 years. Trends in future perspectives in rapid clinical detection sensors on viruses are also discussed. KEY POINTS: • Respiratory related viruses and Flavivirus are being concerned for past decades. • Important to differentiate the cross-reactivity between the virus in same family. • Electrochemical biosensor as a suitable device to detect viruses with high performance.

A quadruplet 3-D laser scribed graphene/MoS2, functionalised N2-doped graphene quantum dots and lignin-based Ag-nanoparticles for biosensing.

Troponin I is a protein released into the human blood circulation and a commonly used biomarker due to its sensitivity and specificity in diagnosing myocardial injury. When heart injury occurs, elevated troponin Troponin I levels are released into the bloodstream. The biomarker is a strong and reliable indicator of myocardial injury in a person, with immediate treatment required. For electrochemical sensing of Troponin I, a quadruplet 3D laser-scribed graphene/molybdenum disulphide functionalised N2-doped graphene quantum dots hybrid with lignin-based Ag-nanoparticles (3D LSG/MoS2/N-GQDs/L-Ag NPs) was fabricated using a hydrothermal process as an enhanced quadruplet substrate. Hybrid MoS2 nanoflower (H3 NF) and nanosphere (H3 NS) were formed independently by varying MoS2 precursors and were grown on 3D LSG uniformly without severe stacking and restacking issues, and characterized by morphological, physical, and structural analyses with the N-GQDs and Ag NPs evenly distributed on 3D LSG/MoS2 surface by covalent bonding. The selective capture of and specific interaction with Troponin I by the biotinylated aptamer probe on the bio-electrode, resulted in an increment in the charge transfer resistance. The limit of detection, based on impedance spectroscopy, is 100 aM for both H3 NF and H3 NS hybrids, with the H3 NF hybrid biosensor having better analytical performance in terms of linearity, selectivity, repeatability, and stability.

Conversion of archeological iron rust employing coconut husk lignin.

Rust powder collected from an archeological iron was evaluated by complementary analyses such as FTIR, XRD, XRF, and SEM/EDX. The analyses revealed that lepidocrocite (L) was the major component in the archeological iron. Coconut husk (CH) can be classified as a type of lignocellulosic biomass of renewable resources that are widely available, especially in coastal areas. In this research, the isolated lignin extracted from CH is being studied as a potential alternative for environmentally friendly applications. The isolated lignin from soda and organosolv pulping went through several analyses such as FTIR, NMR (13C and 2D-HSQC), and TGA analyses. The analyses showed that lignin isolated via soda pulping has superior antioxidant capabilities due to its greater phenolic-OH content compared to lignin isolated from organosolv pulping. The effects of lignin concentrations, pH, and reaction time were utilized in rust conversion studies of an archeological iron. 5 wt% of soda lignin (SL) was revealed as the ideal condition in this rust conversion study with a value of 84.21 %. The treated rust powder with 5 wt% of SL was then further gone through several complementary analyses, which revealed that the treated rust had nearly transformed into an amorphous state.

Gum Arabic Nanoparticles as Green Corrosion Inhibitor for Reinforced Concrete Exposed to Carbon Dioxide Environment.

The inhibiting effect of Gum Arabic-nanoparticles (GA-NPs) to control the corrosion of reinforced concrete that exposed to carbon dioxide environment for 180 days has been investigated. The steel reinforcement of concrete in presence and absence of GA-NPs were examined using various standard techniques. The physical/surface changes of steel reinforcement was screened using weight loss measurement, electrochemical impedance spectroscopy (EIS), atomic force microscopy and scanning electron microscopy (SEM). In addition, the carbonation resistance of concrete as well screened using visual inspection (carbonation depth), concrete alkalinity (pH), thermogravimetric analysis (TGA), SEM, energy-dispersive X-ray spectroscopy (EDX) and X-ray diffraction (XRD). The GA-NPs inhibitor size was also confirmed by transmission electron microscopy (TEM). The results obtained revealed that incorporation of 3% GA-NPs inhibitor into concrete inhibited the corrosion process via adsorption of inhibitor molecules over the steel reinforcement surface resulting of a protective layer formation. Thus, the inhibition efficiency was found to increase up-to 94.5% with decreasing corrosion rate up-to 0.57 × 10-3 mm/year. Besides, the results also make evident the presence of GA-NPs inhibitor, ascribed to the consumption of calcium hydroxide, and reduced the Ca/Si to 3.72% and 0.69% respectively. Hence, C-S-H gel was developed and pH was increased by 9.27% and 12.5, respectively. It can be concluded that green GA-NPs have significant corrosion inhibition potential and improve the carbonation resistance of the concrete matrix to acquire durable reinforced concrete structures.

Laser-scribed graphene nanofiber decorated with oil palm lignin capped silver nanoparticles: a green biosensor.

Tuberculosis (TB), caused by Mycobacterium tuberculosis (M. tuberculosis), requires a high level of attention and is one of the most infectious diseases in the air. Present methods of diagnosing TB remain ineffective owing to their low sensitivity and time consumption. In this study, we produced a green graphene nanofiber laser biosensor (LSG-NF) decorated with oil palm lignin-based synthetic silver nanoparticles (AgNPs). The resulting composite morphology was observed by field-emission scanning electron microscopy and transmission electron microscopy, which revealed the effective adaptation of the AgNPs to the LSG-NF surface. The successful attachment of AgNPs and LSG-NFs was also evident from X-ray diffraction and Raman spectroscopy studies. In order to verify the sensing efficiency, a selective DNA sample captured on AgNPs was investigated for specific binding with M.tb target DNA through selective hybridisation and mismatch analysis. Electrochemical impedance studies further confirmed sensitive detection of up to 1 fM, where a detection limit of 10-15 M was obtained by estimating the signal-to-noise ratio (S/N = 3:1) as 3σ. Successful DNA immobilisation and hybridisation was confirmed by the detection of phosphorus and nitrogen peaks based on X-ray photoelectron spectroscopy and Fourier-transform infrared spectroscopy. The stability and repeatability of the analysis were high. This approach provides an affordable potential sensing system for the determination of M. tuberculosis biomarker and thus provides a new direction in medical diagnosis.