RESUMEN
Sensing and characterization of water-soluble peptides is of critical importance in a wide variety of bioapplications. Single molecule nanopore spectrometry (SMNS) is based on the idea that one can use biological protein nanopores to resolve different sized molecules down to limits set by the blockade duration and noise. Previous work has shown that this enables discrimination between polyethylene glycol (PEG) molecules that differ by a single monomer unit. This paper describes efforts to extend SMNS to a variety of biologically relevant, water-soluble peptides. We describe the use of Au25(SG)18 clusters, previously shown to improve PEG detection, to increase the on- and off-rate of peptides to the pore. In addition, we study the role that fluctuations play in the single molecule nanopore spectrometry (SMNS) methodology and show that modifying solution conditions to increase peptide flexibility (via pH or chaotropic salt) leads to a nearly 2-fold reduction in the current blockade fluctuations and a corresponding narrowing of the peaks in the blockade distributions. Finally, a model is presented that connects the current blockade depths to the mass of the peptides, which shows that our enhanced SMNS detection improves the mass resolution of the nanopore sensor more than 2-fold for the largest cationic peptides studied.
RESUMEN
Potentiometric redox measurements were made in subnanoliter droplets of solutions using an optically transparent nanoporous gold electrode strategically mounted on the stage of an inverted microscope. Nanoporous gold was prepared via dealloying gold leaf with concentrated nitric acid and was chemisorbed to a standard microscope coverslip with (3-mercaptopropyl)trimethoxysilane. The gold surface was further modified with 1-hexanethiol to optimize hydrophobicity of the surface to allow for redox measurements to be made in nanoscopic volumes. Time traces of the open-circuit potential (OCP) were used to construct Nernst plots to evaluate the applicability of the droplet-based potentiometric redox measurement system. Two poised one-electron transfer systems (potassium ferricyanide/ferrocyanide and ferrous/ferric ammonium sulfate) yielded Nernstian slopes of -58.5 and -60.3 mV, respectively, with regression coefficients greater than 0.99. The y-intercepts of the two agreed well to the formal potential of the two standard oxidation-reduction potential (ORP) calibrants, ZoBell's and Light's solution. The benzoquinone and hydroquinone redox couple was examined as a representative two-electron redox system; a Nernst slope of -30.8 mV was obtained. Additionally, two unpoised systems (potassium ferricyanide and ascorbic acid) were studied to evaluate the system under conditions where only one form of the redox couple is present in appreciable concentrations. Again, slopes near the Nernstian values of -59 and -29 mV, respectively, were obtained. All experiments were carried out using solution volumes between 280 and 1400 pL with injection volumes between 8 and 100 pL. The miniscule volumes allowed for extremely rapid mixing (<305 ms) as well. The small volumes and rapid mixing along with the high accuracy and sensitivity of these measurements lend support to the use of this approach in applications where time is a factor and only small volumes are available for testing.
RESUMEN
Recent work described the use of thiolate-capped gold clusters (Au25(SG)18) with nanopore sensing to increase the residence time of polyethylene glycol (PEG) in an alpha hemolysin pore [Anal. Chem., 2014, 86, 11077]. It was shown that the residence time enhancement narrows the peaks in the PEG-induced current blockade distribution, thus increasing the resolving power of the single molecule nanopore spectrometry (SMNS) technique. Here, we further study the interaction between the cluster and PEG with the goal of optimizing the residence time enhancement for SMNS detection. Specifically, we report the voltage dependence of the enhancement effect and show that, under the conditions studied, the cluster-enhanced residence time is maximized at an applied transmembrane potential near 60 mV. Additionally, we show that the PEG residence time depends on the degree to which the cluster blocks current through the pore and that the PEG on-rate to the pore can be more accurately measured with a cluster in the pore. Finally, we develop a model that describes the cluster-induced shift of the PEG current blockade distribution. We use this model to characterize the interaction between the cluster and PEG and show that it scales linearly with the applied voltage as expected from the proposed enhancement mechanism.
RESUMEN
Tryptophan (Trp) is a naturally occurring amino acid, which exhibits fluorescence emission properties that are dependent on the polarity of the local environment around the Trp side chain. However, this sensitivity also complicates interpretation of fluorescence emission data. A non-natural analogue of tryptophan, ß-(1-azulenyl)-L-alanine, exhibits fluorescence insensitive to local solvent polarity and does not impact the structure or characteristics of several peptides examined. In this study, we investigated the effect of replacing Trp with ß-(1-azulenyl)-L-alanine in the well-known bee-venom peptide melittin. This peptide provides a model framework for investigating the impact of replacing Trp with ß-(1-azulenyl)-L-alanine in a functional peptide system that undergoes significant shifts in Trp fluorescence emission upon binding to lipid bilayers. Microbiological methods including assessment of the antimicrobial activity by minimal inhibitory concentration (MIC) assays and bacterial membrane permeability assays indicated little difference between the Trp and the ß-(1-azulenyl)-L-alanine-substituted versions of melittin. Circular dichroism spectroscopy showed both that peptides adopted the expected α-helical structures when bound to phospholipid bilayers and electrophysiological analysis indicated that both created membrane disruptions leading to significant conductance increases across model membranes. Both peptides exhibited a marked protection of the respective fluorophores when bound to bilayers indicating a similar membrane-bound topology. As expected, while fluorescence quenching and CD indicate the peptides are stably bound to lipid vesicles, the peptide containing ß-(1-azulenyl)-L-alanine exhibited no fluorescence emission shift upon binding while the natural Trp exhibited >10 nm shift in emission spectrum barycenter. Taken together, the ß-(1-azulenyl)-L-alanine can serve as a solvent insensitive alternative to Trp that does not have significant impacts on structure or function of membrane interacting peptides.
Asunto(s)
Fluorescencia , Membrana Dobles de Lípidos/química , Meliteno , Triptófano , Meliteno/análogos & derivados , Meliteno/química , Estructura Secundaria de Proteína , Triptófano/análogos & derivados , Triptófano/químicaRESUMEN
Nanopore sensing is a label-free method for characterizing water-soluble molecules. The ability to accurately identify and characterize an analyte depends on the residence time of the molecule within the pore. It is shown here that when a Au25(SG)18 metallic cluster is bound to an α-hemolysin (αHL) nanopore, the mean residence time of polyethylene glycol (PEG) within the pore is increased by over 1 order of magnitude. This leads to an increase in the range of detectable PEG sizes and improves the peak resolution within the PEG-induced current blockade distribution. A model describing the relationship between the analyte residence time and the width of the peaks in the current blockade distribution is included. Finally, evidence is presented that shows the Coulombic interaction between the charged analyte and cluster plays an important role in the residence time enhancement, which suggests the cluster-based approach could be used to increase the residence time of a wide variety of charged analyte molecules.