RESUMO
The remarkable performance of copper indium gallium selenide (CIGS)-based double heterojunction (DH) photovoltaic cells is presented in this work. To increase all photovoltaic performance parameters, in this investigation, a novel solar cell structure (FTO/SnS2/CIGS/Sb2S3/Ni) is explored by utilizing the SCAPS-1D simulation software. Thicknesses of the buffer, absorber and back surface field (BSF) layers, acceptor density, defect density, capacitance-voltage (C-V), interface defect density, rates of generation and recombination, operating temperature, current density, and quantum efficiency have been investigated for the proposed solar devices with and without BSF. The presence of the BSF layer significantly influences the device's performance parameters including short-circuit current (Jsc), open-circuit voltage (Voc), fill factor (FF), and power conversion efficiency (PCE). After optimization, the simulation results of a conventional CIGS cell (FTO/SnS2/CIGS/Ni) have shown a PCE of 22.14% with Voc of 0.91 V, Jsc of 28.21 mA cm-2, and FF of 86.31. Conversely, the PCE is improved to 31.15% with Voc of 1.08 V, Jsc of 33.75 mA cm-2, and FF of 88.50 by introducing the Sb2S3 BSF in the structure of FTO/SnS2/CIGS/Sb2S3/Ni. These findings of the proposed CIGS-based double heterojunction (DH) solar cells offer an innovative method for realization of high-efficiency solar cells that are more promising than the previously reported traditional designs.
RESUMO
Conventional Copper Indium Gallium Di Selenide (CIGS)-based solar cells are more efficient than second-generation technology based on hydrogenated amorphous silicon (a-Si: H) or cadmium telluride (CdTe). So, herein the photovoltaic (PV) performance of CIGS-based solar cells has been investigated numerically using SCAPS-1D solar simulator with different buffer layer and less expensive tin sulfide (Sn2S3) back-surface field (BSF). At first, three buffer layer such as cadmium sulfide (CdS), zinc selenide (ZnSe) and indium-doped zinc sulfide ZnS:In have been simulated with CIGS absorber without BSF due to optimized and non-toxic buffer. Then the optimized structure of Al/FTO/ZnS:In/CIGS/Ni is modified to become Al/FTO/ZnS:In/CIGS/Sn2S3/Ni by adding a Sn2S3 BSF to enhanced efficiency. The detailed analysis have been investigated is the influence of physical properties of each absorber and buffer on photovoltaic parameters including layer thickness, carrier doping concentration, bulk defect density, interface defect density. This study emphasizes investigating the reasons for the actual devices' poor performance and illustrates how each device's might vary open-circuit voltage (VOC), short-circuit current density (JSC), fill factor (FF), power conversion efficiency (PCE), and quantum efficiency (QE). The optimized structure offers outstanding power conversion efficiency (PCE) of 21.83 % with only 0.80 µm thick CIGS absorber. The proposed CIGS-based solar cell performs better than the previously reported conventional designs while also reducing CIGS thickness and cost.