RESUMEN
In this Letter, an SiPM with a dedicated cooling system suitable for receiving ultra-low-power solar-blind wavelengths is reported. This is designed to decrease the temperature of the detector from 21°C to -10°C, and the corresponding dark count rate (DCR) is reduced by approximately 10â dB. A 275â nm optical wireless communication (OWC) system is established using on-off-keying (OOK) modulation. Transmission rates ranging from 100â kbit/s to 2â Mbit/s are demonstrated with this cooled SiPM. The received power is as low as 30â pW (corresponding to 41.5 photons per bit) at a data rate of 1â Mbit/s and a bit error rate of 2.4 × 10-3.
RESUMEN
We present, to our knowledge for the first time, a 100-km Brillouin Optical Frequency-Domain Analysis (BOFDA) employing a 200-km fiber loop. Compared to our previous publication, enhanced sensor length, sensor accuracy and spatial resolution are presented. The performance improvements are achieved by applying distributed Raman amplification (DRA) and a digital high-pass filter. We report on temperature measurements over sensing distances of 75 km and 100 km both with a 12.5-m spatial resolution. Temperature changes of 5 ° C have been measured along 75 km sensing fiber. A temperature change of 30 ° C has been detected at 99.5 km.
RESUMEN
We report, to our knowledge, for the first time on humidity-induced Brillouin frequency shifts in perfluorinated graded index polymer optical fibers. A linear relation between Brillouin frequency shift and humidity was observed. Furthermore, the humidity coefficient of the Brillouin frequency shift is demonstrated to be a function of temperature (-107 to -64 kHz/%r.h. or -426 to -49 kHz m3/g in the range of 20 to 60 °C). An analytical description proves temperature and humidity as two mutually independent effects on the Brillouin frequency shift.
RESUMEN
We demonstrate (and are the first to do so) 63 km Brillouin Optical Frequency-Domain Analysis (BOFDA) for temperature and strain monitoring using a 100 km fiber loop. The use of BOFDA for long-range applications can be considered a novel approach, as previous investigations focused on the utilization of Brillouin Optical Time-Domain Reflectometry and Analysis (BOTDR and BOTDA, respectively). At 51.7 km, a 100 m hotspot (37 ∘ C) was detected without using distributed Raman amplification or image processing.
RESUMEN
In this paper perfluorinated graded-index polymer optical fibers are characterized with respect to the influence of relative humidity changes on spectral transmission absorption and Rayleigh backscattering. The hygroscopic and thermal expansion coefficient of the fiber are determined to be C H E = (7.4 ± 0.1) · 10 - 6 %r.h.-1 and C T E = (22.7 ± 0.3) · 10 - 6 K-1, respectively. The influence of humidity on the Brillouin backscattering power and linewidth are presented for the first time to our knowledge. The Brillouin backscattering power at a pump wavelength of 1319 nm is affected by temperature and humidity. The Brillouin linewidth is observed to be a function of temperature but not of humidity. The strain coefficient of the BFS is determined to be C S = (-146.5 ± 0.9) MHz/% for a wavelength of 1319 nm within a strain range from 0.1% to 1.5%. The obtained results demonstrate that the humidity-induced Brillouin frequency shift is predominantly caused by the swelling of the fiber over-cladding that leads to fiber straining.