Mass transport of lipopolysaccharide induced H2O2 detected by an intracellular carbon nanoelectrode sensor.

Hydrogen peroxide is a key component of the innate immune response, regulating how a cell responds to a bacterial threat; however, being transient in nature makes it extremely difficult to detect. We show the development of an improved biosensor capable of the rapid detection of the hydrogen peroxide produced intracellularly in response to both smooth and rough lipopolysaccharides (LPS) structures. The arising signal and mass transport behaviour to the electrodes were characterised. This response was detected utilising a single walled carbon nanotube-based sensor that has been functionalised with an osmium complex for specificity and detecting the change in intracellular concentrations of hydrogen peroxide through chronoamperometry. This was conducted within murine macrophage (RAW264.7) cells and using ultra-pure LPS extracted from two different serotypes of bacteria (0111:B4 and Re495). This allowed the comparison of the immune response when infected with different structures of LPS. We demonstrate that the hydrogen peroxide signal can be electrochemically detected within 3 seconds post injection. Combining the nature of the mass transport of hydrogen peroxide and concentration characteristics, a bacterial 'fingerprint' was identified. The impact of this work will be demonstrated in allowing us to develop a rapid diagnostic for bacterial detection.

Real-time bacterial detection with an intracellular ROS sensing platform.

Reactive oxygen species are highly reactive molecules that as well as being ubiquitously expressed throughout the body, are also known to be involved in many diseases and disorders including bacterial infection. Current technology has limited success in the accurate detection and identification of specific reactive oxygen species. To combat this, we have developed an electrochemical biosensor that is constructed from single walled carbon nanotubes that have been immobilised on an indium tin oxide surface functionalised with osmium-based compound. This sensor was integrated within mouse macrophage cells (RAW 264.7) with multiple serotypes of bacteria used to initiate an immune response. Intracellular hydrogen peroxide was then measured in response to the interaction of the lipopolysaccharides, present on the outer wall of Gram-negative bacteria, with the Toll-like Receptor 4. Additional controls of n-acetylcysteine and sodium pyruvate were implemented to prove the specificity of the sensor towards hydrogen peroxide. The sensors were found to have a lower limit of detection of 368 nM hydrogen peroxide. An increase in intracellular hydrogen peroxide was detected within 3 seconds of interaction of the bacteria with the macrophage cells. This low limit of detection combined with the rapid response of the sensor resulted in the unprecedented detection of hydrogen peroxide on a temporal level not previously seen in response to a bacterial threat. From the three serotypes of Gram-negative bacteria that were tested, there were distinct differences in hydrogen peroxide production. This proves that the innate immune system has the ability to respond dynamically and rapidly, after infection prior to the activation of the adaptive immune system.

Development of a SERS strategy to overcome the nanoparticle stabilisation effect in serum-containing samples: Application to the quantification of dopamine in the culture medium of PC-12 cells.

The analysis of serum samples by surface-enhanced Raman spectroscopy (SERS) has gained ground over the last few years. However, the stabilisation of colloids by the proteins contained in these samples has restricted their use in common practice, unless antibodies or aptamers are used. Therefore, this work was dedicated to the development of a SERS methodology allowing the analysis of serum samples in a simple and easy-to-implement way. This approach was based on the pre-aggregation of the colloid with a salt solution. Gold nanoparticles (AuNPs) were used as the SERS substrate and, owing to its physiopathological importance, dopamine was chosen as a model to implement the SERS approach. The presence of this neurotransmitter could be determined in the concentration range 0.5-50 ppm (2.64-264 µM) in the culture medium of PC-12 cells, with a R2 of 0.9874, and at even lower concentrations (0.25 ppm, 1.32 µM) in another matrix containing fewer proteins. Moreover, the effect of calcium and potassium on the dopamine exocytosis from PC-12 cells was studied. Calcium was shown to have a predominant and dose-dependant effect. Finally, PC-12 cells were exposed to dexamethasone in order to increase their biosynthesis and release of dopamine. This increase was monitored with the developed SERS approach.

Electrochemical communication with the inside of cells using micro-patterned vertical carbon nanofibre electrodes.

With the rapidly increasing demands for ultrasensitive biodetection, the design and applications of new nano-scale materials for development of sensors based on optical and electrochemical transducers have attracted substantial interest. In particular, given the comparable sizes of nanomaterials and biomolecules, there exist plenty of opportunities to develop functional nanoprobes with biomolecules for highly sensitive and selective biosensing, shedding new light on cellular behaviour. Towards this aim, herein we interface cells with patterned nano-arrays of carbon nanofibers forming a nanosensor-cell construct. We show that such a construct is capable of electrochemically communicating with the intracellular environment.

A novel electrospun biphasic scaffold provides optimal three-dimensional topography for in vitro co-culture of airway epithelial and fibroblast cells.

Conventional airway in vitro models focus upon the function of individual structural cells cultured in a two-dimensional monolayer, with limited three-dimensional (3D) models of the bronchial mucosa. Electrospinning offers an attractive method to produce defined, porous 3D matrices for cell culture. To investigate the effects of fibre diameter on airway epithelial and fibroblast cell growth and functionality, we manipulated the concentration and deposition rate of the non-degradable polymer polyethylene terephthalate to create fibres with diameters ranging from nanometre to micrometre. The nanofibre scaffold closely resembles the basement membrane of the bronchiole mucosal layer, and epithelial cells cultured at the air-liquid interface on this scaffold showed polarized differentiation. The microfibre scaffold mimics the porous sub-mucosal layer of the airway into which lung fibroblast cells showed good penetration. Using these defined electrospinning parameters we created a biphasic scaffold with 3D topography tailored for optimal growth of both cell types. Epithelial and fibroblast cells were co-cultured onto the apical nanofibre phase and the basal microfibre phase respectively, with enhanced epithelial barrier formation observed upon co-culture. This biphasic scaffold provides a novel 3D in vitro platform optimized to mimic the different microenvironments the cells encounter in vivo on which to investigate key airway structural cell interactions in airway diseases such as asthma.

Conjugatable water-soluble Pt(II) and Pd(II) porphyrin complexes: novel nano- and molecular probes for optical oxygen tension measurement in tissue engineering.

Measurement of oxygen tension in compressed collagen sheets was performed using matrix-embedded optical oxygen sensors based on platinum(II) and palladium(II) porphyrins supported on polyacrylamide nanoparticles. Bespoke, fully water-soluble, mono-functionalised Pt(II) and Pd(II) porphyrin complexes designed for conjugation under mild conditions were obtained using microwave-assisted metallation. The new sensors display a linear response (1/τ vs. O2) to varying oxygen tension over a biologically relevant range (7.0 × 10(-4) to 2.7 × 10(-1) mM) in aqueous solutions; a behaviour that is maintained following conjugation to polyacrylamide nanoparticles, and following embedding of the nanosensors in compressed collagen sheets, paving the way to innovative approaches for real-time resolution of oxygen gradients throughout 3D matrices useful for tissue regeneration.

Human airway smooth muscle maintain in situ cell orientation and phenotype when cultured on aligned electrospun scaffolds.

Human airway smooth muscle (HASM) contraction plays a central role in regulating airway resistance in both healthy and asthmatic bronchioles. In vitro studies that investigate the intricate mechanisms that regulate this contractile process are predominantly conducted on tissue culture plastic, a rigid, 2D geometry, unlike the 3D microenvironment smooth muscle cells are exposed to in situ. It is increasingly apparent that cellular characteristics and responses are altered between cells cultured on 2D substrates compared with 3D topographies. Electrospinning is an attractive method to produce 3D topographies for cell culturing as the fibers produced have dimensions within the nanometer range, similar to cells' natural environment. We have developed an electrospun scaffold using the nondegradable, nontoxic, polymer polyethylene terephthalate (PET) composed of uniaxially orientated nanofibers and have evaluated this topography's effect on HASM cell adhesion, alignment, and morphology. The fibers orientation provided contact guidance enabling the formation of fully aligned sheets of smooth muscle. Moreover, smooth muscle cells cultured on the scaffold present an elongated cell phenotype with altered contractile protein levels and distribution. HASM cells cultured on this scaffold responded to the bronchoconstrictor bradykinin. The platform presented provides a novel in vitro model that promotes airway smooth muscle cell development toward a more in vivo-like phenotype while providing topological cues to ensure full cell alignment.

Orthogonally bifunctionalised polyacrylamide nanoparticles: a support for the assembly of multifunctional nanodevices.

Polyacrylamide nanoparticles bearing two orthogonal reactive functionalities were prepared by reverse microemulsion polymerisation. Water-soluble photosensitisers and peptide or carbohydrate moieties were sequentially attached to the new nanospecies by orthogonal conjugations based on copper-catalysed azide-alkyne cycloaddition and isothiocyanate chemistry.

The delivery of PEBBLE nanosensors to measure the intracellular environment.

Cellular introduction of PEBBLEs (photonic explorers for bioanalysis with biologically localized embedding) has been investigated by a wide variety of methods in a range of cell types. These methods include surface functionalization with CPPs (cell-penetrating peptides), pinocytosis, commercial lipid transfection agents, cytochalasin D, picoinjection, and Gene gun bombardment. This paper will overview several of the most popular methods used for the introduction of PEBBLE nanosensors to the cellular environment and discuss the efficacy of the techniques.

A real-time ratiometric method for the determination of molecular oxygen inside living cells using sol-gel-based spherical optical nanosensors with applications to rat C6 glioma.

The first sol-gel-based, ratiometric, optical nanosensors, or sol-gel probes encapsulated by biologically localized embedding (PEBBLEs), are made and demonstrated here to enable reliable, real-time measurements of subcellular molecular oxygen. Sensors were made using a modified Stöber method, with poly(ethylene glycol) as a steric stabilizer. The radii of these spherical PEBBLE sensors range from about 50 to 300 nm. These sensors incorporate an oxygen-sensitive fluorescent indicator, Ru(II)-tris(4,7-diphenyl-1,10-phenanthroline) chloride ([Ru(dpp)3]2+), and an oxygen-insensitive fluorescent dye, Oregon Green 488-dextran, as a reference for the purpose of ratiometric intensity measurements. The PEBBLE sensors have excellent reversibility, dynamic range, and stability to leaching and photobleaching. The small size and inert matrix of these sensors allow them to be inserted into living cells with minimal physical and chemical perturbations to their biological functions. Applications of sol-gel PEBBLEs inserted in rat C6 glioma cells for real-time intracellular oxygen analysis are demonstrated. Compared to using free dyes for intracellular measurements, the PEBBLE matrix protects the fluorescent dyes from interference by proteins in cells, enabling reliable in vivo chemical analysis. Conversely, the matrix also significantly reduces the toxicity of the indicator and reference dyes to the cells, so that a wide variety of dyes can be used in optimal fashion.

Optical biosensing of nitric oxide using the metalloprotein cytochrome c'.

The metalloprotein cytochrome c' was extracted and purified from the bacterium Paracoccus denitrificans in order to develop a specific biosensing system for nitric oxide (NO). The metalloprotein was encapsulated in a porous silicate sol-gel glass to enable spectroscopic changes in the haem centre as a function of NO ligation to be quantified using absorption measurements. Spectroscopic evidence suggested that, between 2 and 4 d after encapsulation, the cytochrome c' protein changed conformation in the locality of the haem moiety, possibly from a five to a six coordinate haem centre. Such conformational changes were also observed when the cytochrome c' was stored in solution, although over a 2-3 month period. The conformational changes occurring in the protein altered the spectral characteristics of the reduced, oxidised and nitrosyl complex of the cytochrome c' and appear to change the binding affinity of the protein towards NO. However, the encapsulated (reconformed) cytochrome c' was shown to retain its selectivity towards NO with good reproducibility (seven consecutive measurements of NO produced an intensity value with a relative standard deviation of 0.28%). An NO calibration curve, using the in situ release of NO from the donor diethylamine NONOate, was obtained for the encapsulated cytochrome c' with an approximate working range of 10-400 mumol l-1.