Facet-Dependent Passivation for Efficient Perovskite Solar Cells.

Understanding the interplay between the surface structure and the passivation materials and their effects associated with surface structure modification is of fundamental importance; however, it remains an unsolved problem in the perovskite passivation field. Here, we report a surface passivation principle for efficient perovskite solar cells via a facet-dependent passivation phenomenon. The passivation process selectively occurs on facets, which is observed with various post-treatment materials with different functionality, and the atomic arrangements of the facets determine the alignments of the passivation layers. The profound understanding of facet-dependent passivation leads to the finding of 2-amidinopyridine hydroiodide as the material for a uniform and effective passivation on both (100) and (111) facets. Consequently, we achieved perovskite solar cells with an efficiency of 25.10% and enhanced stability. The concept of facet-dependent passivation can provide an important clue on unidentified passivation principles for perovskite materials and a novel means to enhance the performance and stability of perovskite-based devices.

Measurement of dielectric function and bandgap of germanium telluride using monochromated electron energy-loss spectroscopy.

Using a monochromator in transmission electron microscopy, a low-energy-loss spectrum can provide inter- and intra-band transition information for nanoscale devices with high energy and spatial resolutions. However, some losses, such as Cherenkov radiation, phonon scattering, and surface plasmon resonance superimposed at zero-loss peak, make it asymmetric. These pose limitations to the direct interpretation of optical properties, such as complex dielectric function and bandgap onset in the raw electron energy-loss spectra. This study demonstrates measuring the dielectric function of germanium telluride using an off-axis electron energy-loss spectroscopy method. The interband transition from the measured complex dielectric function agrees with the calculated band structure of germanium telluride. In addition, we compare the zero-loss subtraction models and propose a reliable routine for bandgap measurement from raw valence electron energy-loss spectra. Using the proposed method, the direct bandgap of germanium telluride thin film was measured from the low-energy-loss spectrum in transmission electron microscopy. The result is in good agreement with the bandgap energy measured using an optical method.

Determination of Dy substitution site in Nd2-xDyxFe14B by HAADF-STEM and illustration of magnetic anisotropy of "g" and "f" sites, before and after substitution.

Nd2Fe14B and Nd2-xDyxFe14B (x = 0.25, 0.50) particles were prepared by the modified co-precipitation followed by reduction-diffusion process. Bright field scanning transmission electron microscope (BF-STEM) image revealed the formation of Nd-Fe-B trigonal prisms in [- 101] viewing zone axis, confirming the formation of Nd2Fe14B/Nd2-xDyxFe14B. Accurate site for the Dy substitution in Nd2Fe14B crystal structure was determined as "f" site by using high-angle annular dark field scanning transmission electron microscope (HAADF-STEM). It was found that all the "g" sites are occupied by the Nd, meanwhile Dy occupied only the "f" site. Anti-ferromagnetic coupling at "f" site decreased the magnetic moment values for Nd1.75Dy0.25Fe14B (23.48 µB) and Nd1.5Dy0.5Fe14B (21.03 µB) as compared to Nd2Fe14B (25.50 µB). Reduction of magnetic moment increased the squareness ratio, coercivity and energy product. Analysis of magnetic anisotropy at constant magnetic field confirmed that "f" site substitution did not change the patterns of the anisotropy. Furthermore, magnetic moment of Nd2Fe14B, Nd2-xDyxFe14B, Nd ("f" site), Nd ("g" site) and Dy ("f" site) was recorded for all angles between 0° and 180°.

Quantification of crystallinity using zero-loss filtered electron diffraction.

The quantity of the crystalline phases present in a nanomaterial is an important parameter that governs the correlation between its properties and microstructure. However, quantification of crystallinity in nanoscale-level applications by conventional methods (Raman spectroscopy and X-ray diffraction) is difficult because of the spatial limitations of sampling. Therefore, we propose a technique that involves using energy-filtered electron diffraction in transmission electron microscopy which offers improved spatial resolution. The degree of crystallinity (DOC) was calculated by separating the crystalline and amorphous intensities from the total intensity histogram acquired by the azimuthal averaging of the zero-loss filtered signals from electron diffraction. In order to validate the method, it was demonstrated that the DOC calculated by zero-loss filtered electron diffraction was consistent with the DOC measured by the area ratio using an amorphous silicon on crystalline silicon standard sample. In addition, the results obtained from zero-loss filtered and conventional electron diffractions were compared. The zero-loss filtered electron diffraction successfully provided the reliable results of the crystallinity quantification. In contrast, the DOC measured using conventional electron diffraction yielded extremely variable results. Therefore, our results provide a crystallinity quantification technique that can extract quantitative information about crystallinity of nanoscale devices by using zero-loss filtered electron diffraction with better reliability than conventional electron diffraction. RESEARCH HIGHLIGHTS: The degree of crystallinity can be measured by separating the crystalline and amorphous intensities from the total intensity histogram acquired by the azimuthal averaging of the zero-loss filtered signals from selected area electron diffraction.

Novel Method for Preparing Transmission Electron Microscopy Samples of Micrometer-Sized Powder Particles by Using Focused Ion Beam.

The preparation of transmission electron microscopy (TEM) samples from powders is quite difficult and challenging. For powders with particles in the 1-5 µm size range, it is especially difficult to select an adequate sample preparation technique. Epoxy is commonly used to bind powder, but drawbacks, such as differential milling originating from unequal milling rates between the epoxy and powder, remain. We propose a new, simple method for preparing TEM samples. This method is especially useful for powders with particles in the 1-5 µm size range that are vulnerable to oxidation. The method uses solder as an embedding agent together with focused ion beam (FIB) milling. The powder was embedded in low-temperature solder using a conventional hot-mounting instrument. Subsequently, FIB was used to fabricate thin TEM samples via the lift-out technique. The solder proved to be more effective than epoxy in producing thin TEM samples with large areas. The problem of differential milling was mitigated, and the solder binder was more stable than epoxy under an electron beam. This methodology can be applied for preparing TEM samples from various powders that are either vulnerable to oxidation or composed of high atomic number elements.

Anti-melanogenesis constituents from the seaweed Dictyota coriacea.

This study was conducted to identify the anti-melanogenesis constituents from a seaweed Dictyota coriacea (Holmes). Three known compounds, viz. 1,9-dihydroxycrenulide (1), epiloliolide (2) and D-mannitol (3), were isolated from the ethanol extract. The melanin synthesis inhibition activities were evaluated using B16F10 melanoma cells for the isolates. Compared with the positive control, arbutin, compounds 1 and 2 exhibited more potency, showing 27.8 and 22.6% inhibition activities at a substrate concentration of 30 microg/mL. Our studies also indicate that these compounds are not cytotoxic. Hence, they might prove to be useful therapeutic agents for treating hyperpigmentation and effective components of whitening cosmetics.

A case of an unusual eccrine poroma on the left forearm area.

A 40-year-old woman presented with an asymptomatic red to brown colored walnut-sized, dome shaped, hemorrhagic, crusted nodule on the left forearm. There was no previous history of trauma to the area. The first impression of this case was a vascular tumor or malignant lesion due to the large size and bleeding tendency. However, the final diagnosis, according to histologic and immunostaining methods, was a benign eccrine poroma that occurred on the left forearm, which is an unusual area for such a lesion. The tumor was excised and no recurrence was noted when she was examined 24 months later.

TGF-ß1-treated ADSCs-CM promotes expression of type I collagen and MMP-1, migration of human skin fibroblasts, and wound healing in vitro and in vivo.

Conditioned medium from adipose-derived stem cells (ADSCs) stimulates both collagen synthesis and migration of dermal fibroblasts. However, it is still unknown whether conditioned media from tumor growth factor (TGF)-ß1-treated ADSCs (TGF-ß1-treated ADSCs-CM) induces increased expression of type I collagen, matrix metalloproteinase-1 (MMP-1), and migration as well as cell cycle regulatory proteins in fibroblasts, compared to non-treated ADSCs-CM. Our data showed that TGF-ß1-treated ADSCs-CM promoted effectively the proliferation and migration of human skin fibroblasts, compared to non-treated ADSCs-CM. In addition the expression of MMP-1 were markedly increased by treatment of TGF-ß1-treated ADSCs-CM in fibroblasts, compared to non-treated ADSCs-CM. Expression of type I collagen protein were slightly increased by treatment of TGF-ß1-treated ADSCs-CM in fibroblasts. The expression of cell cycle regulators of G1/S phase transition were not markedly altered by treatment of TGF-ß1-treated ADSCs-CM. Finally, artificial wounds were made using a 4-mm punch biopsy in hairless mice and TGF-ß1-treated ADSCs-CM were injected into the wound area. The injection of TGF-ß1-treated ADSCs-CM promoted the wound healing process in hairless mice. Taken together, our data indicated that TGF-ß1-treated ADSCs-CM induced up-regulation of type I collagen and MMP-1, promoted the migration of skin fibroblasts, and thereby promoted the wound healing process in vivo. Our data indicate that TGF-ß1-treated ADSCs-CM will be a component for a wound healing accelerating agent.