A comprehensive review direct methods to overcome the limitations of gas injection during the EOR process.

Among the Enhanced Oil Recovery (EOR) methods, gas-based EOR methods are very popular all over the world. The gas injection has a high ability to increase microscopic sweep efficiency and can increase production efficiency well. However, it should be noted that in addition to all the advantages of these methods, they have disadvantages such as damage due to asphaltene deposition, unfavorable mobility ratio, and reduced efficiency of macroscopic displacement. In this paper, the gas injection process and its challenges were investigated. Then the overcoming methods of these challenges were investigated. To inhibit asphaltene deposition during gas injection, the use of nanoparticles was proposed, which were examined in two categories: liquid-soluble and gas-soluble, and the limitations of each were examined. Various methods were used to overcome the problem of unfavorable mobility ratio and their advantages and disadvantages were discussed. Gas-phase modification has the potential to reduce the challenges and limitations of direct gas injection and significantly increase recovery efficiency. In the first part, the introduction of gas injection and the enhanced oil recovery mechanisms during gas injection were mentioned. In the next part, the challenges of gas injection, which included unfavorable mobility ratio and asphaltene deposition, were investigated. In the third step, gas-phase mobility control methods investigate, emphasizing thickeners, thickening mechanisms, and field applications of mobility control methods. In the last part, to investigate the effect of nanoparticles on asphaltene deposition and reducing the minimum miscible pressure in two main subsets: 1- use of nanoparticles indirectly to prevent asphaltene deposition and reduce surface tension and 2- use of nanoparticles as a direct asphaltene inhibitor and Reduce MMP of the gas phase in crude oil was investigated.

Effect of chemicals on the phase and viscosity behavior of water in oil emulsions.

Due to population growth, the need for energy, especially fossil fuels, is increased every year. Since the costs of exploring new reservoirs and drilling new wells are very high, most reservoirs have passed their first and second periods of life, and it is necessary to use EOR methods. Water-based enhanced oil recovery (EOR) methods are one of the popular methods in this field. In this method, due to the possibility of emulsion formation is high, and by creating a stable emulsion, viscosity and mobility improved. In this study, the parameters affecting the stability and viscosity of the emulsion have been investigated step by step. In the first step, 50% (v/v) of water has been selected as the best water cut. The type of salt and its best concentration was evaluated in the second step by measuring the average droplets size. The third step investigated the effect of SiO2 nanoparticles and surfactant (span80) on emulsion stability and viscosity. According to the results, the best amount of water cut was 50% due to the maximum viscosity. In salts the yield was as follows: MgCl2 > CaCl2 > MgSO4 > Na2SO4 > NaCl. The best yield was related to MgCl2 at a concentration of 10,000 ppm. Finally, it was shown that the synergy of nanoparticles and surfactants resulted in higher stability and viscosity than in the case where each was used alone. It should be noted that the optimal concentration of nanoparticles is equal to 0.1% (w/w), and the optimal concentration of surfactant is equal to 200 ppm. In general, a stable state was obtained in 50% water-cut with MgCl2 salt at a concentration of 10,000 ppm and in the presence of SiO2 nanoparticles at a concentration of 0.1% and span 80 surfactants at a concentration of 200 ppm. The results obtained from this study provide important insights for optimal selection of the water-based EOR operation parameters. Viscosity showed a similar trend with stability and droplet size. As the average particle size decreased (or stability increased), the emulsion viscosity increased.

Dependence of emittance of the He+ beam extracted from a Penning ion source on the design of the source, a Particle-In-Cell simulation.

The dependence of the emittance of He+ beam extracted from a cold cathode Penning ion source on source discharge voltage, anode length, and cathode to anode distance was studied. The 2D3V particle-in-cell Monte Carlo simulation technique was utilized to perform the analysis. Different dimensions for components of the ion source such as anode length and cathode to anode distance were considered. The increase in the cathode to anode distance led to a reduction in rms emittance, almost independent of discharge voltage. This study indicated that the rms emittance slightly improves on increasing the anode length.

Severe valvular toxicity and pericarditis early after radiation therapy in a patient treated for Hodgkin's lymphoma.

Hodgkin's disease can be cured in most cases by radiotherapy. However, it can increase the risk of cardiotoxicity. Here, we report a patient with Hodgkin's disease and superior vena cava syndrome who was treated with chemotherapy in combination with radiotherapy. Four months after the initiation of this therapy, she developed progressive dyspnea. Pleural and pericardial effusion, severe mitral regurgitation, moderate aortic insufficiency, and mild tricuspid regurgitation were detected in echocardiography, which suggested heart failure. The patient was then treated with intrapericardial drainage and received dopamine and diuretics for congestive heart failure; she responded well to this treatment and was discharged in good condition. After high-dose mediastinal radiation, cardiologic screening is recommended in order to identify patients with radiation-induced heart disease and to assess their need for treatment and follow-up.

Cytologic phenotypes of B-cell acute lymphoblastic leukemia-a single center study.

Acute lymphoblastic leukemia (ALL) is a malignant disorder of lymphoid precursor cells, which could be classified according to morphological and cytochemical methods as well as immunophenotyping. Twenty patients with ALL, who had been referred to the Children's Medical Center Hospital, during the year 2007, were enrolled in this study in order to evaluate the morphologic and immunophenotypic profile of these patients. Cytologic analysis of blood and bone marrow samples revealed that the frequency of ALL-L1 was 70%, followed by ALL-L2 and ALL-L3. The onset age of the patients with ALL-L1 was significantly lower than the patients with L2/L3. Severe anemia was significantly detected more in L1 group. Flow cytometic study of bone marrow showed that 10 cases had Pre-B1 ALL and 7 cases had Pre-B2 ALL, while three cases had Pro-B ALL. Comparisons of the characteristics and clinical manifestations among these groups did not show any appreciable difference. There were an increase percentage of CD20+ cells and a decrease CD10+ cells in pre-B2 group in comparison with pre-B1 group. Fifteen patients were in standard risk and five were in high risk. Although standard risk patients were more common in the group of pre-B1, this was not significant. Our results confirm the previous reports indicating heterogeneity of ALL. Immunophenotyping is not the only diagnostic test of importance, while morphological assessment still can be used in the diagnosis and classification of the disease.