Strange Metallicity and Magnetic Order in the CoNi(Cr/V) Medium-Entropy Alloy System.

CoNiCr is a prototypical example of topical multi-principle element alloys with superior cryogenic and high-temperature mechanical strength, corrosion, oxidation resistance, and yet-to-be-explored magnetic and electronic functionalities. The remarkable properties of this transition metal ternary system are not only due to atomic radii, electronic configurational mismatch, and atomic volume misfit but are also dependent on the debated magnetically driven chemical short-range order. The current study focuses on the electric and magnetic properties of the single-phase face-centered cubic CoNi(Cr/V) system in which V is introduced to the system at the expense of Cr to fine-tune the volume misfit in the system. All the samples exhibited ultra-small magnetic moments due to the complex magnetic interactions of the constituent elements. The electric transport measurements revealed a strange metallicity evidenced through the observation of the linear temperature dependence of the resistivity. Our findings support the recent theoretical studies on the magnetically driven chemical short-range order of the CoNiCr system.

A Low-Cost Process for Fabricating Reinforced 3D Printing Thermoplastic Filaments.

Low-cost desktop-sized fused deposition modeling (FDM) printers have been widely embraced by small to large-scale institutions and individuals. To further enhance their utility and increase the range of materials that they can process, this work proposes a low-cost solution that adapts to low-cost desktop-sized extruders and enables them to fabricate filaments comprising a wide range of nonorganic reinforcing particles. This solution will fill a gap in the field, as low-cost fabrication techniques for reinforced filaments have been lacking. In the proposed solution, particles are heated and deposited on thermoplastic pellets to form a coating. Coated pellets are subsequently extruded using a low-cost desktop single-screw extruder. The effectiveness of the process is demonstrated by fabricating polylactic acid (PLA) filaments reinforced with two types of reinforcements, namely, dune sand and silicon carbide. Filaments' stiffness and strength were measured, and their microstructure along their lateral and longitudinal directions were investigated. Improvements in tensile strength (up to 8%) and stiffness (up to 4.5%) were observed, but at low reinforcement levels (less than 2 wt%). Results showed that the proposed process could be used to fabricate filaments with multiple types of particles. The produced filaments were successfully used to fabricate 3D parts using a commercial desktop FDM printer.

Shear Strength of Fiber Reinforced Recycled Aggregate Concrete.

In this paper, shear strength of fiber reinforced recycled concrete was investigated. A Self Consolidated Concrete (SCC) matrix with 100% coarse recycled aggregate and different types of fibers were used in the study. Steel (3D and 5D), synthetic and hybrid fibers with a volume fraction of 0.75% were added to the concrete matrix to prepare eight beams. In addition, two beams were cast without fibers as control specimens. All beams were prepared without shear reinforcement and were tested to evaluate concrete contribution to the shear capacity. In addition, optical images were captured to allow for full-field displacement measurements using Digital Image Correlation (DIC). The results showed about 23.44-64.48% improvement in the average concrete shear capacity for fiber-reinforced beams when compared to that of the control specimens. The percentage improvement was affected by fiber type and the steel fiber beams achieved the best performance. The addition of the fiber delayed the crack initiation and improved the post-cracking and ductile behavior of all beams. Moreover, the experimental results were compared to those predicted by codes and proposed equations found in the literature for concrete strength with and without fibers.