Insight into the charging-discharging of magnetite electrodes: in situ XAS and DFT study.

The structural changes of Fe3O4 nanoparticle electrodes in Li ion batteries during charging-discharging cycles have been investigated using in situ X-ray absorption spectroscopy (XAS). Chemometric methods viz., Principal Component Analysis (PCA) and Multivariate Curve Resolution-Alternate Least Square (MCR-ALS) have been used for analysis of the in situ XANES data during the charge-discharge cycle, which help to identify the various species formed during the lithiation-delithiation of Fe3O4. The concentration variation of the different species has also been determined and the detailed intercalation-conversion mechanism of the Fe3O4 electrodes during the first discharge has been established. Subsequently, the first charge and second discharge cycles were also studied to apprehend the difference in redox reaction between the first discharge and subsequent cycles. The above studies clearly identify the four species involved in the whole intercalation-conversion process of Fe3O4 electrode of a Li ion battery and also indicate the irreversibility of the conversion reaction in subsequent cycles which may be one of the reasons for capacity fading of these electrodes. The above results have also been corroborated with density functional theory (DFT)based ab inito calculations.

Interface modification of Cr/Ti multilayers with C barrier layer for enhanced reflectivity in the water window regime.

The influence of a carbon barrier layer to improve the reflectivity of Cr/Ti multilayers, intended to be used in the water window wavelength regime, is investigated. Specular grazing-incidence X-ray reflectivity results of Cr/Ti multilayers with 10 bilayers show that interface widths are reduced to ∼0.24 nm upon introduction of a ∼0.3 nm C barrier layer at each Cr-on-Ti interface. As the number of bilayers increases to 75, a multilayer with C barrier layers maintains almost the same interface widths with no cumulative increase in interface imperfections. Using such interface-engineered Cr/C/Ti multilayers, a remarkably high soft X-ray reflectivity of ∼31.6% is achieved at a wavelength of 2.77 nm and at a grazing angle of incidence of 16.2°, which is the highest reflectivity reported so far in the literature in this wavelength regime. Further investigation of the multilayers by diffused grazing-incidence X-ray reflectivity and grazing-incidence extended X-ray absorption fine-structure measurements using synchrotron radiation suggests that the improvement in interface microstructure can be attributed to significant suppression of inter-diffusion at Cr/Ti interfaces by the introduction of C barrier layers and also due to the smoothing effect of the C layer promoting two-dimensional growth of the multilayer.