Life Cycle Assessment and Net Energy Analysis of an Integrated Hydrothermal Liquefaction-Anaerobic Digestion of Single and Mixed Beverage Waste and Sewage Sludge.

The conversion of biomass to bioenergy is one of the approaches to creating a sustainable society. In this study, the life cycle assessment and the net energy analysis of converting mixed sewage sludge and beverage waste into bioenergy via a combined hydrothermal liquefaction-anaerobic digestion (HTL-AD) system was carried out. Primary sludge (PS), winery rose lees (RL), brewery Trub (BT), the mixture of brewery trub and primary sludge (BTPS) and the mixture of winery rose lees and primary sludge (RLPS) were the feedstocks considered. Efficient energy utilization [in form of net energy ratio (NER)], and environmental emissions were evaluated. The NER of BT (2.07) and RL (1.76) increased when mixed with PS (3.18) to produce BTPS (3.20) and RLPS (2.85). Also, the HTL phase of the combined HTL-AD system produced a greater NER than the AD phase in BT, BTPS, and PS and vice-versa in RL and RLPS. Six environmental impact categories were studied namely global warming, terrestrial acidification, ionizing radiation, terrestrial ecotoxicity, human carcinogenic toxicity, and human non-carcinogenic toxicity. RL produced the greatest environmental impact while BTPS produced the least impact, thus indicating the advantage of feedstock combination. This study shows that the combination of feedstocks for bioenergy production in an HTL-AD system does not only increase the quality and quantity of products but also increases the overall NER as well as reducting the environmental impacts. The study also proved that an integrated HTL-AD system is an energy efficient system with greater resource utilization and less environmental footprint than the constituent systems.

Removal of pollutants from aqueous product of Co-hydrothermal liquefaction: Adsorption and isotherm studies.

Hydrothermal liquefaction (HTL) is an attractive technology for the conversion of wet waste into biofuel and co-HTL has been touted to increase the quality of products. However, the recovery of energy from wastewater byproduct called aqueous co-product (ACP) is limited due to the presence of toxic inhibitory substances. Adsorption has been countenanced to remove these toxic compounds but there has not been a distinct comprehensive adsorption isotherm study to explain the interaction between the adsorbate molecules and the adsorbent sites. This study investigated the sorption mechanism of oxidizable reducing pollutants measured as chemical oxygen demand (COD); heavy metals (boron and copper); and phenols from ACP samples obtained from co-HTL of brewery trub (BT), and primary sludge (PS) onto granular and powdered activated carbon (GAC and PAC). Conventional isotherm models such as Langmuir, Freundlich, Temkin, and Dubinin-Radushkevich were used for data analysis. Results indicated that the adsorptive capacity (qe) of PAC was greater than GAC in COD adsorption (BT-1947 > 234; BTPS-617 > 245; PS-289 > 207), boron adsorption (BTPS-70 > 7; PS-53 > 49), copper adsorption (BT-5 > 1; BTPS-3 > 2; PS-1.3 > 1.1) and phenol adsorption (BT-1340 > 356; BTPS-1587 > 253; PS-460 > 245) in mg/g, µg/g, µg/g, and µg/g respectively. Comparing the adsorption of pollutants onto PAC and GAC, this study observed that PAC followed the Temkin, and Dubinin-Radushkevich models in the adsorption of the four pollutants while GAC followed the Freundlich and Langmuir models in the adsorption of phenol and copper, and Temkin, and Dubinin-Radushkevich in the adsorption of COD and boron. This study proved that combining feedstock in HTL (co-HTL) does not only change the quality of the ACP but also changes the dynamics of the adsorption isotherms. The Free Energy Change (ΔG0) result showed a spontaneous reaction in the adsorption of copper and phenol. This study presents an adsorption equilibrium information for the interpretation of adsorption isotherms for the overall improvement of adsorption mechanism pathways and the effective design of adsorption systems for the treatment of ACP.