MoO(3-x) nanowire arrays as stable and high-capacity anodes for lithium ion batteries.

In this study, vertical nanowire arrays of MoO(3-x) grown on metallic substrates with diameters of ~90 nm show high-capacity retention of ~630 mAhg(-1) for up to 20 cycles at 50 mAg(-1) current density. Particularly, they exhibit a capacity retention of ~500 mAhg(-1) in the voltage window of 0.7-0.1 V, much higher than the theoretical capacity of graphite. In addition, 10 nm Si-coated MoO(3-x) nanowire arrays have shown a capacity retention of ~780 mAhg(-1), indicating that hybrid materials are the next generation materials for lithium ion batteries.

Mesoporous TiO2 coating on carbon-sulfur cathode for high capacity Li-sulfur battery.

In this paper, a meso-porous TiO2 (titania) coating is shown to effectively protect a carbon-sulfur composite cathode from polysulfide dissolution. The cathode consisted of a sulfur impregnated carbon support coated with a few microns thick mesoporous titania layer. The carbon-sulfur cathode is made using activated carbon powder (ACP) derived from biomass. The mesoporous titania coated carbon-sulfur cathodes exhibit a retention capacity after 100 cycles at C/3 rate (433 mA g -1) and stabilized at a capacity around 980 mA h g-1. The electrochemical impedance spectroscopy (EIS) of the sulfur cathodes suggests that the charge transfer resistance at the anode, (R act) is stable for the titania coated sulfur electrode in comparison to a continuous increase in R act for the uncoated electrode implying mitigation of polysulfide shuttling for the protected cathode. Stability in the cyclic voltammetry (CV) data for the first 5 cycles further confirms the polysulfide containment in the titania coated cathode while the uncoated sulfur electrode shows significant irreversibility in the CV with considerable shifting of the voltage peak positions. Raman spectroscopy and X-ray photoelectron spectroscopy (XPS) studies confirm the adsorption of soluble polysulfides by mesoporous titania.

The synthesis and fabrication of one-dimensional nanoscale heterojunctions.

There are a variety of methods for synthesizing or fabricating one-dimensional (1D) nanostructures containing heterojunctions between different materials. Here we review recent developments in the synthesis and fabrication of heterojunctions formed between different materials within the same 1D nanostructure or between different 1D nanostructures composed of different materials. Structures containing 1D nanoscale heterojunctions exhibit interesting chemistry as well as size, shape, and material-dependent properties that are unique when compared to single-component materials. This leads to new or enhanced properties or multifunctionality useful for a variety of applications in electronics, photonics, catalysis, and sensing, for example. This review separates the methods into vapor-phase synthesis, solution-phase synthesis, template-based synthesis, and other approaches, such as lithography, electrospinning, and assembly. These methods are used to form a variety of heterojunctions, including segmented, core/shell, branched, or crossed, from different combinations of semiconductor, metal, carbon, and polymeric materials.

Rapid effects of diesel exhaust particulate extracts on intracellular signaling in human endothelial cells.

Inhalation of ultrafine particulate matter (PM) in air pollution increases cardiovascular mortality by passing into systemic circulation and possibly affecting endothelial cell (EC) function. This study identified the chemical constituents, including polycyclic aromatic hydrocarbons (PAHs), in diesel exhaust particulate extracts (DEPEs) prepared from a truck run at different speeds and engine loads. The short-term effects of DEPEs alone or in combination with estradiol (E(2)) on MAPK (ERK1/2), AKT, and eNOS activation and nitric oxide (NO) production in human umbilical vein EC (HUVEC) were evaluated. Notably, DEPE from a truck run under increasing loads (L) stimulated phosphorylation of MAPK, AKT, and eNOS whereas DEPE from the truck run at increasing speeds (S) did not affect MAPK alone, but inhibited E(2)-induced MAPK and eNOS phosphorylation. Higher PAH concentrations in the DEPE L versus DEPE S samples correlate with the observed differences in cellular activities. Like E(2), DEPEs rapidly increased NO with the DEPE L sample acting additively with E(2) and then inhibiting E(2)-induced NO with longer treatment time. Like E(2), DEPEs increased trans-endothelial electrical resistance (TEER) across a monolayer of HUVEC. These data are the first characterization of rapid effects of DEPE in human EC and may indicate mechanisms for diesel exhaust in vascular function.

Synergy between graphene and Au nanoparticles (heterojunction) towards quenching, improving Raman signal, and UV light sensing.

Here, we developed a simple method for obtaining a heterojunction composed of graphene (G) and surfactant-coated Au nanoparticles (NPs) to measure film conductivity and surface enhanced Raman scattering (SERS). Monolayer G is obtained by chemical vapor deposition (CVD) and transferred via poly(methyl methacrylate) (PMMA) to microfabricated Au electrodes, glass, and silicon. Post-synthesis treatments of G with PMMA and ozone (O3) showed 1 and 6 orders of magnitude decrease in film conductivity, respectively. The heterojunction formation with Au NPs had no major effect on G conductivity. In this work is demonstrated that G quenches more than 90% of the combined photoluminescence and fluorescence of Au NPs and Rhodamine B (RhB), respectively. Signal quenching permitted quantitative analysis of SERS of RhB on various substrates including as-transferred graphene, oxidized graphene (OG), and the heterojunction. While G is mainly responsible for quenching photoluminescence and fluorescence, ∼3 orders of magnitude increase SERS activity for RhB was accomplished by the heterojunction. Finally, we wanted to correlate changes in film current during UV light sensing experiments. We found striking differences in the sensing profiles at different UV energies.

Hybrid tin oxide nanowires as stable and high capacity anodes for Li-ion batteries.

In this report, we present a simple and generic concept involving metal nanoclusters supported on metal oxide nanowires as stable and high capacity anode materials for Li-ion batteries. Specifically, SnO(2) nanowires covered with Sn nanoclusters exhibited an exceptional capacity of >800 mAhg(-1) over hundred cycles with a low capacity fading of less than 1% per cycle. Post lithiation analyses after 100 cycles show little morphological degradation of the hybrid nanowires. The observed, enhanced stability with high capacity retention is explained with the following: (a) the spacing between Sn nanoclusters on SnO(2) nanowires allowed the volume expansion during Li alloying and dealloying; (b) high available surface area of Sn nanoclusters for Li alloying and dealloying; and (c) the presence of Sn nanoclusters on SnO(2) allowed reversible reaction between Sn and Li(2)O to produce both Sn and SnO phases.

Morphological, structural, and chemical effects in response of novel carbide derived carbon sensor to NH3, N2O, and air.

The response of two carbide derived carbons (CDCs) films to NH(3), N(2)O, and room air is investigated by four probe resistance at room temperature and pressures up to 760 Torr. The two CDC films were synthesized at 600 (CDC-600) and 1000 degrees C (CDC-1000) to vary the carbon morphology from completely amorphous to more ordered, and determine the role of structure, surface area, and porosity on sensor response. Sensor response time followed kinetic diameter and indicated a more ordered carbon structure slowed response due to increased tortuosity caused by the formation of graphitic layers at the particle fringe. Steady state sensor response was greater for the less-ordered material, despite its decreased surface area, decreased micropore volume, and less favorable surface chemistry, suggesting carbon structure is a stronger predictor of sensor response than surface chemistry. The lack of correlation between adsorption of the probe gases and sensor response suggests chemical interaction (charge transfer) drive sensor response within the material; N(2)O response, in particular, did not follow simple adsorption behavior. Based on Raman and FTIR characterization, carbon morphology (disorder) appeared to be the determining factor in overall sensor response, likely due to increased charge transfer between gases and carbon defects of amorphous or disordered regions. The response of the amorphous CDC-600 film to NH(3) was 45% without prior oxidation, showing amorphous CDCs have promise as chemical sensors without additional pretreatment common to other carbon sensors.

Preferential growth of single-walled carbon nanotubes with metallic conductivity.

Single-walled carbon nanotubes can be classified as either metallic or semiconducting, depending on their conductivity, which is determined by their chirality. Existing synthesis methods cannot controllably grow nanotubes with a specific type of conductivity. By varying the noble gas ambient during thermal annealing of the catalyst, and in combination with oxidative and reductive species, we altered the fraction of tubes with metallic conductivity from one-third of the population to a maximum of 91%. In situ transmission electron microscopy studies reveal that this variation leads to differences in both morphology and coarsening behavior of the nanoparticles that we used to nucleate nanotubes. These catalyst rearrangements demonstrate that there are correlations between catalyst morphology and resulting nanotube electronic structure and indicate that chiral-selective growth may be possible.

Charge transfer equilibria between diamond and an aqueous oxygen electrochemical redox couple.

Undoped, high-quality diamond is, under almost all circumstances, one of the best insulators known. However, diamond covered with chemically bound hydrogen shows a pronounced conductivity when exposed to air. This conductivity arises from positive-charge carriers (holes) and is confined to a narrow near-surface region. Although several explanations have been proposed, none has received wide acceptance, and the mechanism remains controversial. Here, we report the interactions of hydrogen-terminated, macroscopic diamonds and diamond powders with aqueous solutions of controlled pH and oxygen concentration. We show that electrons transfer between the diamond and an electrochemical reduction/oxidation couple involving oxygen. This charge transfer is responsible for the surface conductivity and also influences contact angles and zeta potentials. The effect is not confined to diamond and may play a previously unrecognized role in other disparate systems.

Estradiol and dihydrotestosterone regulate endothelial cell barrier function after hypergravity-induced alterations in MAPK activity.

Postflight orthostatic intolerance (POI) was reported to be higher in female than male astronauts and may result from sex-dependent differences in endothelial cell (EC) barrier permeability. Here the effect of 17beta-estradiol (E(2)) and dihydrotestosterone (DHT) on the expression of the tight junction protein occludin, EC barrier function, and MAPK activation over time was tested after subjecting human umbilical vein EC (HUVEC) to brief hypergravity identical to that experienced by astronauts during liftoff (LO) into space. After LO hypergravity, HUVEC showed a time-dependent decrease in occludin correlating with an increase in paracellular permeability and a decrease in transendothelial electrical resistance, indicating a decrease in EC barrier function. LO hypergravity inhibited MAPK activation, which remained suppressed 4 h after LO. Inhibition of MAPK activation correlated with decreased phosphotyrosine occludin, decreased cytochrome-c oxidase activity, and increased paracellular permeability, suggesting a mechanism by which LO hypergravity decreased EC barrier function. Time-dependent differences in MAPK activation, decreased occludin, and EC barrier function between HUVEC treated with E(2) vs. DHT were observed. HUVEC showed delayed activation of MAPK with DHT, i.e., 4 h rather than 2 h for E(2), which correlated with decreased paracellular permeability and the observed sex differences in POI in astronauts. These data temporally separate E(2) and DHT effects in HUVEC and provide evidence for the possible protective roles of sex steroids on EC function after brief exposure to low hypergravity.

Oriented nanomaterial air bridges formed from suspended polymer-composite nanofibers.

In a two-step method, carbon nanotubes, inorganic nanowires, or graphene sheets are connected between two anchor points to form nanomaterial air bridges. First, a recently developed method of forming directionally oriented polymer nanofibers by hand-application is used to form suspended composite polymer-nanomaterial fibers. Then, the polymer is sacrificed by thermally induced depolymerization and vaporization, leaving air bridges of the various materials. Composite fibers and bundles of nanotubes as thin as 10 nm that span 1 microm gaps have been formed by this method. Comparable bridges are observed by electrospinning solutions of the same nanomaterial-polymer composites onto micrometer-scale corrugated surfaces. This method for assembling nanomaterial air-bridges provides a convenient way to suspend nanomaterials for mechanical and other property determinations, and for subsequent device fabrication built up from the suspended nanosubstrates.

Synthesis of gold nanorod/single-wall carbon nanotube heterojunctions directly on surfaces.

This contribution describes the synthesis of gold nanorod (Au NR)/single-wall carbon nanotube (SWCNT) heterojunctions assembled directly on Si/SiOx substrates. SWCNTs are attached to amine-functionalized Si/SiOx substrates, and Au monolayer-protected clusters (MPCs) are adsorbed to the surface of SWCNTs through hydrophobic interactions. Seed-mediated reduction of HAuCl4 with ascorbic acid in the presence of cetyltrimethylammonium bromide (CTAB) onto the Au MPCs leads to the growth of larger Au nanostructures directly on the SWCNTs. Au NRs account for 19% of the nanostructures, some of which are attached directly to the sidewall and some at the ends of the SWCNTs. Raman spectroscopic measurements of SWCNTs before and after growth of the Au nanostructures reveal that the presence of Au leads to an approximately 50-fold enhancement of the Raman scattering signal. Combining 1D nanostructures of different materials (Au and carbon in this example) is of fundamental interest and may find use in nanoelectronics, chemical sensing, electrochemical, and spectroscopy applications.