Critical investigation of the substituent distribution in the polymer chains of hydroxypropyl methylcelluloses by (LC-)ESI-MS.

Three hydroxypropyl methylcellulose samples (HPMC1-3, DS(Me) = 1.45, 1.29, and 1.36; MS(HP) = 0.28, 0.46, and 0.84) were analyzed with respect to their methyl and hydroxypropyl substitution pattern in the polymer chains. Ionization yield of HPMC oligomers in electrospray ionization ion trap mass spectrometry (ESI-IT-MS) is strongly influenced by the hydroxypropyl pattern. Therefore, a sample derivatization procedure, as well as suitable measurement conditions that enable relative quantification were elaborated. Analysis was performed by negative ESI-IT-MS after per(deutero)methylation, partial depolymerization, and reductive amination with m-aminobenzoic acid. Measurement parameters like solvent, trap drive, and voltages of the ion transportation unit were studied with regard to the suitability for quantitative evaluation. Using direct infusion of the samples, strong influence of trap drive and octopole settings was observed. Optimized measurement conditions were used for the determination of the HP pattern of the permethylated samples by direct infusion. The methyl pattern was determined from the perdeuteromethylated samples by high-performance liquid chromatography-electrospray tandem mass spectrometry. For HPMC1, substituents were both found to fit the random distribution model. The other two samples showed pronounced heterogeneity which could be interpreted in more detail by extracting methyl subpatterns depending on the number of HP groups.

Structure and properties of aqueous methylcellulose gels by small-angle neutron scattering.

Cold, semidilute, aqueous solutions of methylcellulose (MC) are known to undergo thermoreversible gelation when warmed. This study focuses on two MC materials with much different gelation performance (gel temperature and hot gel modulus) even though they have similar metrics of their coarse-grained chemical structure (degree-of-methylether substitution and molecular weight distribution). Small-angle neutron scattering (SANS) experiments were conducted to probe the structure of the aqueous MC materials at pre- and postgel temperatures. One material (MC1, higher gel temperature) exhibited a single almost temperature-insensitive gel characteristic length scale (ζ(c) = 1090 ± 50 Å) at postgelation temperatures. This length scale is thought to be the gel blob size between network junctions. It also coincides with the length scale between entanglement sites measured with rheology studies at pregel temperatures. The other material (MC2, lower gel temperature) exhibited two distinct length scales at all temperatures. The larger length scale decreased as temperature increased. Its value (ζ(c1) = 1046 ± 19 Å) at the lowest pregel temperature was indistinguishable from that measured for MC1, and reached a limiting value (ζ(c1) = 450 ± 19 Å) at high temperature. The smaller length scale (ζ(c2) = 120 to 240 Å) increased slightly as temperature increased, but remained on the order of the chain persistence length (130 Å) measured at pregel temperatures. The smaller blob size (ζ(c1)) of MC2 suggests a higher bond energy or a stiffer connectivity between network junctions. Moreover, the number density of these blobs, at the same reduced temperature with respect to the gel temperature, is orders of magnitude higher for the MC2 gels. Presumably, the smaller gel length scale and higher number density lead to higher hot gel modulus for the low gel temperature material.

Simultaneous determination of substituent patterns in partially acid hydrolyzed O-Me/O-Me-d(3)-cellulose and quantification of the obtained oligomers by HPLC-ESI-MS.

Substituent patterns in oligosaccharide derivatives obtained from methyl cellulose were determined up to DP10 by electrospray ionization mass spectrometry employing separation of the oligomer fractions by HPLC. Oligosaccharides were labeled with meta-aminobenzoic acid after perdeuteromethylation and partial hydrolysis of methyl cellulose, enabling simultaneous quantification according to DP by HPLC/UV. Control of the HPLC-method was performed with a defined oligomer mixture obtained from ß-cyclodextrin. Results from LC-ESI-MS are discussed in comparison with those from syringe pump injection and compared to a calculated pattern for a random distribution. Programing of instrumental parameters optimized for each DP and avoidance of competition of successively eluting analytes in the electrospray process allowed extension of the established method for determination of the substitution pattern of cellulose derivatives along the polymer chain from DP5 to DP10 and thus a significant gain of information.

Comprehensive analysis of the substituent distribution in hydroxyethyl celluloses by quantitative MALDI-ToF-MS.

Three HECs with a high MS (HEC 1: 1.89, HEC 2: 1.94, HEC 3: 3.03) were analyzed with respect to their substituent distribution and tandem reaction in the glucosyl unit by GLC of the corresponding glucitol acetates, and along the polymer chain by MALDI-ToF-MS after a multi-step sample preparation. For comparison of the experimental data with a random pattern an extended Bernoulli plot was applied to calculate a random distribution for the composition of un-, mono-, di-, tri-, and up to heptasubstituted glucosyl units (c0, c1, c2, ... c7).

New approaches to the analysis of enzymatically hydrolyzed methyl cellulose. Part 1. Investigation of the influence of structural parameters on the extent of degradation.

Six methyl celluloses (MCs), one with a degree of substitution (DS) of 1.32 and five with DS between 1.83 and 1.88, were thoroughly investigated. Monomer composition and methyl distribution in the polymer chain were analyzed after total or partial random hydrolysis and appropriate derivatization with gas chromatography (GC) and mass spectrometry (MS), respectively, and used as reference data. The same MCs were then hydrolyzed with an enzyme preparation of Trichoderma longibrachiatum and further investigated with size-exclusion chromatography with multiangle light scattering and refractive index detection (SEC-MALS/RI) and MS. Electrospray ionization (ESI) and matrix-assisted laser desorption/ionization (MALDI) in combination with various MS analyzers were compared with respect to quantification of the degradation products directly and after perdeuteriomethylation. The methyl group distribution in the oligomeric fractions and the average DS as a function of chain length were calculated from ESI mass spectra. With help of the reference analysis, patterns could be corrected for the unspecific contribution of end groups. By labeling and ESI tandem MS, our knowledge about the tolerance of the enzymes' sub-sites with respect to the number of methyl groups could be improved.

New approaches to the analysis of enzymatically hydrolyzed methyl cellulose. Part 2. Comparison of various enzyme preparations.

In this part of our studies, dealing with new approaches to the analysis of enzymatically hydrolyzed methyl cellulose, five different enzymes or enzyme preparations containing endoglucanases (from Bacillus agaradhaerens Cel 5A, Trichoderma reesei, Trichoderma viride, and two obtained from Trichoderma longibrachiatum) were used to hydrolyze six different methyl celluloses (MCs). The main goal was to investigate whether enzymes could be used for determination of the heterogeneity of the substituent distribution along the cellulose chain. To obtain information about the heterogeneity, it was necessary to gather information on how the enzymes affect hydrolysis. Size exclusion chromatography with multi-angle light scattering and refractive index detection (SEC-MALS/RI) was used to estimate the molar mass distribution of the MCs before and after hydrolysis. A novel internal standard addition method in combination with electrospray ionization ion trap mass spectrometry (ESI-ITMS) was used to determine the amount of formed oligomers. Two MCs, one with a degree of substitution (DS) of 1.8 and one with DS 1.3, were hydrolyzed with all of the five enzymes. The yield of summarized di- and trisaccharides was approximately 2% of the hydrolysis products for the MC with DS 1.8, whereas the product mixture, obtained from a MC with a DS of 1.3, contained 7-16% di- and trisaccharides. By a novel sample preparation method in combination with ESI-IT tandem MS, outlined in part 1 of this work, it was shown that the enzymes produced oligomers with the reducing end bearing no or only one substituent. Comparison of the methyl pattern at the nonreducing ends of the dimers and trimers indicated that the -2 subsite of the active complex is less tolerant than subsites -3 and +1. All enzymes had similar general selectivity toward the methyl substituents but also showed some differences. From both SEC-MALS/RI and ESI-ITMS, differences with respect to substituent distribution of MCs could be recognized but not for each enzyme used. Basic considerations for enzymatic hydrolysis and analysis of methyl cellulose were listed as a consequence of the results from the work.

Comprehensive analysis of the substituent distribution in the glucosyl units and along the polymer chain of hydroxyethylmethyl celluloses and statistical evaluation.

Hydroxyethylmethyl celluloses (HEMC, DS(Me) 1.46-1.66, DS(HE) = 0.14-0.17) have been analyzed with respect to their methyl and hydroxyethyl pattern in the glucosyl units and along the polymer chain. Methyl groups were located by GLC/MS after direct hydrolysis, reduction, and acetylation, and the distribution of hydroxyethyl residues in the glucosyl units could be determined with enhanced sensitivity after permethylation to unify a certain HE pattern occurring in combination with various methyl patterns in a single peak. To get insight into the distribution of Me and HE along the cellulose chain, a method was developed which overcomes the strong discrimination of relative ion intensities caused by hydroxyalkyl groups and enables quantitative determination of the oligomer composition after random degradation for the first time. This comprises perdeuteriomethylation; partial acid hydrolysis; reductive amination with propylamine; and, finally, permethylation to yield completely O- and N-alkylated, permanently charged oligosaccharides. Although the methyl pattern can be determined by electrospray ionization ion-trap mass spectrometry (ESI-IT-MS) and matrix-assisted laser desorption ionization time-of-flight mass spectrometry (MALDI-TOF-MS), as well, only MALDI-TOF-MS produced representative data for a quantitative evaluation of the HE pattern. Distribution of HE groups matches with a random distribution calculated from the monomer composition, whereas the methyl pattern was heterogeneous to a different extent.