Exploring the Effects of Organic Matter Characteristics on Fe(II) Oxidation Kinetics in Coastal Seawater.

The iron(II) oxidation kinetic process was studied at 25 stations in coastal seawater of the Macaronesia region (9 around Cape Verde, 11 around the Canary Islands, and 5 around Madeira). In a physicochemical context, experiments were carried out to study the pseudo-first-order oxidation rate constant (k', min-1) over a range of pH (7.8, 7.9, 8.0, and 8.1) and temperature (10, 15, 20, and 25 °C). Deviations from the calculated kcal' at the same T, pH, and S were observed for most of the stations. The measured t1/2 (ln 2/k', min) values at the 25 stations ranged from 1.82 to 3.47 min (mean 1.93 ± 0.76 min) and for all but two stations were lower than the calculated t1/2 of 3.21 ± 0.2 min. In a biogeochemical context, nutrients and variables associated with the organic matter spectral properties (CDOM and FDOM) were analyzed to explain the observed deviations. The application of a multilinear regression model indicated that k' can be described (R = 0.921 and SEE = 0.064 for pH = 8 and T = 25 °C) from a linear combination of three organic variables, k'OM = kcal' -0.11* TDN + 29.9*bDOM + 33.4*C1humic, where TDN is the total dissolved nitrogen, bDOM is the spectral peak obtained from colored dissolved organic matter (DOM) analysis when protein-like or tyrosine-like components are present, and C1humic is the component associated with humic-like compounds obtained from the parallel factor analysis of the fluorescent DOM. Results show that compounds with N in their structures mainly explain the observed k' increase for most of the samples, although other components could also play a relevant role. Experimentally, k' provides the net result between the compounds that accelerate the process and those that slow it down.

Impact of sampling depth on CO 2 flux estimates.

The exchange of trace gases between the atmosphere and the ocean plays a key role in the Earth's climate. Fluxes at the air-sea interface are affected mainly by wind blowing over the ocean and seawater temperature and salinity changes. This study aimed to quantify the use of CO 2 partial pressure (pCO 2 ) measurements at different depths (1, 5, and 10 m) in ocean surface layers to determine CO 2 fluxes (FCO 2 ) and to investigate the impacts of wind-sheltered and wind-exposed regions on the carbon budget. Vertical profiles of temperature, salinity, and pCO 2 were considered during a daily cycle. pCO 2 profiles exhibited relatively high values during sunny hours, associated with relatively high sea temperatures. However, the largest FCO 2 corresponded with higher wind speeds. Estimated fluxes between measurements at 1 and 10 m depths decreased by 71% in the sheltered region and 44% in the exposed region. According to the SOCAT dataset, at a depth of 5 m, the Atlantic basin emits approximately 0.29 Tg month - 1 of CO 2 to the atmosphere; nevertheless, our estimates suggest that FCO 2 at the surface is 12.02 Tg month - 1 , which is 97.6% greater than that at 5 m depth. Therefore, future studies should consider sampling depth to adequately estimate the FCO 2 .

Cu transport and complexation by the marine diatom Phaeodactylum tricornutum: Implications for trace metal complexation kinetics in the surface ocean.

Elucidating whether dissolved Cu uptake is kinetically or thermodynamically controlled, and the effects of speciation on Cu transport by phytoplankton will allow better modeling of the fate and impact of dissolved Cu in the ocean. To address these questions, we performed Cu physiological and physicochemical experiments using the model diatom, Phaeodactylum tricornutum, grown in natural North Atlantic seawater (0.44 nM Cu). Using competitive ligand equilibration-cathodic stripping voltammetry (CLE-CSV), we measured two organic ligand types released by P. tricornutum to bind Cu (L1 and L2) at concentrations of ~0.35 nM L1 and 1.3 nM L2. We also established the presence of two putative Cu-binding sites at the cell surface of P. tricornutum (S1 and S2) with log K differing by ~5 orders of magnitude (i.e., 12.9 vs. 8.1) and cell surface densities by 9-fold. Only the high-affinity binding sites, S1, exhibit reductase activity. Using voltammetric kinetic measurements and a theoretical kinetic model, we calculated the forward and dissociation rate constants of L1 and S1. Complementary 67Cu uptake experiments identified a high- and a low-affinity Cu uptake system in P. tricornutum, with half-saturation constant (Km) of 154 nM and 2.63 µM dissolved Cu, respectively. In the P. tricornutum genome, we identified a putative high-affinity Cu transporter (PtCTR49224) and a putative ZIP-like, low-affinity Cu transporter (PtZIP49400). PtCTR49224 has high homology to Homo sapiens hCTR1, which depending on the accessibility to extracellular reducing agents, the hCTR1 itself is involved in the reduction of Cu2+ to Cu+ before internalization. We combined these physiological and physicochemical data to calculate the rate constants for the internalization of Cu, and established that while the high-affinity Cu uptake system (S1) is borderline between a kinetically or thermodynamically controlled system, the low-affinity Cu transporters, S2, is thermodynamically-controlled. We revised the inverse relationship between the concentrations of inorganic complexes of essential metals (i.e., Ni, Fe, Co, Zn, Cd, Mn and Cu) in the mixed layer and the formation rate constant of metal transporters in phytoplankton, highlighting the link between the chemical properties of phytoplankton metal transporters and the availability and speciation of trace metals in the surface ocean.

Oxidation of Cu(I) in seawater at low oxygen concentrations.

The oxidation of nanomolar copper(I) at low oxygen (6 µM) concentrations was studied as a function of pH (6.7-8.2), ionic strength (0.1-0.76 M), total inorganic carbon concentration (0.65-6.69 mM), and the added concentration of hydrogen peroxide, H(2)O(2) (100-500 nM) over the initial 150 nM H(2)O(2) concentration in the coastal seawater. The competitive effect between H(2)O(2) and O(2) at low O(2) concentrations has been described. Both the oxidation of Cu(I) by oxygen and by H(2)O(2) had a reaction order of one. The reduction of Cu(II) back to Cu(I) in the studied seawater by H(2)O(2) and other reactive oxygen intermediates took place at both high and low O(2) concentrations. The effect of the pH on oxidation was more important at low oxygen concentrations, where δlog k/δpH was 0.85, related to the presence of H(2)O(2) in the initial seawater and its role in the redox chemistry of Cu species, than at oxygen saturation, where the value was 0.6. A kinetic model that considered the Cu speciation, major ion interactions, and the rate constants for the oxidation and reduction of Cu(I) and Cu(II) species, respectively, was applied. When the oxygen concentration was lower than 22 µM and under the presence of 150 nM H(2)O(2), the model showed that the oxidation of Cu(I) was controlled by its reaction with H(2)O(2). The effect of the pH on the oxidation rate of Cu(I) was explained by its influence on the oxidation of Cu(I) with O(2) and H(2)O(2), making the model valid for any low oxygen environment.

Oxidation of Fe(II) in natural waters at high nutrient concentrations.

The Fe(II) oxidation kinetic was studied in seawater enriched with nutrients as a function of pH (7.2-8.2), temperature (5-35 °C), and salinity (10-36.72) and compared with the same parameters in seawater media. The effect of nitrate (0-1.77 × 10(-3) M), phosphate (0-5.80 × 10(-5) M) and silicate (0-2.84 × 10(-4) M) was studied at pH 8.0 and 25 °C. The experimental results demonstrated that Fe(II) oxidation was faster in high nutrient concentrations affecting the lifetime of Fe(II) in nutrient rich waters. Silicate displayed the most significant effects on the Fe(II) oxidation rate with values similar to those determined in seawater enriched with all the nutrients. A kinetic model was applied to the experimental results in order to account for changes in the speciation and to compute the fractional contribution of each Fe(II) species to the total rate constant as a function of pH. FeH(3)SiO(4)(+) played a key role in the Fe(II) speciation, dominating the process at pH over 8.4. At pH 8.0, FeH(3)SiO(4)(+) represented 18% of the total Fe(II) species. Model results show that when the concentration of silicate is 3 × 10(-5) M as in high nutrient low chlorophyll areas, FeH(3)SiO(4)(+) contributed at pH 8.0 by 4% increasing the rate to 11% at 1.4 × 10(-4) M. The effect of nutrients, especially silicate, must be considered in any further study in seawater media cultures and eutrophic oceanic areas.

Phenolic profile of Dunaliella tertiolecta growing under high levels of copper and iron.

The present study investigates the phenolic profile of exudates and extracts of the green algae Dunaliella tertiolecta, harvested in natural seawater in the absence (control) and in the presence of Cu(II) (315 and 790 nmol L(-1)) and Fe(III) (900 nmol L(-1)) in order to identify and quantify the phenolic compounds produced under metallic stress conditions. The presence of metal ions modifies the growth of cells and changes cell metabolism by producing phenolic compounds adapted to the solution. The use of reversed-phase high-performance liquid chromatography (RP-HPLC) permitted the identification of 14 phenolic constituents. The concentration and type of polyphenols detected in cell extracts and in solution are directly related with the metal and its concentration during growth cultures, achieving 1.4 times higher levels of polyphenols under 790 nmol Cu(II) L(-1) with respect to the control experiments. Microalga excretes polyphenols to be adapted to the environmental conditions. Gentisic acid, (+) catechin and (-) epicatechin, the most prominent phenolic compounds detected in the algae extracts, showed high antioxidant activity in inhibiting 1,1-diphenyl-2-picrylhydrazyl (DPPH) radicals. This potent activity may be related to its presence in cells and exudates in high concentrations.

Tracking the variable North Atlantic sink for atmospheric CO2.

The oceans are a major sink for atmospheric carbon dioxide (CO2). Historically, observations have been too sparse to allow accurate tracking of changes in rates of CO2 uptake over ocean basins, so little is known about how these vary. Here, we show observations indicating substantial variability in the CO2 uptake by the North Atlantic on time scales of a few years. Further, we use measurements from a coordinated network of instrumented commercial ships to define the annual flux into the North Atlantic, for the year 2005, to a precision of about 10%. This approach offers the prospect of accurately monitoring the changing ocean CO2 sink for those ocean basins that are well covered by shipping routes.

Oxidation of nanomolar levels of Fe(II) with oxygen in natural waters.

The oxidation of Fe(II) by molecular oxygen at nanomolar levels has been studied using a UV-Vis spectrophotometric system equipped with a long liquid waveguide capillary flow cell. The effect of pH (6.5-8.2), NaHCO3 (0.1-9 mM), temperature (3-35 degrees C), and salinity (0-36) on the oxidation of Fe(II) are presented. The first-order oxidation rates at nanomolar Fe(II) are higher than the values at micromolar levels at a pH below 7.5 and lower than the values at a higher pH. A kinetic model has been developed to consider the mechanism of the Fe(II) oxidation and the speciation of Fe(II) in seawater, the interactions between the major ions, and the oxidation rates of the different Fe(II) species. The concentration of Fe(II) is largely controlled by oxidation with O2 and O2.- but is also affected by hydrogen peroxide that may be both initially present and formed from the oxidation of Fe(II) by superoxide. The model has been applied to describe the effect of pH, concentration of NaHCO3, temperature, and salinity on the kinetics of Fe(II) oxidation. At a pH over 7.2, Fe(OH)2 is the most important contributing species to the apparent oxidation rate. At high levels of CO3(2-) and pH, the Fe(CO3)2(2-) species become important. At pH values below 7, the oxidation rate is controlled by Fe2+. Using the model, log k(i) values for the most kinetically active species (Fe2+, Fe(OH)+, Fe(OH)2, Fe(CO3), and Fe(CO3)2(2-)) are given that are valid over a wide range of temperature, salinity, and pH in natural waters. Model results showthatwhen H2O2 concentrations approach the Fe(II) concentrations used in this study, the oxidation of Fe(II) with H2O2 also needs to be considered.