New Benzotriazole and Benzodithiophene-Based Conjugated Terpolymer Bearing a Fluorescein Derivative as Side-Group: In-Ternal Förster Resonance Energy Transfer to Improve Organic Solar Cells.

A new benzodithiophene and benzotriazole-based terpolymer bearing a fluorescein derivative as a side group was synthesized and studied for organic solar cell (OSC) applications. This side group was covalently bounded to the backbone through an n-hexyl chain to induce the intramolecular Förster Resonance Energy Transfer (FRET) process and thus improve the photovoltaic performance of the polymeric material. The polymer exhibited good solubility in common organic chlorinated solvents as well as thermal stability (TDT10% > 360 °C). Photophysical measurements demonstrated the occurrence of the FRET phenomenon between the lateral group and the terpolymer. The terpolymer exhibited an absorption band centered at 501 nm, an optical bandgap of 2.02 eV, and HOMO and LUMO energy levels of −5.30 eV and −3.28 eV, respectively. A preliminary study on terpolymer-based OSC devices showed a low power-conversion efficiency (PCE) but a higher performance than devices based on an analogous polymer without the fluorescein derivative. These results mean that the design presented here is a promising strategy to improve the performance of polymers used in OSCs.

Synthesis and Characterization of a 2,3-Dialkoxynaphthalene-Based Conjugated Copolymer via Direct Arylation Polymerization (DAP) for Organic Electronics.

Poly[(5,5'-(2,3-bis(2-ethylhexyloxy)naphthalene-1,4-diyl)bis(thiophene-2,2'-diyl))-alt-(2,1,3-benzothiadiazole-4,7-diyl)] (PEHONDTBT) was synthesized for the first time and through direct arylation polymerization (DAP) for use as p-donor material in organic solar cells. Optimized reaction protocol leads to a donor-acceptor conjugated polymer in good yield, with less structural defects than its analog obtained from Suzuki polycondensation, and with similar or even higher molecular weight than other previously reported polymers based on the 2,3-dialkoxynaphthalene monomer. The batch-to-batch repeatability of the optimized DAP conditions for the synthesis of PEHONDTBT was proved, showing the robustness of the synthetic strategy. The structure of PEHONDTBT was corroborated by NMR, exhibiting good solubility in common organic solvents, good film-forming ability, and thermal stability. PEHONDTBT film presented an absorption band centered at 498 nm, a band gap of 2.15 eV, and HOMO and LUMO energy levels of -5.31 eV and -3.17 eV, respectively. Theoretical calculations were performed to understand the regioselectivity in the synthesis of PEHONDTBT and to rationalize its optoelectronic properties. Bilayer heterojunction organic photovoltaic devices with PEHONDTBT as the donor layer were fabricated to test their photovoltaic performance, affording low power-conversion efficiency in the preliminary studies.

Doped Poly(3-hexylthiophene) Coatings onto Chitosan: A Novel Approach for Developing a Bio-Based Flexible Electronic.

Conductive and flexible bio-based materials consisting of chitosan films coated with conductive poly(3-hexylthiophene) (P3HT) were prepared. Thermal, optical, mechanical, morphological, wettability, and conductive properties were analyzed. In a very simple and effective method of chitosan film modification, a controlled volume of a P3HT solution was deposited onto a previously formed chitosan film, assisted by the spin coating method. Later, P3HT-coated chitosan films were doped by simple contact with an aqueous solution of HAuCl4. The use of HAuCl4 becomes attractive because the reports on the doping process in this type of material using this reagent are still scarce and recent to date. In addition, since this acid is a well-known metal nanoparticle precursor, its use opens new future perspectives for these materials into new applications. The effect of P3HT concentration and doping times on film properties was studied. Attenuated total reflectance spectroscopy and UV-Vis spectroscopy allowed us to demonstrate that the presence of the P3HT coating and its doping induce significant changes in the vibrational modes and optoelectronic properties of samples. Additionally, the images obtained by scanning electron microscopy showed a well-distributed and homogeneous coating on the surface of chitosan films. Measured conductivity values of doped film samples fall in the range from 821.3 to 2017.4 S/m, representing, to the best of our knowledge, the highest values reported in the literature for chitosan/chitin-based materials. Indeed, these values are around or even higher than those obtained for some materials purely consisting of conductive polymers.

Synthesis of Amorphous Monomeric Glass Mixtures for Organic Electronic Applications.

We report a divergent synthetic strategy and novel design concept that exploit molecular mixtures to create amorphous organic charge-transporting glasses. Using Suzuki-Miyaura cross-coupling reactions, we synthesized well-defined molecular mixtures in a single step. These solution-processable materials are noncrystalline and show good thermal and morphological stabilities. Moreover, they have robust hole and electron mobilities, which make them excellent candidate materials for organic light-emitting diodes. Our general strategy enables the facile synthesis of noncrystalline materials with well-controlled electronic properties.