The different adsorption-degradation behaviors of SARS-CoV-2 by bioactive chemicals in wastewater: The suppression kinetics and their implications for wastewater-based epidemiology.

Wastewater-Based Epidemiology (WBE) is widely used to monitor the progression of SARS-CoV-2 pandemic. While there is a clear correlation between the number of COVID patients in a sewershed and the viral load in the wastewater, there is notable variability across different treatment plants. In particular, some facilities consistently exhibit higher viral content per diagnosed patient, implying a potential underestimation of the number of COVID patients, while others show a low viral load per diagnosed case, indicating potential attenuation of genetic material from the sewershed. In this study, we investigated the impact of nonylphenol ethoxylate (NPHE), linear alkylbenzene sulfonic acid (LABS), bisoctyl dimethyl ammonium chloride (BDAC), and didecyldimethylammonium chloride (DDAC), the surfactants that have been commonly used as detergents, emulsifiers, wetting agents on the stability of SARS-CoV-2 in wastewater. The results showed multiple and dynamic mechanisms, including degradation and desorption, can occur simultaneously during the interaction between SARS-CoV-2 and different chemicals depending on the physicochemical properties of each chemical. Through the elucidation of the dynamic interactions, the findings from this study could help the state health organizations and scientific community to optimize the SARS-CoV-2 wastewater-based epidemiology strategies.

Continued selection on cryptic SARS-CoV-2 observed in Missouri wastewater.

Deep sequencing of wastewater to detect SARS-CoV-2 has been used during the COVID-19 pandemic to monitor viral variants as they appear and circulate in communities. SARS-CoV-2 lineages of an unknown source that have not been detected in clinical samples, referred to as cryptic lineages, are sometimes repeatedly detected from specific locations. We have continued to detect one such lineage previously seen in a Missouri site. This cryptic lineage has continued to evolve, indicating continued selective pressure similar to that observed in Omicron lineages.

Biomarkers selection for population normalization in SARS-CoV-2 wastewater-based epidemiology.

Wastewater-based epidemiology (WBE) has been one of the most cost-effective approaches to track the severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2) levels in the communities since the coronavirus disease 2019 (COVID-19) outbreak in 2020. Normalizing SARS-CoV-2 concentrations by the population biomarkers in wastewater is critical for interpreting the viral loads, comparing the epidemiological trends among the sewersheds, and identifying the vulnerable communities. In this study, five population biomarkers, pepper mild mottle virus (PMMoV), creatinine (CRE), 5-hydroxyindoleacetic acid (5-HIAA), caffeine (CAF) and its metabolite paraxanthine (PARA) were investigated and validated for their utility in normalizing the SARS-CoV-2 loads through two normalizing approaches using the data from 64 wastewater treatment plants (WWTPs) in Missouri. Their utility in assessing the real-time population contributing to the wastewater was also evaluated. The best performing candidate was further tested for its capacity for improving correlation between normalized SARS-CoV-2 loads and the clinical cases reported in the City of Columbia, Missouri, a university town with a constantly fluctuating population. Our results showed that, except CRE, the direct and indirect normalization approaches using biomarkers allow accounting for the changes in wastewater dilution and differences in relative human waste input over time regardless flow volume and population of the given WWTP. Among selected biomarkers, PARA is the most reliable population biomarker in determining the SARS-CoV-2 load per capita due to its high accuracy, low variability, and high temporal consistency to reflect the change in population dynamics and dilution in wastewater. It also demonstrated its excellent utility for real-time assessment of the population contributing to the wastewater. In addition, the viral loads normalized by the PARA-estimated population significantly improved the correlation (rho=0.5878, p < 0.05) between SARS-CoV-2 load per capita and case numbers per capita. This chemical biomarker complements the current normalization scheme recommended by CDC and helps us understand the size, distribution, and dynamics of local populations for forecasting the prevalence of SARS-CoV2 within each sewershed.

Identification and quantification of bioactive compounds suppressing SARS-CoV-2 signals in wastewater-based epidemiology surveillance.

Recent SARS-CoV-2 wastewater-based epidemiology (WBE) surveillance have documented a positive correlation between the number of COVID-19 patients in a sewershed and the level of viral genetic material in the wastewater. Efforts have been made to use the wastewater SARS-CoV-2 viral load to predict the infected population within each sewershed using a multivariable regression approach. However, reported clear and sustained variability in SARS-CoV-2 viral load among treatment facilities receiving industrial wastewater have made clinical prediction challenging. Several classes of molecules released by regional industries and manufacturing facilities, particularly the food processing industry, can significantly suppress the SARS-CoV-2 signals in wastewater by breaking down the lipid-bilayer of the membranes. Therefore, a systematic ranking process in conjugation with metabolomic analysis was developed to identify the wastewater treatment facilities exhibiting SARS-CoV-2 suppression and identify and quantify the chemicals suppressing the SARS-COV-2 signals. By ranking the viral load per diagnosed case among the sewersheds, we successfully identified the wastewater treatment facilities in Missouri, USA that exhibit SARS-CoV-2 suppression (significantly lower than 5 × 1011 gene copies/reported case) and determined their suppression rates. Through both untargeted global chemical profiling and targeted analysis of wastewater samples, 40 compounds were identified as candidates of SARS-CoV-2 signal suppressors. Among these compounds, 14 had higher concentrations in wastewater treatment facilities that exhibited SARS-CoV-2 signal suppression compared to the unsuppressed control facilities. Stepwise regression analyses indicated that 4-nonylphenol, palmitelaidic acid, sodium oleate, and polyethylene glycol dioleate are positively correlated with SARS-CoV-2 signal suppression rates. Suppression activities were further confirmed by incubation studies, and the suppression kinetics for each bioactive compound were determined. According to the results of these experiments, bioactive molecules in wastewater can significantly reduce the stability of SARS-CoV-2 genetic marker signals. Based on the concentrations of these chemical suppressors, a correction factor could be developed to achieve more reliable and unbiased surveillance results for wastewater treatment facilities that receive wastewater from similar industries.

Biomarkers Selection for Population Normalization in SARS-CoV-2 Wastewater-based Epidemiology.

Wastewater-based epidemiology (WBE) has been one of the most cost-effective approaches to track the SARS-CoV-2 levels in the communities since the COVID-19 outbreak in 2020. Normalizing SARS-CoV-2 concentrations by the population biomarkers in wastewater can be critical for interpreting the viral loads, comparing the epidemiological trends among the sewersheds, and identifying the vulnerable communities. In this study, five population biomarkers, pepper mild mottle virus (pMMoV), creatinine (CRE), 5-hydroxyindoleacetic acid (5-HIAA), caffeine (CAF) and its metabolite paraxanthine (PARA) were investigated for their utility in normalizing the SARS-CoV-2 loads through developed direct and indirect approaches. Their utility in assessing the real-time population contributing to the wastewater was also evaluated. The best performed candidate was further tested for its capacity for improving correlation between normalized SARS-CoV-2 loads and the clinical cases reported in the City of Columbia, Missouri, a university town with a constantly fluctuated population. Our results showed that, except CRE, the direct and indirect normalization approaches using biomarkers allow accounting for the changes in wastewater dilution and differences in relative human waste input over time regardless flow volume and population at any given WWTP. Among selected biomarkers, PARA is the most reliable population biomarker in determining the SARS-CoV-2 load per capita due to its high accuracy, low variability, and high temporal consistency to reflect the change in population dynamics and dilution in wastewater. It also demonstrated its excellent utility for real-time assessment of the population contributing to the wastewater. In addition, the viral loads normalized by the PARA-estimated population significantly improved the correlation ( rho =0.5878, p <0.05) between SARS-CoV-2 load per capita and case numbers per capita. This chemical biomarker offers an excellent alternative to the currently CDC-recommended pMMoV genetic biomarker to help us understand the size, distribution, and dynamics of local populations for forecasting the prevalence of SARS-CoV2 within each sewershed. HIGHLIGHT bullet points: The paraxanthine (PARA), the metabolite of the caffeine, is a more reliable population biomarker in SARS-CoV-2 wastewater-based epidemiology studies than the currently recommended pMMoV genetic marker.SARS-CoV-2 load per capita could be directly normalized using the regression functions derived from correlation between paraxanthine and population without flowrate and population data.Normalizing SARS-CoV-2 levels with the chemical marker PARA significantly improved the correlation between viral loads per capita and case numbers per capita.The chemical marker PARA demonstrated its excellent utility for real-time assessment of the population contributing to the wastewater.

Defining biological and biophysical properties of SARS-CoV-2 genetic material in wastewater.

SARS-CoV-2 genetic material has been detected in raw wastewater around the world throughout the COVID-19 pandemic and has served as a useful tool for monitoring community levels of SARS-CoV-2 infections. SARS-CoV-2 genetic material is highly detectable in a patient's feces and the household wastewater for several days before and after a positive COVID-19 qPCR test from throat or sputum samples. Here, we characterize genetic material collected from raw wastewater samples and determine recovery efficiency during a concentration process. We find that pasteurization of raw wastewater samples did not reduce SARS-CoV-2 signal if RNA is extracted immediately after pasteurization. On the contrary, we find that signal decreased by approximately half when RNA was extracted 24-36 h post-pasteurization and ~90% when freeze-thawed prior to concentration. As a matrix control, we use an engineered enveloped RNA virus. Surprisingly, after concentration, the recovery of SARS-CoV-2 signal is consistently higher than the recovery of the control virus leading us to question the nature of the SARS-CoV-2 genetic material detected in wastewater. We see no significant difference in signal after different 24-hour temperature changes; however, treatment with detergent decreases signal ~100-fold. Furthermore, the density of the samples is comparable to enveloped retrovirus particles, yet, interestingly, when raw wastewater samples were used to inoculate cells, no cytopathic effects were seen indicating that wastewater samples do not contain infectious SARS-CoV-2. Together, this suggests that wastewater contains fully intact enveloped particles.

Cake Decorating Luster Dust Associated with Toxic Metal Poisonings - Rhode Island and Missouri, 2018-2019.

During 2018-2019, the Rhode Island Department of Health (RIDOH) and the Missouri Department of Health and Senior Services (DHSS) investigated cases of metal poisonings associated with commercially and home-prepared cakes decorated with products referred to as luster dust. Several types of glitters and dusts, broadly known as luster dust,* for use on prepared foods can be purchased online and in craft and bakery supply stores (1). Decorating foods with luster dust and similar products is a current trend, popularized on television programs, instructional videos, blogs, and in magazine articles.† Some luster dusts are specifically produced with edible ingredients that can be safely consumed. Companies that make edible luster dust are required by law to include a list of ingredients on the label (2). Luster dusts that are safe for consumption are typically marked "edible" on the label. Some luster dusts used as cake decorations are not edible or food grade; labeled as "nontoxic" or "for decorative purposes only," these luster dusts are intended to be removed before consumption (3). RIDOH (2018) and Missouri DHSS (2019), investigated heavy metal poisonings associated with commercially and home-prepared cakes decorated with luster dust after receiving reports of children (aged 1-11 years) who became ill after consuming birthday cake. Cases in Rhode Island were associated with copper ingestion, and the case in Missouri was associated with a child's elevated blood lead level. In Rhode Island, luster dust products that had been used in cake frosting were found to contain high levels of multiple metals.§ These events indicate that increased vigilance by public health departments and further guidance to consumers and bakeries are needed to prevent unintentional poisonings. Labeling indicating that a product is nontoxic does not imply that the product is safe for consumption. Explicit labeling indicating that nonedible products are not safe for human consumption is needed to prevent illness from inappropriate use of inedible products on foods. Educating consumers, commercial bakers, and public health professionals about potential hazards of items used in food preparation is essential to preventing illness and unintentional poisoning from toxic metals and other nonedible ingredients.

New model for electron flow for sulfate reduction in Desulfovibrio alaskensis G20.

To understand the energy conversion activities of the anaerobic sulfate-reducing bacteria, it is necessary to identify the components involved in electron flow. The importance of the abundant type I tetraheme cytochrome c3 (TpIc3) as an electron carrier during sulfate respiration was questioned by the previous isolation of a null mutation in the gene encoding TpIc3, cycA, in Desulfovibrio alaskensis G20. Whereas respiratory growth of the CycA mutant with lactate and sulfate was little affected, growth with pyruvate and sulfate was significantly impaired. We have explored the phenotype of the CycA mutant through physiological tests and transcriptomic and proteomic analyses. Data reported here show that electrons from pyruvate oxidation do not reach adenylyl sulfate reductase, the enzyme catalyzing the first redox reaction during sulfate reduction, in the absence of either CycA or the type I cytochrome c3:menaquinone oxidoreductase transmembrane complex, QrcABCD. In contrast to the wild type, the CycA and QrcA mutants did not grow with H2 or formate and sulfate as the electron acceptor. Transcriptomic and proteomic analyses of the CycA mutant showed that transcripts and enzymes for the pathway from pyruvate to succinate were strongly decreased in the CycA mutant regardless of the growth mode. Neither the CycA nor the QrcA mutant grew on fumarate alone, consistent with the omics results and a redox regulation of gene expression. We conclude that TpIc3 and the Qrc complex are D. alaskensis components essential for the transfer of electrons released in the periplasm to reach the cytoplasmic adenylyl sulfate reductase and present a model that may explain the CycA phenotype through confurcation of electrons.