High-performance phase camera as a frequency selective laser wavefront sensor for gravitational wave detectors.

We have designed, built and tested a high-performance phase camera, which can observe laser wavefronts in a large range of sideband frequencies. Our phase camera scans the laser beam over a pinhole diode and uses a heterodyne technique to independently assess the information in the upper and lower sidebands of up to five different modulation frequencies. Amplitude and phase images, consisting of 214 points each, are obtained every second for each of the 11 demodulated frequencies in parallel. The achieved sensitivity is about 4×10-3 rad (λ/1600 at λ = 1064 nm) at the center of the beam, corresponding to a wavefront deformation of 0.7 nm, and drops to about 3 nm over the beam size. This sensitivity is extremely useful for diagnostic purposes in gravitational wave detectors and fits the requirements for control loops in Advanced Virgo. We report on the design, realization and performance of our phase camera.

Characterization of the room temperature payload prototype for the cryogenic interferometric gravitational wave detector KAGRA.

KAGRA is a cryogenic interferometric gravitational wave detector currently under construction in the Kamioka mine in Japan. Besides the cryogenic test masses, KAGRA will also rely on room temperature optics which will hang at the bottom of vibration isolation chains. The payload of each chain comprises an optic, a system to align it, and an active feedback system to damp the resonant motion of the suspension itself. This article describes the performance of a payload prototype that was assembled and tested in vacuum at the TAMA300 site at the NAOJ in Mitaka, Tokyo. We describe the mechanical components of the payload prototype and their functionality. A description of the active components of the feedback system and their capabilities is also given. The performance of the active system is illustrated by measuring the quality factors of some of the resonances of the suspension. Finally, the alignment capabilities offered by the payload are reported.

Precise measurement of laser power using an optomechanical system.

This paper shows a novel method to precisely measure the laser power using an optomechanical system. By measuring a mirror displacement caused by the reflection of an amplitude modulated laser beam, the number of photons in the incident continuous-wave laser can be precisely measured. We have demonstrated this principle by means of a prototype experiment uses a suspended 25 mg mirror as an mechanical oscillator coupled with the radiation pressure and a Michelson interferometer as the displacement sensor. A measurement of the laser power with an uncertainty of less than one percent (1σ) is achievable.

Reduction of thermal fluctuations in a cryogenic laser interferometric gravitational wave detector.

The thermal fluctuation of mirror surfaces is the fundamental limitation for interferometric gravitational wave (GW) detectors. Here, we experimentally demonstrate for the first time a reduction in a mirror's thermal fluctuation in a GW detector with sapphire mirrors from the Cryogenic Laser Interferometer Observatory at 17 and 18 K. The detector sensitivity, which was limited by the mirror's thermal fluctuation at room temperature, was improved in the frequency range of 90 to 240 Hz by cooling the mirrors. The improved sensitivity reached a maximum of 2.2×10(-19) m/√Hz at 165 Hz.

Direct measurement of thermal fluctuation of high-Q pendulum.

We have achieved a direct measurement of the thermal fluctuation of a pendulum in an off-resonant and wide frequency region using a laser interferometric gravitational-wave detector. These measurements have been well identified for over one decade by an agreement with a theoretical prediction, which is derived by a fluctuation-dissipation theorem. Thermal fluctuation was dominated by the contribution of resistances in coil-magnet actuator circuits. When we tuned these resistances, the noise spectrum also changed according to a theoretical prediction. The measured thermal noise level corresponds to a high quality factor on the order of 10(5) of the pendulum.