CPE-Na-Based Hole Transport Layers for Improving the Stability in Nonfullerene Organic Solar Cells: A Comprehensive Study.

Organic photovoltaic (OPV) cells have experienced significant development in the last decades after the introduction of nonfullerene acceptor molecules with top power conversion efficiencies reported over 19% and considerable versatility, for example, with application in transparent/semitransparent and flexible photovoltaics. Yet, the optimization of the operational stability continues to be a challenge. This study presents a comprehensive investigation of the use of a conjugated polyelectrolyte polymer (CPE-Na) as a hole layer (HTL) to improve the performance and longevity of OPV cells. Two different fabrication approaches were adopted: integrating CPE-Na with PEDOT:PSS to create a composite HTL and using CPE-Na as a stand-alone bilayer deposited beneath PEDOT:PSS on the ITO substrate. These configurations were compared against a reference device employing PEDOT:PSS alone, as the HTL increased efficiency and fill factor. The instruments with CPE-Na also demonstrated increased stability in the dark and under simulated operational conditions. Device-based PEDOT:PSS as an HTL reached T80 after 2500 h while involving CPE-Na in the device kept at T90 in the same period, evidenced by a reduced degradation rate. Furthermore, the impedance spectroscopy and photoinduced transient methods suggest optimized charge transfer and reduced charge carrier recombination. These findings collectively highlight the potential of CPE-Na as a HTL optimizer material for nonfluorine OPV cells.

Ionic Field Screening in MAPbBr3 Crystals Revealed from Remnant Sensitivity in X-ray Detection.

Research on metal halide perovskites as absorbers for X-ray detection is an attractive subject due to the optimal optoelectronic properties of these materials for high-sensitivity applications. However, the contact degradation and the long-term instability of the current limit the performance of the devices, in close causality with the dual electronic-ionic conductivity of these perovskites. Herein, millimeter-thick methylammonium-lead bromide (MAPbBr3) single and polycrystalline samples are approached by characterizing their long-term dark current and photocurrent under X-ray incidence. It is shown how both the dark current and the sensitivity of the detectors follow similar trends at short-circuit (V = 0 V) after biasing. By performing drift-diffusion numerical simulations, it is revealed how large ionic-related built-in fields not only produce relaxations to equilibrium lasting up to tens of hours but also continue to affect the charge kinetics under homogeneous low photogeneration rates. Furthermore, a method is suggested for estimating the ionic mobility and concentration by analyzing the initial current at short-circuit and the characteristic diffusion times.

Surface versus Bulk Currents and Ionic Space-Charge Effects in CsPbBr3 Single Crystals.

CsPbBr3 single crystals have potential for application in ionizing-radiation detection devices due to their optimal optoelectronic properties. Yet, their mixed ionic-electronic conductivity produces instability and hysteretic artifacts hindering the long-term device operation. Herein, we report an electrical characterization of CsPbBr3 single crystals operating up to the time scale of hours. Our fast time-of-flight measurements reveal bulk mobilities of 13-26 cm2 V-1 s-1 with a negative voltage bias dependency. By means of a guard ring (GR) configuration, we separate bulk and surface mobilities showing significant qualitative and quantitative transport differences. Our experiments of current transients and impedance spectroscopy indicate the formation of several regimes of space-charge-limited current (SCLC) associated with mechanisms similar to the Poole-Frenkel ionized-trap-assisted transport. We show that the ionic-SCLC seems to be an operational mode in this lead halide perovskite, despite the fact that experiments can be designed where the contribution of mobile ions to transport is negligible.

Coupling between Ion Drift and Kinetics of Electronic Current Transients in MAPbBr3 Single Crystals.

The optoelectronic properties of halide perovskite materials have fostered their utilization in many applications. Unravelling their working mechanisms remains challenging because of their mixed ionic-electronic conductive nature. By registering, with high reproducibility, the long-time current transients of a set of single-crystal methylammonium lead tribromide samples, the ion migration process was proved. Sample biasing experiments (ionic drift), with characteristic times exhibiting voltage dependence as ∝ V -3/2, is interpreted with an ionic migration model obeying a ballistic-like voltage-dependent mobility (BVM) regime of space-charge-limited current. Ionic kinetics effectively modify the long-time electronic current, while the steady-state electronic currents' behavior is nearly ohmic. Using the ionic dynamic doping model (IDD) for the recovering current at zero bias (ion diffusion), the ionic mobility is estimated to be ∼10-6 cm2 V-1 s-1. Our findings suggest that ionic currents are negligible in comparison to the electronic currents; however, they influence them via changes in the charge density profile.

Mobile Ion-Driven Modulation of Electronic Conductivity Explains Long-Timescale Electrical Response in Lead Iodide Perovskite Thick Pellets.

The favorable optoelectronic properties of metal halide perovskites have been used for X- and γ-ray detection, solar energy, and optoelectronics. Large electronic mobility, reduced recombination losses of the electron-hole pairs, and high sensitivity upon ionizing irradiation have fostered great attention on technological realizations. Nevertheless, the recognized mixed ionic-electronic transport properties of hybrid perovskites possess severe limitations as far as long-timescale instabilities and degradation issues are faced. Several effects are attributed to the presence of mobile ions such as shielding of the internal electrical field upon biasing and chemical interaction between intrinsic moving defects and electrode materials. Ion-originated modulations of electronic properties constitute an essential peace of knowledge to further progress into the halide perovskite device physics and operating modes. Here, ionic current and electronic impedance of lead methylammonium iodide perovskite thick pellets are independently monitored, showing self-consistent patterns. Our findings point to a coupling of ionic and electronic properties as a dynamic doping effect caused by moving ions that act as mobile dopants. The electronic doping profile changes within the bulk as a function of the actual ion inner distribution, then producing a specific time dependence in the electronic conductivity that reproduces time patterns of the type ∝t, a clear fingerprint of diffusive transport. Values for the iodine-related defect diffusivity in the range of Dion ∼ 10-8 cm2 s-1, which corresponds to ionic mobilities of about µion ∼ 10-6 cm2 V-1 s-1, are encountered. Technological realizations based on thick perovskite layers would benefit from this fundamental information, as far as long-timescale current stabilization is concerned.

Unraveling the Microstructure-Related Device Stability for Polymer Solar Cells Based on Nonfullerene Small-Molecular Acceptors.

As the power conversion efficiency (PCE) of organic solar cells (OSCs) has surpassed the 17% baseline, the long-term stability of highly efficient OSCs is essential for the practical application of this photovoltaic technology. Here, the photostability and possible degradation mechanisms of three state-of-the-art polymer donors with a commonly used nonfullerene acceptor (NFA), IT-4F, are investigated. The active-layer materials show excellent intrinsic photostability. The initial morphology, in particular the mixed region, causes degradation predominantly in the fill factor (FF) under illumination. Electron traps are formed due to the reorganization of polymers and diffusion-limited aggregation of NFAs to assemble small isolated acceptor domains under illumination. These electron traps lead to losses mainly in FF, which is in contradistinction to the degradation mechanisms observed for fullerene-based OSCs. Control of the composition of NFAs close to the thermodynamic equilibrium limit while keeping adequate electron percolation and improving the initial polymer and NFA ordering are of the essence to stabilize the FF in NFA-based solar cells, which may be the key tactics to develop next-generation OSCs with high efficiency as well as excellent stability.

Electrical-Field-Driven Tunable Spectral Responses in a Broadband-Absorbing Perovskite Photodiode.

Controllably manipulating the spectral response of broadband-absorbing semiconductors is crucial for developing wavelength-selective optoelectronic devices. In this article, we report for the first time, the bias-dependent spectral responses for a metal-halide perovskite photodiode. Tunable external quantum efficiencies in the short- and long-wavelength regimes, and the full spectral range (ca. 300-800 nm) are observed when the device is operated under short-circuit, and forward and reverse bias conditions, respectively. This observation is understood by the interplay of wavelength-dependent penetration depth and barrier formation within the photodiode device stack. The general applicability of this concept is confirmed by a systematic study on a series of mixed-halide perovskite devices. These results suggest that the proposed concept allows as a promising platform and should inspire further exploration of multispectral responsive optoelectronic devices.

Utilization of Temperature-Sweeping Capacitive Techniques to Evaluate Band Gap Defect Densities in Photovoltaic Perovskites.

Capacitive techniques, routinely used for solar cell parameter extraction, probe the voltage-modulation of the depletion layer capacitance isothermally as well as under varying temperature. In addition, defect states within the semiconductor band gap respond to such stimuli. Although extensively used, capacitive methods have found difficulties when applied to elucidating bulk defect bands in photovoltaic perovskites. This is because perovskite solar cells (PSCs) actually exhibit some intriguing capacitive features hardly connected to electronic defect dynamics. The commonly reported excess capacitance observed at low frequencies is originated by outer interface mechanisms and has a direct repercussion on the evaluation of band gap defect levels. Starting by updating previous observations on Mott-Schottky analysis in PSCs, it is discussed how the thermal admittance spectroscopy and the deep level transient spectroscopy characterization techniques present spectra with overlapping or even "fake" peaks caused by the mobile ion-related, interfacial excess capacitance. These capacitive techniques, when used uncritically, may be misleading and produce wrong outcomes.

Comprehensive Investigation and Analysis of Bulk-Heterojunction Microstructure of High-Performance PCE11:PCBM Solar Cells.

Worldwide research efforts have been devoted to organic photovoltaics in the hope of a large-scale commercial application in the near future. To meet the industrial production requirements, organic photovoltaics that can reach power conversion efficiency (PCE) of over 10% along with promising operational device stability are of utmost interest. In the study, we take PCE11:PCBM as a model system, which can achieve over 11% PCE when processed from nonhalogen solvents, to deeply investigate the morphology-performance-stability correlation. We demonstrate that four batches of PCE11 with varying crystalline properties can achieve similar high performance in combination with PCBM. Careful device optimization is necessary in each case to properly address the requirements for the quite distinct microstructures. The bulk-heterojunction (BHJ) microstructure is comprehensively investigated as a function of the macromolecular weight and crystallinity. It is demonstrated that small differences in morphology significantly affect the kinetics and thermodynamic equilibrium of the BHJ microstructure as well as the photostability and thermal stability of the PCE11:PCBM solar cells.

Surface Polarization Model for the Dynamic Hysteresis of Perovskite Solar Cells.

The dynamic hysteresis of perovskite solar cells consists of the occurrence of significant deviations of the current density-voltage curve shapes depending on the specific conditions of measurement such as starting voltage, waiting time, scan rate, and other factors. Dynamic hysteresis is a serious impediment to stabilized and reliable measurement and operation of the perovskite solar cells. In this Letter, we formulate a model for the dynamic hysteresis based on the idea that the cell accumulates a huge quantity of surface electronic charge at forward bias that is released on voltage sweeping, causing extra current over the normal response. The charge shows a retarded dynamics due to the slow relaxation of the accompanying ionic charge, that produces variable shapes depending on scan rate or poling value and time. We show that the quantitative model provides a consistent description of experimental results and allows us to determine significant parameters of the perovskite solar cell for both the transient and steady-state performance.

Analysis of the Hysteresis Behavior of Perovskite Solar Cells with Interfacial Fullerene Self-Assembled Monolayers.

The use of self-assembled monolayers (SAMs) of fullerene derivatives reduces the hysteresis of perovskite solar cells (PSCs). We have investigated three different fullerene derivatives observing a decrease on hysteresis for all the cases. Several processes can contribute to the hysteresis behavior on PSCs. We have determined that the reduced hysteresis observed for devices with SAMs is produced by a decrease of the capacitive hysteresis. In addition, with an appropriated functionalization, SAMs can increase photocurrent even when no electron selective contact (ESC) is present and a SAM is deposited just on top of the transparent conductive oxide. Appropriated functionalization of the fullerene derivative, as introducing -CN groups, can enhance cell performance and reduce hysteresis. This work paves the way for a future enhancement of PSCs by a tailored design of the fullerene molecules that could actuate as an ESC by themselves.

Polarization Switching and Light-Enhanced Piezoelectricity in Lead Halide Perovskites.

We investigate the ferroelectric properties of photovoltaic methylammonium lead halide CH3NH3PbI3 perovskite using piezoelectric force microscopy (PFM) and macroscopic polarization methods. The electric polarization is clearly observed by amplitude and phase hysteresis loops. However, the polarization loop decreases as the frequency is lowered, persisting for a short time only, in the one second regime, indicating that CH3NH3PbI3 does not exhibit permanent polarization at room temperature. This result is confirmed by macroscopic polarization measurement based on a standard capacitive method. We have observed a strong increase of piezoelectric response under illumination, consistent with the previously reported giant photoinduced dielectric constant at low frequencies. We speculate that an intrinsic charge transfer photoinduced dipole in the perovskite cage may lie at the origin of this effect.

Capacitive Dark Currents, Hysteresis, and Electrode Polarization in Lead Halide Perovskite Solar Cells.

Despite spectacular advances in conversion efficiency of perovskite solar cell many aspects of its operating modes are still poorly understood. Capacitance constitutes a key parameter to explore which mechanisms control particular functioning and undesired effects as current hysteresis. Analyzing capacitive responses allows addressing not only the nature of charge distribution in the device but also the kinetics of the charging processes and how they alter the solar cell current. Two main polarization processes are identified. Dielectric properties of the microscopic dipolar units through the orthorhombic-to-tetragonal phase transition account for the measured intermediate frequency capacitance. Electrode polarization caused by interfacial effects, presumably related to kinetically slow ions piled up in the vicinity of the outer interfaces, consistently explain the reported excess capacitance values at low frequencies. In addition, current-voltage curves and capacitive responses of perovskite-based solar cells are connected. The observed hysteretic effect in the dark current originates from the slow capacitive mechanisms.