EPR and Structural Characterization of Water-Soluble Mn2+-Doped Si Nanoparticles.

Water-soluble poly(allylamine) Mn2+-doped Si (SiMn) nanoparticles (NPs) were prepared and show promise for biologically related applications. The nanoparticles show both strong photoluminescence and good magnetic resonance contrast imaging. The morphology and average diameter were obtained through transmission electron microscopy (TEM) and high-resolution transmission electron microscopy (HRTEM); spherical crystalline Si NPs with an average diameter of 4.2 ± 0.7 nm were observed. The doping maximum obtained through this process was an average concentration of 0.4 ± 0.3% Mn per mole of Si. The water-soluble SiMn NPs showed a strong photoluminescence with a quantum yield up to 13%. The SiMn NPs had significant T1 contrast with an r1 relaxivity of 11.1 ± 1.5 mM-1 s-1 and r2 relaxivity of 32.7 ± 4.7 mM-1 s-1 where the concentration is in mM of Mn2+. Dextran-coated poly(allylamine) SiMn NPs produced NPs with T1 and T2 contrast with a r1 relaxivity of 27.1 ± 2.8 mM-1 s-1 and r2 relaxivity of 1078.5 ± 1.9 mM-1 s-1. X-band electron paramagnetic resonance spectra are fit with a two-site model demonstrating that there are two types of Mn2+ in these NP's. The fits yield hyperfine splittings (A) of 265 and 238 MHz with significant zero field splitting (D and E terms). This is consistent with Mn in sites of symmetry lower than tetrahedral due to the small size of the NP's.

Cytotoxicity of surface-functionalized silicon and germanium nanoparticles: the dominant role of surface charges.

Although it is frequently hypothesized that surface (like surface charge) and physical characteristics (like particle size) play important roles in cellular interactions of nanoparticles (NPs), a systematic study probing this issue is missing. Hence, a comparative cytotoxicity study, quantifying nine different cellular endpoints, was performed with a broad series of monodisperse, well characterized silicon (Si) and germanium (Ge) NPs with various surface functionalizations. Human colonic adenocarcinoma Caco-2 and rat alveolar macrophage NR8383 cells were used to clarify the toxicity of this series of NPs. The surface coatings on the NPs appeared to dominate the cytotoxicity: the cationic NPs exhibited cytotoxicity, whereas the carboxylic acid-terminated and hydrophilic PEG- or dextran-terminated NPs did not. Within the cationic Si NPs, smaller Si NPs were more toxic than bigger ones. Manganese-doped (1% Mn) Si NPs did not show any added toxicity, which favors their further development for bioimaging. Iron-doped (1% Fe) Si NPs showed some added toxicity, which may be due to the leaching of Fe(3+) ions from the core. A silica coating seemed to impart toxicity, in line with the reported toxicity of silica. Intracellular mitochondria seem to be the target for the toxic NPs since a dose-, surface charge- and size-dependent imbalance of the mitochondrial membrane potential was observed. Such an imbalance led to a series of other cellular events for cationic NPs, like decreased mitochondrial membrane potential (ΔΨm) and ATP production, induction of ROS generation, increased cytoplasmic Ca(2+) content, production of TNF-α and enhanced caspase-3 activity. Taken together, the results explain the toxicity of Si NPs/Ge NPs largely by their surface characteristics, provide insight into the mode of action underlying the observed cytotoxicity, and give directions on synthesizing biocompatible Si and Ge NPs, as this is crucial for bioimaging and other applications in for example the field of medicine.

Chemical insight into the origin of red and blue photoluminescence arising from freestanding silicon nanocrystals.

Silicon nanocrystals (Si NCs) are attractive functional materials. They are compatible with standard electronics and communications platforms and are biocompatible. Numerous methods have been developed to realize size-controlled Si NC synthesis. While these procedures produce Si NCs that appear identical, their optical responses can differ dramatically. Si NCs prepared using high-temperature methods routinely exhibit photoluminescence agreeing with the effective mass approximation (EMA), while those prepared via solution methods exhibit blue emission that is somewhat independent of particle size. Despite many proposals, a definitive explanation for this difference has been elusive for no less than a decade. This apparent dichotomy brings into question our understanding of Si NC properties and potentially limits the scope of their application. The present contribution takes a substantial step forward toward identifying the origin of the blue emission that is not expected based upon EMA predictions. It describes a detailed comparison of Si NCs obtained from three of the most widely cited procedures as well as the conversion of red-emitting Si NCs to blue emitters upon exposure to nitrogen-containing reagents. Analysis of the evidence is consistent with the hypothesis that the presence of trace nitrogen and oxygen even at the parts per million level in Si NCs gives rise to the blue emission.

Synthesis of long T1 silicon nanoparticles for hyperpolarized ²9Si magnetic resonance imaging.

We describe the synthesis, materials characterization, and dynamic nuclear polarization (DNP) of amorphous and crystalline silicon nanoparticles for use as hyperpolarized magnetic resonance imaging (MRI) agents. The particles were synthesized by means of a metathesis reaction between sodium silicide (Na4Si4) and silicon tetrachloride (SiCl4) and were surface functionalized with a variety of passivating ligands. The synthesis scheme results in particles of diameter ∼10 nm with long size-adjusted ²9Si spin-lattice relaxation (T1) times (>600 s), which are retained after hyperpolarization by low-temperature DNP.

An efficient microwave-assisted synthesis method for the production of water soluble amine-terminated Si nanoparticles.

Silicon nanoparticles can be considered a green material, especially when prepared via a microwave-assisted method without the use of highly reactive reducing agents or hydrofluoric acid. A simple solution synthesis of hydrogen-terminated Si- and Mn-doped Si nanoparticles via microwave-assisted synthesis is demonstrated. The reaction of the Zintl salt, Na(4)Si(4), or Mn-doped Na(4)Si(4), Na(4)Si(4(Mn)), with ammonium bromide, NH(4)Br, produces small dispersible nanoparticles along with larger particles that precipitate. Allylamine and 1-amino-10-undecene were reacted with the hydrogen-terminated Si nanoparticles to provide water solubility and stability. A one-pot, single-reaction process and a one-pot, two-step reaction process were investigated. Details of the microwave-assisted process are provided, with the optimal synthesis being the one-pot, two-step reaction procedure and a total time of about 15 min. The nanoparticles were characterized by transmission electron microscopy (TEM), x-ray diffraction, and fluorescence spectroscopies. The microwave-assisted method reliably produces a narrow size distribution of Si nanoparticles in solution.

Development of iron-doped silicon nanoparticles as bimodal imaging agents.

We demonstrate the synthesis of water-soluble allylamine-terminated Fe-doped Si (Si(xFe)) nanoparticles as bimodal agents for optical and magnetic imaging. The preparation involves the synthesis of a single-source iron-containing precursor, Na(4)Si(4) with x% Fe (x = 1, 5, 10), and its subsequent reaction with NH(4)Br to produce hydrogen-terminated Si(xFe) nanoparticles. The hydrogen-capped nanoparticles are further terminated with allylamine via thermal hydrosilylation. Transmission electron microscopy indicates that the average particle diameter is ∼3.0 ± 1.0 nm. The Si(5Fe) nanoparticles show strong photoluminescence quantum yield in water (∼10%) with significant T(2) contrast (r(2)/r(1) value of 4.31). Electron paramagnetic resonance and Mössbauer spectroscopies indicate that iron in the nanoparticles is in the +3 oxidation state. Analysis of cytotoxicity using the resazurin assay on HepG2 liver cells indicates that the particles have minimal toxicity.

Rapid microwave-assisted synthesis of dextran-coated iron oxide nanoparticles for magnetic resonance imaging.

Currently, magnetic iron oxide nanoparticles are the only nanosized magnetic resonance imaging (MRI) contrast agents approved for clinical use, yet commercial manufacturing of these agents has been limited or discontinued. Though there is still widespread demand for these particles both for clinical use and research, they are difficult to obtain commercially, and complicated syntheses make in-house preparation unfeasible for most biological research labs or clinics. To make commercial production viable and increase accessibility of these products, it is crucial to develop simple, rapid and reproducible preparations of biocompatible iron oxide nanoparticles. Here, we report a rapid, straightforward microwave-assisted synthesis of superparamagnetic dextran-coated iron oxide nanoparticles. The nanoparticles were produced in two hydrodynamic sizes with differing core morphologies by varying the synthetic method as either a two-step or single-step process. A striking benefit of these methods is the ability to obtain swift and consistent results without the necessity for air-, pH- or temperature-sensitive techniques; therefore, reaction times and complex manufacturing processes are greatly reduced as compared to conventional synthetic methods. This is a great benefit for cost-effective translation to commercial production. The nanoparticles are found to be superparamagnetic and exhibit properties consistent for use in MRI. In addition, the dextran coating imparts the water solubility and biocompatibility necessary for in vivo utilization.

Femtosecond ligand/core dynamics of microwave-assisted synthesized silicon quantum dots in aqueous solution.

A microwave-assisted reaction has been developed to produce hydrogen-terminated silicon quantum dots (QDs). The Si QDs were passivated for water solubility via two different methods: hydrosilylation produced 3-aminopropenyl-terminated Si QDs, and a modified Stöber process produced silica-encapsulated Si QDs. Both methods produce water-soluble QDs with maximum emission at 414 nm, and after purification, the QDs exhibit intrinsic fluorescence quantum yield efficiencies of 15 and 23%, respectively. Even though the QDs have different surfaces, they exhibit nearly identical absorption and fluorescence spectra. Femtosecond transient absorption spectroscopy was used for temporal resolution of the photoexcited carrier dynamics between the QDs and ligand. The transient dynamics of the 3-aminopropenyl-terminated Si QDs is interpreted as a formation and decay of a charge-transfer (CT) excited state between the delocalized π electrons of the carbon linker and the Si core excitons. This CT state is stable for ~4 ns before reverting back to a more stable, long-living species. The silica-encapsulated Si QDs show a simpler spectrum without CT dynamics.

Synthesis and thermolytic behavior of tin(IV) formates: in search of recyclable metal-hydride systems.

The synthesis and characterization of the series of organotin formates together with their thermolytic behavior are described. The diformate Bu(n)(2)Sn{OC(O)H}(2) (1) was synthesized by the reaction of Bu(n)(2)SnH(2) with formic acid. The triorganotin monoformate compounds R(3)SnOC(O)H (R = Cy (cyclohexyl)) 3, Mes, (mesityl, 2,4,6-trimethylphenyl) 4, and Dmp (2,6-dimethylphenyl 5) were obtained by the reaction of R(3)SnOH with formic acid. Their X-ray crystal structures along with that of the previously reported formate (PhCH(2))(3)SnOC(O)H (2) were determined. The diformate 1 exhibits an extended two-dimensional polymeric structure in which six-coordinate tin centers are linked by formate bridges. The tribenzyltin formate (2) possesses a chain structure in which the five-coordinate Sn(CH(2)Ph)(3) units are bridged by formate ions. The cyclohexyl derivative 3 was observed to have a similar structure. In contrast, the Mes and Dmp derivatives 4 and 5 support monomeric structures in which the four-coordinate tin atom is bound to an oxygen of the formate ligand. Heating the compounds in various high boiling solvents produced no decomposition up to 120 °C in the case of 1 and refluxing a solution of 2 or 3 in mesitylene or diglyme left the starting material mostly unchanged, although 3 decomposed to an insoluble orange solid in refluxing decalin. In contrast, the heating of 4 and 5 in refluxing mesitylene led to elimination of CO to give the tin hydroxides. The results are in contrast to the known thermolytic behavior of R(3)SnOC(O)H (R = Pr(n) or Bu(n)) complexes, which eliminate CO(2) to generate R(3)SnH. Compounds 3-5 are rare examples of structurally characterized tin formates.

A versatile low temperature synthetic route to Zintl phase precursors: Na4Si4, Na4Ge4 and K4Ge4 as examples.

Na(4)Si(4) and Na(4)Ge(4) are ideal chemical precursors for inorganic clathrate structures, clusters, and nanocrystals. The monoclinic Zintl phases, Na(4)Si(4) and Na(4)Ge(4), contain isolated homo-tetrahedranide [Si(4)](4-) and [Ge(4)](4-) clusters surrounded by alkali metal cations. In this study, a simple scalable route has been applied to prepare Zintl phases of composition Na(4)Si(4) and Na(4)Ge(4) using the reaction between NaH and Si or Ge at low temperature (420 degrees C for Na(4)Si(4) and 270 degrees C for Na(4)Ge(4)). The method was also applied to K(4)Ge(4), using KH and Ge as raw materials, to show the versatility of this approach. The influence of specific reaction conditions on the purity of these Zintl phases has been studied by controlling five factors: the method of reagent mixing (manual or ball milled), the stoichiometry between raw materials, the reaction temperature, the heating time and the gas flow rate. Moderate ball-milling and excess NaH or KH facilitate the formation of pure Na(4)Si(4), Na(4)Ge(4) or K(4)Ge(4) at 420 degrees C (Na(4)Si(4)) or 270 degrees C (both M(4)Ge(4) compounds, M = Na, K). TG/DSC analysis of the reaction of NaH and Ge indicates that ball milling reduces the temperature for reaction and confirms the formation temperature. This method provides large quantities of high quality Na(4)Si(4) and Na(4)Ge(4) without the need for specialized laboratory equipment, such as Schlenk lines, niobium/tantalum containers, or an arc welder, thereby expanding the accessibility and chemical utility of these phases by making them more convenient to prepare. This new synthetic method may also be extended to lithium-containing Zintl phases (LiH is commercially available) as well as to alkali metal-tetrel Zintl compounds of other compositions, e.g. K(4)Ge(9).