RESUMO
Pure and doped Ba(6)Ti(2)Nb(8)O(30) (BTN), obtained by substituting M = Cr, Mn, or Fe on the Ti site (Ba(6)Ti(2-x) M(x)Nb(8)O(30), x = 0.06 and 0.18) and Y and Fe on the Ba and Ti sites, respectively (Ba(6-x)Y(x)Ti(2-x)Fe(x)Nb(8)O(30), x= 0.18), are synthesized. The influence of cation doping on the local structure, the cation oxidation state, and the possible defect formation able to maintain the charge neutrality are investigated by spectroscopic (electron paramagnetic resonance (EPR) and micro-Raman), structural (X-ray powder diffraction) and transport (impedance spectroscopy, thermoelectric power) measurements, in the temperature range of 300-1200 K in air and N(2) flow. Starting from the valence state of the doping ions (Fe(3+), Cr(3+), and Mn(2+)), determined by EPR, and from thermoelectric power measurements, evidencing a negative charge transport, different charge-compensating defect equilibria, based on the creation of positive electron holes or oxygen vacancies and electrons, are discussed to interpret the conductivity results.
RESUMO
Single crystals of TiO(2) rutile doped with Cr, Mn, Fe, Co, Ni, and Cu were grown with the flux method in a Na(2)B(4)O(7) melt. The samples, checked in their structural and phase homogeneity by x-ray diffraction and micro-Raman spectroscopy, were single-phase needle-shaped crystals several millimetres long. Paramagnetic and ferromagnetic behaviours at room temperature were observed and they are discussed also in connection with the magnetic properties of undoped TiO(2) crystals.
RESUMO
This study deals with the effects of 5 and 10% chromium additions on the transport and structural properties of Li3VO4. The Cr substitution is easily obtained without impurity phases and does not affect the room- and high-temperature host crystal structure, as evidenced by X-ray powder diffraction and micro-Raman analysis. The EPR signals are interpreted in terms of quantified amounts of Cr ions in 5+ and 3+ valence states. Suitable 7Li and 51V MAS NMR spectra simulations agree with the EPR results about the relative amount of Cr5+ and Cr3+ ions substituted in V5+ and Li+ sites, respectively. The Cr3+ presence on Li site, also suggested by Raman results and Rietveld refinements, requires Li vacancies to maintain the charge neutrality. The p-type conductivity, suggested by the positive thermoelectric power coefficients, significantly increases by the cation doping up to an order of magnitude.
RESUMO
Beryllium oxide dosimeters (Termalox 995) have been irradiated (at 60-Co facility) with graduated doses from 3 X 10(-1) to 1 X 10(2) Gy (30 to 10.000 rad). EPR measurements show a very good linear correlation between the amplitude of signal and the absorbed dose. This method has the advantage that the stored information into dosimeter doesn't regress "after reading procedure".