Color Centers in BaFBr Crystals: Experimental Study and Theoretical Modeling.

This study presents theoretical and experimental investigations into the electron and hole color centers in BaFBr crystals, characterizing their electronic and optical properties. Stoichiometric BaFBr crystals grown by the Steber method were used in the experiments. Radiation defects in BaFBr crystals were created by irradiation with 147 MeV 84Kr ions with up to fluences of 1010-1014 ions/cm2. The formation of electron color centers (F(F-), F2(F-), F2(Br-)) and hole aggregates was experimentally established by optical absorption spectroscopy. Performed measurements are compared with theoretical calculations. It allows us to determine the electron transition mechanisms and investigate the processes involved in photoluminescence emission in Eu-doped BaFBr materials to enhance the understanding of the fundamental electronic structure and properties of electron and hole color centers formed in BaFBr crystals.

Unveiling the Structural and Optical Properties of MgAl2O4 Single Crystals Irradiated by Swift Heavy Ions.

A synthetic single crystal of magnesium-aluminate spinel was irradiated perpendicularly to the (111) plane with swift heavy xenon ions with an energy of 220 MeV. The modified layer was attested based on Raman scattering spectra recorded while focusing on the surface. A decrease in surface crystallinity was observed, reflected in the changes in fundamental optical characteristics such as the band gap and the energies of static and dynamic disorder. In this study, we demonstrate, along with the modification of optical characteristics and the formation of a disordered layer, the creation of new optically active centers. The luminescent properties of these centers were analyzed. The effect of temperature flare-up in the 3.4 eV band of the excitation spectrum was determined. The low sensitivity of Cr3+ luminescence to SHI is demonstrated.

Optical Characteristics of MgAl2O4 Single Crystals Irradiated by 220 MeV Xe Ions.

In In this study, the optical properties of magnesium-aluminate spinel were examined after being irradiated with 220 MeV Xe ions. The research aimed to simulate the impact of nuclear fuel fission fragments on the material. The following measurements were taken during the experiments: transmission spectra in the IR region (190-7000) nm, optical absorption spectra in the range (1.2-6.5) eV, and Raman spectra were measured along the depth of ion penetration from the surface to 30 µm. A peak with a broad shape at approximately 5.3 eV can be observed in the optical absorption spectrum of irradiated spinel crystals. This band is linked to the electronic color centers of F+ and F. Meanwhile, the band with a maximum at ~(3-4) eV is attributed to hole color centers. Apart from the typical Raman modes of an unirradiated crystal, additional modes, A1g* (720 cm-1), and Eg* (385 cm-1), manifested mainly as an asymmetric shoulder of the main Eg mode, are also observed. In addition, the Raman spectroscopy method showed that the greatest disordering of crystallinity occurs in the near-surface layer up to 4 µm thick. At the same time, Raman scattering spectroscopy is sensitive to structural changes almost up to the simulated value of the modified layer, which is an excellent express method for certifying the structural properties of crystals modified by swift heavy ions.

Comparative Study of Impact of Gamma and MeV Ion Irradiations on Electrical and Optical Properties Polystyrene/Eu2O3 Nanocomposites.

In the present study, the effect of gamma irradiation and 90 MeV carbon ion beam irradiation on electrical properties and optical of Polystyrene/Eu2O3 nanocomposites at different fluences were examined. Modified electrical and optical responses of polymer nanocomposites were investigated using Impedance, Photoluminescence and UV-VIS spectroscopies. FTIR analysis shows a reduction of various modes of molecular vibrations caused by 90 MeV carbon ion beam irradiation. The polymer nanocomposites change into a graphite-like structure upon both kinds of irradiations as evidenced by the decrease in the optical band gap. The photoluminescence emission spectra show three characteristic peaks of Eu3+ ions, when excited at 247 nm wavelength. It emits intense red light suggesting its potential for usage in LED technology. The peak intensity of PL emission spectra is enhanced after ion beam irradiation and is because of the formation new radiative combination; however, it decreases upon gamma irradiation. Dielectric responses of pristine and irradiated polymer nanocomposites were studied over the frequency range of 100 Hz to 100 kHz using LCR meter. There appears a significant improvement in the dielectric response as a result of structural changes in both types of irradiations. AFM images show that the film becomes smoother upon both types of irradiations.

Direct Fabrication of Sub-10 nm Nanopores in WO3 Nanosheets Using Single Swift Heavy Ions.

Extending the fabrication methodology of solid-state nanopores in a wide range of materials is significant in the fields of single molecule detection, nanofluidic devices, and nanofiltration membranes. Here, we demonstrate a new method to directly fabricate size- and density-controllable sub-10 nm nanopores in WO3 nanosheets using single swift heavy ions (SHIs) without any chemical etching process. By selecting ions of different electronic energy losses (Se), nanopores with sizes from 1.8 to 7.4 nm can be created in WO3 nanosheets. The creation efficiency of nanopores achieves ∼100% for Se > 20 keV/nm, and there exists a critical thickness below which nanopores can be created. Combined with molecular dynamics simulations, we propose that the viscosity and surface tension of the transient molten phase caused by SHIs are the key factors for the formation of nanopores. This method paves a way to fabricate solid-state nanopores in materials with a low viscosity and surface tension.

Structural and Electrical Response of Emerging Memories Exposed to Heavy Ion Radiation.

Hafnium oxide- and GeSbTe-based functional layers are promising candidates in material systems for emerging memory technologies. They are also discussed as contenders for radiation-harsh environment applications. Testing the resilience against ion radiation is of high importance to identify materials that are feasible for future applications of emerging memory technologies like oxide-based, ferroelectric, and phase-change random-access memory. Induced changes of the crystalline and microscopic structure have to be considered as they are directly related to the memory states and failure mechanisms of the emerging memory technologies. Therefore, we present heavy ion irradiation-induced effects in emerging memories based on different memory materials, in particular, HfO2-, HfZrO2-, as well as GeSbTe-based thin films. This study reveals that the initial crystallinity, composition, and microstructure of the memory materials have a fundamental influence on their interaction with Au swift heavy ions. With this, we provide a test protocol for irradiation experiments of hafnium oxide- and GeSbTe-based emerging memories, combining structural investigations by X-ray diffraction on a macroscopic, scanning transmission electron microscopy on a microscopic scale, and electrical characterization of real devices. Such fundamental studies can be also of importance for future applications, considering the transition of digital to analog memories with a multitude of resistance states.

Signature of strong localization and crossover conduction processes in doped ZnO thin films: synergetic effect of doping fraction and dense electronic excitations.

GaxZn1-xO thin films with varying Ga fraction within the solubility limit were irradiated with high-energy heavy ions to induce electronic excitations. The films show good transmittance in the visible region and a reduction of about 20% in transmittance was observed for irradiated films at higher ion fluences. The Urbach energy was estimated and showed an augmenting response upon increase in doping fraction and ion irradiation, this divulges an enhancement of localized states in the bandgap or disorder in the films. The evolution of such localized states plays a vital role in charge transport and thus the temperature dependent electrical conductivity of irradiated thin films was studied to elucidate the dominant conduction mechanisms. The detailed analysis unfolds that in the high-temperature regime (180 K

Formation of swift heavy ion tracks on a rutile TiO2 (001) surface.

Nanostructuring of surfaces and two-dimensional materials using swift heavy ions offers some unique possibilities owing to the deposition of a large amount of energy localized within a nanoscale volume surrounding the ion trajectory. To fully exploit this feature, the morphology of nanostructures formed after ion impact has to be known in detail. In the present work the response of a rutile TiO2 (001) surface to grazing-incidence swift heavy ion irradiation is investigated. Surface ion tracks with the well known intermittent inner structure were successfully produced using 23 MeV I ions. Samples irradiated with different ion fluences were investigated using atomic force microscopy and grazing-incidence small-angle X-ray scattering. With these two complementary approaches, a detailed description of the swift heavy ion impact sites, i.e. the ion tracks on the surface, can be obtained even for the case of multiple ion track overlap. In addition to the structural investigation of surface ion tracks, the change in stoichiometry of the rutile TiO2 (001) surface during swift heavy ion irradiation was monitored using in situ time-of-flight elastic recoil detection analysis, and a preferential loss of oxygen was found.

Microstructural and plasmonic modifications in Ag-TiO2 and Au-TiO2 nanocomposites through ion beam irradiation.

The development of new fabrication techniques of plasmonic nanocomposites with specific properties is an ongoing issue in the plasmonic and nanophotonics community. In this paper we report detailed investigations on the modifications of the microstructural and plasmonic properties of metal-titania nanocomposite films induced by swift heavy ions. Au-TiO2 and Ag-TiO2 nanocomposite thin films with varying metal volume fractions were deposited by co-sputtering and were subsequently irradiated by 100 MeV Ag(8+) ions at various ion fluences. The morphology of these nanocomposite thin films before and after ion beam irradiation has been investigated in detail by transmission electron microscopy studies, which showed interesting changes in the titania matrix. Additionally, interesting modifications in the plasmonic absorption behavior for both Au-TiO2 and Ag-TiO2 nanocomposites were observed, which have been discussed in terms of ion beam induced growth of nanoparticles and structural modifications in the titania matrix.