RESUMO
The geodetic dataset used in the research article entitled "Multi-technique geodetic detection of onshore and offshore subsidence along the Upper Adriatic Sea coasts"[1] is presented here. It consists of the outcomes of three different techniques, i.e. Synthetic Aperture Radar Interferometry (InSAR), Global Navigation Satellite System (GNSS) and topographic Levelling surveys. This dataset has been used for the estimation of onshore and offshore deformation in a mineral concession area located along the Upper Adriatic Sea coastal area (Italy), South-East of Ravenna city. InSAR data covers the period from 2002 to 2018, GNSS data from 1998 to 2018 and levelling data from 2002 to 2017.The different measurements have been cross-validated and referred to a common local reference system fixed in the urban area of Ravenna. This data collection will be very useful for deepening the analysis of any type of deformation in the Ravenna coastal area.
RESUMO
We measured ground displacements before and after the 2009 L'Aquila earthquake using multi-temporal InSAR techniques to identify seismic precursor signals. We estimated the ground deformation and its temporal evolution by exploiting a large dataset of SAR imagery that spans seventy-two months before and sixteen months after the mainshock. These satellite data show that up to 15 mm of subsidence occurred beginning three years before the mainshock. This deformation occurred within two Quaternary basins that are located close to the epicentral area and are filled with sediments hosting multi-layer aquifers. After the earthquake, the same basins experienced up to 12 mm of uplift over approximately nine months. Before the earthquake, the rocks at depth dilated, and fractures opened. Consequently, fluids migrated into the dilated volume, thereby lowering the groundwater table in the carbonate hydrostructures and in the hydrologically connected multi-layer aquifers within the basins. This process caused the elastic consolidation of the fine-grained sediments within the basins, resulting in the detected subsidence. After the earthquake, the fractures closed, and the deep fluids were squeezed out. The pre-seismic ground displacements were then recovered because the groundwater table rose and natural recharge of the shallow multi-layer aquifers occurred, which caused the observed uplift.
RESUMO
The potential for oilfield activities to trigger earthquakes in seismogenic areas has been hotly debated. Our model compares the stress changes from remote water injection and a natural earthquake, both of which occurred in northern Italy in recent years, and their potential effects on a nearby Mw 5.9 earthquake that occurred in 2012. First, we calculate the Coulomb stress from 20 years of fluid injection in a nearby oilfield by using a poroelastic model. Then, we compute the stress changes for a 2011 Mw 4.5 earthquake that occurred close to the area of the 2012 mainshock. We found that anthropogenic activities produced an effect that was less than 10% of that generated by the Mw 4.5 earthquake. Therefore, the 2012 earthquake was likely associated with a natural stress increase. The probability of triggering depends on the magnitude of recent earthquakes, the amount of injected water, the distance from an event, and the proximity to the failure of the activated fault. Determining changes that are associated with seismic hazards requires poroelastic area-specific models that include both tectonic and anthropogenic activities. This comprehensive approach is particularly important when assessing the risk of triggered seismicity near densely populated areas.
RESUMO
The present work focuses on the postseismic deformation observed in the region of L'Aquila (central Italy) following the Mw 6.3 earthquake that occurred on April 6, 2009. A new, 16-month-long dataset of COSMO-SkyMed SAR images was analysed using the Persistent Scatterer Pairs interferometric technique. The analysis revealed the existence of postseismic ground subsidence in the mountainous rocky area of Mt Ocre ridge, contiguous to the sedimentary plain that experienced coseismic subsidence. The postseismic subsidence was characterized by displacements of 10 to 35 mm along the SAR line of sight. In the Mt Ocre ridge, widespread morphological elements associated with gravitational spreading have been previously mapped. We tested the hypothesis that the postseismic subsidence of the Mt Ocre ridge compensates the loss of equilibrium induced by the nearby coseismic subsidence. Therefore, we simulated the coseismic and postseismic displacement fields via the finite element method. We included the gravitational load and fault slip and accounted for the geometrical and rheological characteristics of the area. We found that the elastoplastic behaviour of the material under gravitational loading best explains the observed postseismic displacement. These findings emphasize the role of gravity in the postseismic processes at the fault scale.
