RESUMEN
We show that the onset of steady-state superradiance in a bad cavity laser is preceded by a dissipative phase transition between two distinct phases of steady-state subradiance. The transition is marked by a nonanalytic behavior of the cavity output power and the mean atomic inversion, as well as a discontinuity in the variance of the collective atomic inversion. In particular, for repump rates below a critical value, the cavity output power is strongly suppressed and does not increase with the atom number, while it scales linearly with atom number above this value. Remarkably, we find that the atoms are in a macroscopically entangled steady state near the critical region with a vanishing fraction of unentangled atoms in the large atom number limit.
RESUMEN
We propose a new type of superradiant laser based on a hot atomic beam traversing an optical cavity. We show that the theoretical minimum linewidth and maximum power are competitive with the best ultracoherent clock lasers. Also, our system operates naturally in continuous wave mode, which has been elusive for superradiant lasers so far. Unlike existing ultracoherent lasers, our design is simple and rugged. This makes it a candidate for the first widely accessible ultracoherent laser, as well as the first to realize sought-after applications of ultracoherent lasers in challenging environments.
RESUMEN
We propose a scheme for continuously measuring the evolving quantum phase of a collective spin composed of N pseudospins. Quantum nondemolition measurements of a lossy cavity mode interacting with an atomic ensemble are used to directly probe the phase of the collective atomic spin without converting it into a population difference. Unlike traditional Ramsey measurement sequences, our scheme allows for real-time tracking of time-varying signals. As a bonus, spin-squeezed states develop naturally, providing real-time phase estimation significantly more precise than the standard quantum limit of ΔÏ_{SQL}=1/sqrt[N] rad.
RESUMEN
We experimentally study electromagnetically induced transparency cooling of the drumhead modes of planar two-dimensional arrays with up to N≈190 Be^{+} ions stored in a Penning trap. Substantial sub-Doppler cooling is observed for all N drumhead modes. Quantitative measurements for the center-of-mass mode show near ground-state cooling with motional quantum numbers of n[over ¯]=0.3±0.2 obtained within 200 µs. The measured cooling rate is faster than that predicted by single particle theory, consistent with a quantum many-body calculation. For the lower frequency drumhead modes, quantitative temperature measurements are limited by frequency instabilities, but near ground-state cooling of the full bandwidth is strongly suggested. This advance will greatly improve the performance of large trapped ion crystals in quantum information and metrology applications.
RESUMEN
Two-dimensional crystals of ions stored in Penning traps are a leading platform for quantum simulation and sensing experiments. For small amplitudes, the out-of-plane motion of such crystals can be described by a discrete set of normal modes called the drumhead modes, which can be used to implement a range of quantum information protocols. However, experimental observations of crystals with Doppler-cooled and even near-ground-state-cooled drumhead modes reveal an unresolved drumhead-mode spectrum. In this work, we establish in-plane thermal fluctuations in ion positions as a major contributor to the broadening of the drumhead-mode spectrum. In the process, we demonstrate how the confining magnetic field leads to unconventional in-plane normal modes, whose average potential and kinetic energies are not equal. This property, in turn, has implications for the sampling procedure required to choose the in-plane initial conditions for molecular-dynamics simulations. For current operating conditions of the NIST Penning trap, our study suggests that the two-dimensional crystals produced in this trap undergo in-plane potential-energy fluctuations of the order of 10mK. Our study therefore motivates the need for designing improved techniques to cool the in-plane degrees of freedom.