RESUMEN
In this study, the synthesis of novel 7-hydroxy-3-ethyl-6-hexyl-4-methylcoumarin (1), four respective phthalonitriles; 4-(7-oxy-3-ethyl-6-hexyl-4-methylcoumarin)phthalonitrile (2), 3-(7-oxy-3-ethyl-6-hexyl-4-methylcoumarin)phthalonitrile (3), 4-chloro-5-(7-oxy-3-ethyl-6-hexyl-4-methylcoumarin)phthalonitrile (4), and 4,5-bis(7-oxy-3-ethyl-6-hexyl-4-methylcoumarin)phthalonitrile (5) and their corresponding alpha tetra, beta tetra and beta octa 7-oxy-3-ethyl-6-hexyl-4-methylcoumarin and beta octa 4-chloro-5-(7-oxy-3-ethyl-6-hexyl-4-methylcoumarin) substituted Zn(ii) (6a-9a) and In(iii) Cl (6b-9b) phthalocyanines has been performed. The novel purified compounds were characterized by standard characterization techniques such as elemental analysis, thermal analysis, FT-IR, UV-vis, 1H-NMR and MALDI-TOF mass spectrometry. All of the obtained phthalocyanines showed lipophilic behaviour with excellent solubility in organic solvents such as acetone, dichloromethane, chloroform, pyridine and ethyl acetate. The fluorescence quenching behaviour was investigated using 1,4-benzoquinone and potassium iodide as quenchers. The photophysical (fluorescence quantum yields and lifetimes) and photochemical (singlet oxygen and photodegradation quantum yields) properties of these novel phthalocyanines (6a-9a and 6b-9b) were studied in DMF. They produced high singlet oxygen (for example ΦΔ = 0.99 for 7b) and showed appropriate photodegradation (in the order of 10-5) which is very important for photodynamic therapy (PDT), and thus these phthalocyanines can be used as Type II photosensitizers in PDT applications.
RESUMEN
The new ball-type metallo bisphthalocyanines (Co(2)Pc(2) and Zn(2)Pc(2)) were synthesized from the corresponding [4,4'-bis(dicoumaroylphthalonitrile)] which can be obtained from the reaction of 3,3'-methylenebis(4-hydroxy-2H-chromen-2-one) and 4-nitrophthalonitrile. The structures of the newly synthesized compounds have been confirmed and characterized by elemental analysis, UV/Vis, IR and (1)H NMR spectroscopies and MALDI-TOF mass spectrometry. Solar cells of the configuration ITO/Co(2)Pc(2)/C60/Al and ITO/Zn(2)Pc(2)/C60/Al were fabricated. The effect of the thickness of the active Pc layer--the thickness of the Pc layer was varied from 15 to 80 nm--on solar cells parameters has been investigated. A nearly thickness independent open circuit voltage was observed in both structures. The maximum photovoltaic conversion efficiency, short circuit current and fill factor were observed in ITO/Zn(2)Pc(2)/C60/Al cell with 80 nm Pc layer to be 0.255%, 1 mA cm(-2) and 0.38, respectively. The redox properties of the ball-type complexes were investigated by cyclic voltammetry, controlled-potential coulometry and in situ spectroelectrochemistry in DMSO-TBAP. The electrochemical measurements showed that the complexes form ring-based and/or metal-based mixed-valence species, due to the remarkable intramolecular interactions between the two metal phthalocyanine units. The Vulcan XC-72(VC)/Nafion(Nf)/Co(2)Pc(2) modified glassy carbon electrode showed much higher catalytic performance towards oxygen reduction, compared to the VC/Nf/Zn(2)Pc(2) modified one. It was found that the VC/Nf/Co(2)Pc(2) catalyst is nearly insensitive to the presence of methanol. In the presence of 1 M methanol in the electrolyte, the catalytic performance of the Co(2)Pc(2)-based catalyst in oxygen reduction was much better than that of the Pt-based one. Thus, it was shown that the VC/Nf/Co(2)Pc(2) catalyst can be a good alternative to VC/Nf/Pt as a cathode catalyst in direct methanol fuel cells.