SARS-CoV-2 RNA is enriched by orders of magnitude in primary settled solids relative to liquid wastewater at publicly owned treatment works.

Wastewater-based epidemiology has gained attention throughout the world for detection of SARS-CoV-2 RNA in wastewater to supplement clinical testing. Raw wastewater consists of small particles, or solids, suspended in liquid. Methods have been developed to measure SARS-CoV-2 RNA in the liquid and the solid fraction of wastewater, with some studies reporting higher concentrations in the solid fraction. To investigate this relationship further, six laboratories collaborated to conduct a study across five publicly owned treatment works (POTWs) where both primary settled solids obtained from primary clarifiers and raw wastewater influent samples were collected and quantified for SARS-CoV-2 RNA. Settled solids and influent samples were processed by participating laboratories using their respective methods and retrospectively paired based on date of collection. SARS-CoV-2 RNA concentrations, on a mass equivalent basis, were higher in settled solids than in influent by approximately three orders of magnitude. Concentrations in matched settled solids and influent were positively and significantly correlated at all five POTWs. RNA concentrations in both settled solids and influent were correlated to COVID-19 incidence rates in the sewersheds and thus representative of disease occurrence; the settled solids methods appeared to produce a comparable relationship between SARS-CoV-2 RNA concentration measurements and incidence rates across all POTWs. Settled solids and influent methods showed comparable sensitivity, N gene detection frequency, and calculated empirical incidence rate lower limits. Analysis of settled solids for SARS-CoV-2 RNA has the advantage of using less sample volume to achieve similar sensitivity to influent methods.

A kinetic isotope effect and isotope exchange study of the nonenzymatic and the equine serum butyrylcholinesterase-catalyzed thioester hydrolysis.

Formylthiocholine (FTC) was synthesized and found to be a substrate for nonenzymatic and butyrylcholinesterase (BChE)-catalyzed hydrolysis. Solvent (D2O) and secondary formyl-H kinetic isotope effects (KIEs) were measured by an NMR spectroscopic method. The solvent (D2O) KIEs are (D2O)k = 0.20 in 200 mM HCl, (D2O)k = 0.81 in 50 mM HCl, and (D2O)k = 4.2 in pure water. The formyl-H KIEs are (D)k = 0.80 in 200 mM HCl, (D)k = 0.77 in 50 mM HCl, (D)k = 0.75 in pure water, (D)k = 0.88 in 50 mM NaOH, and (D)(V/K) = 0.89 in the BChE-catalyzed hydrolysis in MES buffer at pH 6.8. Positional isotope exchange experiments showed no detectable exchange of (18)O into the carbonyl oxygen of FTC or the product, formate, under any of the above conditions. Solvent nucleophile-O KIEs were determined to be (18)k = 0.9917 under neutral conditions, (18)k = 1.0290 (water nucleophile) or (18)k = 0.989 (hydroxide nucleophile) under alkaline conditions, and (18)(V/K) = 0.9925 for BChE catalysis. The acidic, neutral, and BChE-catalyzed reactions are explained in terms of a stepwise mechanism with tetrahedral intermediates. Evidence for a change to a direct displacement mechanism under alkaline conditions is presented.