Plasticizing effect of Apis mellifera honey on whey protein isolate films.

The aims of this study were to analyze the plasticizing effect of Apis mellifera honey on the mechanical, physicochemical and optical properties of whey protein isolate (WPI) films and to compare the results collected with the plasticizing effect of glycerol on WPI-films. Response surface was applied to optimize the amounts of WPI and glycerol in order to obtain films with higher tensile strength (TS), moderate elongation, and lower water vapor permeability so that they could be used as reference films. Honey was added at different concentrations (60%, 80%, and 100%) of g honey/100 g WPI, as a plasticizer to the WPI-films. In comparison to glycerol-plasticized films, an increase in the percentage of honey produced a reduction of 20 ± 10 to 48 ± 0.5% of TS, a 66 ± 0.5% lower in Young's modulus (WPI-films with 100% honey), and an increase of 186 ± 11% in elongation at break in the WPI-films with 100% honey. Honey-plasticized WPI-films were from 29 ± 11 to 43 ± 3% less permeable to water vapor than glycerol-plasticized WPI films. The mechanical characteristics of the 80% honey formulation did not differ significantly from those of the reference film (p > 0.05). Findings from this study indicate that honey has great potential as a plasticizer in WPI-films.

Animal fat replacement by vegetable oils in formulations of breads with flour mixes.

The improvement of fatty acids (FA) profile of bread made with bovine fat (BF) and a mixture of flours completely replacing fat with canola oil (CO), or olive oil (OO) was evaluated. Technological and sensory characteristics and overall acceptability of the fortified breads were also studied. The results showed a decrease in saturated FA and a relative increase in monounsaturated and polyunsaturated FA compared to bread made with BF. Regarding CO, this caused the higher increase in n3 FA. This effect was maximized in bread made from the mixture of wheat flour (WF) + flaxseed flour (FF) + soybean flour (SF). OO caused a rise of n9 and n6 FA, mainly in bread made with WF + FF + wheat bran (WB). The breads with WF + FF + SF + CO and WF + FF + WB + OO presented higher specific volume, softer crumb and colour similar to those from base formulations. Furthermore, they had a very good sensory acceptance.

Improvement of fatty acid profile and studio of rheological and technological characteristics in breads supplemented with flaxseed, soybean, and wheat bran flours.

Functional breads constitute an interesting alternative as vehicle of new essential fatty acids sources. The aim of this study was to improve the fatty acids (FA) profile of bakery products, producing breads with low saturated fatty acid (SFA) content and with high polyunsaturated fatty acid (PUFA) content, through partial substitution of wheat flour by other ingredients (soy flour, flax flour, and wheat bran) and to analyze the effect of this change on the technological, rheological, and sensorial characteristics of breads. Flaxseed flour (FF), soybeans flour (SF), or wheat bran (WB) was used to replace 50, 100, and 150 g kg(-1) of wheat flour (WF) in breads. FF or SF produced a decrease in monounsaturated and SFA and an increase of PUFA in these breads. Furthermore, breads replaced with FF presented considerable increase in the content of n3 FA, while, SF or WB contributed to rise of linoleic and oleic FA, respectively. The substitution percentage increase of FF, SF, or WB to formulation produced changes in the colour, rheological, textural, and technological characteristics of breads. This replacement resulted in improved lipid profile, being breads with 50 g kg(-1) SF, the better acceptance, baking features, and enhanced fatty acid profile.