RESUMEN
We present a cryogenic mass spectrometry protocol with the capability to detect peptides in the attomole dilution range from ice films. Our approach employs femtosecond laser pulses and implements neither substrate modification nor proton donor agents in the aqueous solution, known to facilitate analyte detection in mass spectrometry. In a systematic study, we investigated the impact of temperature, substrate composition, and irradiation wavelength (513 and 1026 nm) on the bradykinin signal onset. Our findings show that substrate choice and irradiation wavelength have a minor impact on signal intensity once the preparation protocol is optimized. However, if the temperature is increased from -140 to 0 °C, which is accompanied by ice film thinning, a somehow complex picture of analyte desorption and ionization is recognizable, which has not been described in the literature yet. Under cryogenic conditions (-140 °C), obtaining a signal is only possible from isolated sweet spots across the film. If the thin ice film is between -100 and -70 °C of temperature, these sweet spots appear more frequently. Ice sublimation triggered by temperatures above -70 °C leads to an intense and robust signal onset that could be maintained for several hours. In addition to the above findings, we notice that a vibrant fragmentation pattern produced is strikingly similar with both wavelengths. Our findings suggest that while following an optimized protocol, femtosecond mass spectrometry has excellent potential to analyze small organic molecules and peptides with a mass range of up to 2.5 kDa in aqueous solution without any matrix, as employed in matrix-assisted laser desorption/ionization (MALDI) or any substrate surface modification, found in surface-assisted laser desorption/ionization (SALDI).
Asunto(s)
Bradiquinina , Protones , Rayos Láser , Péptidos/química , Espectrometría de Masa por Láser de Matriz Asistida de Ionización Desorción/métodosRESUMEN
We introduce a liquid application method for time-resolved analyses (LAMA), an in situ mixing approach for serial crystallography. Picoliter-sized droplets are shot onto chip-mounted protein crystals, achieving near-full ligand occupancy within theoretical diffusion times. We demonstrate proof-of-principle binding of GlcNac to lysozyme, and resolve glucose binding and subsequent ring opening in a time-resolved study of xylose isomerase.
Asunto(s)
Cristalografía/métodos , Sincrotrones , Acetilglucosamina/química , Isomerasas Aldosa-Cetosa/química , Glucosa/química , Muramidasa/química , Prueba de Estudio ConceptualRESUMEN
Serial synchrotron crystallography (SSX) is an emerging technique for static and time-resolved protein structure determination. Using specifically patterned silicon chips for sample delivery, the `hit-and-return' (HARE) protocol allows for efficient time-resolved data collection. The specific pattern of the crystal wells in the HARE chip provides direct access to many discrete time points. HARE chips allow for optical excitation as well as on-chip mixing for reaction initiation, making a large number of protein systems amenable to time-resolved studies. Loading of protein microcrystals onto the HARE chip is streamlined by a novel vacuum loading platform that allows fine-tuning of suction strength while maintaining a humid environment to prevent crystal dehydration. To enable the widespread use of time-resolved serial synchrotron crystallography (TR-SSX), detailed technical descriptions of a set of accessories that facilitate TR-SSX workflows are provided.
RESUMEN
Recently, we introduced the liquid application method for time-resolved analyses (LAMA). The time-consuming cleaning cycles required for the substrate solution exchange and storage of the sensitive droplet-dispenser nozzles present practical challenges. In this work, a dispenser cleaning system for the semi-automated cleaning of the piezo-actuator-driven picolitre-droplet dispensers required for LAMA is introduced to streamline typical workflows.
RESUMEN
We introduce the spitrobot, a protein crystal plunger, enabling reaction quenching via cryo-trapping with a time-resolution in the millisecond range. Protein crystals are mounted on canonical micromeshes on an electropneumatic piston, where the crystals are kept in a humidity and temperature-controlled environment, then reactions are initiated via the liquid application method (LAMA) and plunging into liquid nitrogen is initiated after an electronically set delay time to cryo-trap intermediate states. High-magnification images are automatically recorded before and after droplet deposition, prior to plunging. The SPINE-standard sample holder is directly plunged into a storage puck, enabling compatibility with high-throughput infrastructure. Here we demonstrate binding of glucose and 2,3-butanediol in microcrystals of xylose isomerase, and of avibactam and ampicillin in microcrystals of the extended spectrum beta-lactamase CTX-M-14. We also trap reaction intermediates and conformational changes in macroscopic crystals of tryptophan synthase to demonstrate that the spitrobot enables insight into catalytic events.
Asunto(s)
Proteínas , Cristalografía/métodos , Proteínas/química , Temperatura , Humedad , Cristalografía por Rayos XRESUMEN
Fixed-target serial crystallography has become an important method for the study of protein structure and dynamics at synchrotrons and X-ray free-electron lasers. However, sample homogeneity, consumption and the physical stress on samples remain major challenges for these high-throughput experiments, which depend on high-quality protein microcrystals. The batch crystallization procedures that are typically applied require time- and sample-intensive screening and optimization. Here, a simple protein crystallization method inside the features of the HARE serial crystallography chips is reported that circumvents batch crystallization and allows the direct transfer of canonical vapor-diffusion conditions to in-chip crystallization. Based on conventional hanging-drop vapor-diffusion experiments, the crystallization solution is distributed into the wells of the HARE chip and equilibrated against a reservoir with mother liquor. Using this simple method, high-quality microcrystals were generated with sufficient density for the structure determination of four different proteins. A new protein variant was crystallized using the protein concentrations encountered during canonical crystallization experiments, enabling structure determination from â¼55â µg of protein. Additionally, structure determination from intracellular crystals grown in insect cells cultured directly in the features of the HARE chips is demonstrated. In cellulo crystallization represents a comparatively unexplored space in crystallization, especially for proteins that are resistant to crystallization using conventional techniques, and eliminates any need for laborious protein purification. This in-chip technique avoids harvesting the sensitive crystals or any further physical handling of the crystal-containing cells. These proof-of-principle experiments indicate the potential of this method to become a simple alternative to batch crystallization approaches and also as a convenient extension to canonical crystallization screens.
Asunto(s)
Cristalografía por Rayos X/métodos , Proteínas/química , Prueba de Estudio ConceptualRESUMEN
Two different nonthermal plasma reactors at atmospheric pressure were assessed for the removal of organic micropollutants (atrazine, chlorfenvinfos, 2,4-dibromophenol, and lindane) from aqueous solutions (1-5 mg L(-1)) at laboratory scale. Both devices were dielectric barrier discharge (DBD) reactors; one was a conventional batch reactor (R1) and the other a coaxial thin-falling-water-film reactor (R2). A first-order degradation kinetics was proposed for both experiments. The kinetic constants (k) were slightly faster in R1 (0.534 min(-1) for atrazine; 0.567 min(-1) for chlorfenvinfos; 0.802 min(-1) for 2,4-dibromophenol; 0.389 min(-1) for lindane) than in R2 (0.104 min(-1) for atrazine; 0.523 min(-1) for chlorfenvinfos; 0.273 min(-1) for 2,4-dibromophenol; 0.294 min(-1) for lindane). However, energy efficiencies were about one order of magnitude higher in R2 (89 mg kW(-1) h(-1) for atrazine; 447 mg kW(-1) h(-1) for c hlorfenvinfos; 47 mg kW(-1) h(-1) for 2,4-dibromophenol; 50 mg kW(-1) h(-1) for lindane) than in R1. Degradation by -products of all four compounds were identified in R1. As expected, when the plasma treatment (R1) was applied to industrial wastewater spiked with atrazine or lindane, micropollutant removal was also achieved, although at a lower rate than with aqueous solutions (k = 0.117 min(-1) for atrazine; k = 0.061 min(-1) for lindane).
Asunto(s)
Eliminación de Residuos Líquidos/métodos , Contaminantes Químicos del Agua/química , Atrazina/química , Clorfenvinfos/química , Electroquímica , Hexaclorociclohexano/química , Residuos Industriales , Fenoles/químicaRESUMEN
Two different nonthermal plasma reactors at atmospheric pressure were assessed for the first time for cyanide removal (1 mg L(-1)) from aqueous solutions (0.025 M NaHCO(3)/NaOH buffer, pH 11) at laboratory scale. Both devices were dielectric barrier discharge (DBD) reactors; one of them was a conventional batch reactor (R1) and the other one was a coaxial thin falling water film reactor (R2). A first-order degradation kinetics was proposed for both experiments, obtaining k(R1) = 0.5553 min(-1) and k(R2) = 0.7482 min(-1). The coaxial reactor R2 yielded a removal of 99% within only 3 min. Energy efficiencies (G) were calculated, yielding 1.74 mg kW(-1) h(-1) for R1 and 127.9 mg kW(-1) h(-1) for R2. When the treatment was applied to industrial wastewaters, cyanide elimination was confirmed, although at a lower rate (above 92% removal in 90 min with R2). Therefore, plasma reactors could be a relevant alternative to established advanced oxidation techniques (UV, H(2)O(2), ozonation, etc.) for the removal of cyanide from wastewaters with low organic loads or even drinking waters.