N-doped oxidized carbon dots for methanol sensing in alcoholic beverages.

Methanol (MeOH) adulteration in alcoholic beverages resulting in irreparable health damage demands highly sensitive and cost-effective sensors for its quantification. As carbon dots are emerging as new biocompatible and sustainable light-emitting detectors, this work demonstrates the hydrothermally prepared nitrogen-doped oxidized carbon dots (NOCDs) as on-off fluorescent nanoprobes to detect MeOH traces in water and alcoholic beverages. The presence of 1% of MeOH in distilled water is found to decrease the NOCD fluorescent emission intensity by more than 90% whereas up to 70% ethanol (EtOH) content changes the signal to within 20% of its initial value. HR-TEM analysis reveals the agglomeration of the nanoprobes suspended in MeOH. Due to their selectivity towards MeOH, the fluorescent nanoprobes were successfully tested using a few MeOH spiked branded and unbranded Mexican alcoholic beverages. Varying degrees of signal quenching is observed from the fluorescent nanoprobes dispersed in different pristine beverages with a detection limit of less than 0.11 v%. Herein, we establish a new perspective towards economically viable non-toxic fluorescent probes as a potential alternative for the detection of MeOH in alcoholic beverages.

Cu2ZnSn(S,Se)4 thin-films prepared from selenized nanocrystals ink.

For the first time, CZTS ink was formulated using low-temperature heating up synthesis of NCs. Besides, the influence of powder concentration on the properties of the films was examined. Subsequently, the CZTS films were annealed under a selenium (Se)/argon (Ar) atmosphere at different temperatures to enhance their properties. The influence of selenization temperature on the properties of CZTS films was examined in detail. Structural analysis showed a peak shift towards lower 2θ values for CZTSSe films because of Se incorporation, resulting in larger lattice parameters for CZTSSe than CZTS. As the selenization temperature increases, an increment in the grain size was observed and the band gap was decreased from 1.52 to 1.05 eV. Hall Effect studies revealed a significant improvement in the mobility and carrier concentration with respect to selenization temperatures. Moreover, film selenized at 550 °C exhibited higher photoconductivity as compared to other films, indicating their potential application in the field of low-cost thin-film solar cells.

Solution based synthesis of Cu(In,Ga)Se2 microcrystals and thin films.

Herein, for the first time, we report the synthesis of quaternary Cu(In,Ga)Se2 microcrystals (CIGSe MCs) using a facile and economical one-pot heating-up method. The most important parameters such as reaction temperature and time were varied to study their influences on the structural, morphological, compositional and optical properties of the MCs. Based on the results, the formation of CIGSe was initiated from binary ß-CuSe and then converted into pure phase CIGSe by gradual incorporation of In3+ and Ga3+ ions into the ß-CuSe crystal lattice. As the reaction time increases, the band gap energy was increased from 1.10 to 1.28 eV, whereas the size of the crystals increased from 0.9 to 3.1 µm. Besides, large-scale synthesis of CIGSe MCs exhibited a high reaction yield of 90%. Furthermore, the CIGSe MCs dispersed in the ethanol was coated as thin films by a drop casting method, which showed the optimum carrier concentration, high mobility and low resistivity. Moreover, the photoconductivity of the CIGSe MC thin film was enhanced by three order magnitude in comparison with CIGSe NC thin films. The solar cells fabricated with CIGSe MCs showed the PCE of 0.59% which is 14.75 times higher than CIGSe NCs. These preliminary results confirmed the potential of CIGSe MCs as an active absorber layer in low-cost thin film solar cells.

Increased hyperalgesia by 5-nitro-2, 3-(phenylpropylamino)-benzoic acid (NPPB), a chloride channel blocker in crush injury-induced neuropathic pain in rats.

Chloride channels belong to diverse group of anion selective channels involved in different signaling processes. The present study was planned to investigate the involvement of chloride channels in crush injury-induced neuropathic pain in rats by using ivermectin, a ligand gated chloride channel opener and NPPB, a CaCC blocker. The effect of ivermectin (5, 10, 20 mg/kg i.p. or 50, 100 and 200 microg/rat by i.c.v. route) and NPPB (10, 20 and 40 mg/kg i.p.) was investigated on pain behavioural thresholds in crush injury-induced neuropathic pain rat model. Reduction in pain threshold by mechanical, thermal and cold stimuli confirmed the development of neuropathic pain in rats after crush injury. Ivermectin administered either by i.p. or i.c.v. route did not alter the pain threshold in mechanical, thermal and, cold allodynia tests in rats. NPPB (20 and 40 mg/kg i.p.) significantly reduced the pain threshold crush injury neuropathic pain model suggesting its hyperalgesic effect. The results showed that NPPB increased significantly the mechanical and thermal hyperalgesia in crush injury-induced neuropathic pain rat model, whereas ivermectin, either by i.p. or i.c.v. route of administration, has no effect on pain symptoms in this model. NPPB hyperalgesic effect is independent of CaCCs inhibition and may be due to blockade of Ca2+-activated K+ channel.