Analysis of nerve agent degradation products in high-conductivity matrices by transient ITP preconcentration and CZE separation coupled to ESI-MS.

Preconcentration of nerve agent degradation products (alkyl methylphosphonic acids) contained in high-conductivity matrices was performed using transient ITP to enhance sensitivity of CE-ESI-MS. The separation conditions of the five studied alkyl methylphosphonic acids in CE-MS were first optimized. The presence of methanol in the separation medium was required to obtain a good separation of the analytes under counter-EOF conditions. Preconcentration by ITP was induced by the BGE acting as leading electrolyte (LE) while the terminating electrolyte (TE) was loaded before the sample because of the counter-EOF conditions. Different leading ions (formate or acetate) and LE concentrations were tested. The best results for the analysis of soil extracts fortified with the analytes were obtained with an LE composed of 30 mM CH(3)COONH(4) adjusted to pH 8.8 with ammonium hydroxide in (35:65 v/v) MeOH/H(2)O mixture. The TE consisted of 200 mM glycine adjusted to pH 10.0 with ammonium hydroxide in the same solvent mixture. The loading length of the TE zone was optimized. The initial pH of the TE, which determined the initial mobility of the terminating ion, appeared to markedly influence the resolution and the sensitivity. This transient ITP-CZE-MS method was then adapted for the analysis of rat urine samples fortified with the analytes, which required the use of a more concentrated LE (50 mM). LODs between 4 and 70 ng/mL in soil extract, and between 5 and 75 ng/mL in rat urine were reached from extracted ion electropherograms.

Field-amplified sample stacking for the detection of chemical warfare agent degradation products in low-conductivity matrices by capillary electrophoresis-mass spectrometry.

Preconcentration of chemical warfare agent degradation products (alkylphosphonic acids and alkyl alkylphosphonic acids) in low-conductivity matrices (purified water, tap water and local river water) by field-amplified sample stacking (FASS) was developed for capillary electrophoresis (CE) coupled to ion trap mass spectrometry. FASS was performed by adding a mixture of HCOONH(4) and NH(4)OH in appropriate concentrations to the sample. This allowed to control the conductivity and the pH of the sample in order to obtain FASS performances that are independent of analyte concentration. The influence of different parameters on FASS (sample to background electrolyte (BGE) conductivity ratio, injection volume and concentration of BGE) was studied to determine the optimal conditions and was rationalized by using the theoretical model developed by Burgi and Chien. A good correlation was obtained between the bulk electroosmotic velocity predicted by this model and the experimental value deduced from the migration time of the electroosmotic flow marker detected by mass spectrometry (MS). This newly developed method was successfully applied to the analysis of tap water and local river water fortified with the analytes and provided a 10-fold sensitivity enhancement in comparison to the signal obtained without preconcentration procedure. The quite satisfactory repeatability and linearity for peak areas obtained in the 0.5-5 microg mL(-1) concentration range allow quantitative analysis to be implemented. Limits of detection of 0.25-0.5 microg mL(-1) for the alkyl alkylphosphonic acids and of 0.35-5 microg mL(-1) for the alkylphosphonic acids were reached in tap water and river water.

Extraction of alkyl methylphosphonic acids from aqueous samples using a conventional polymeric solid-phase extraction sorbent and a molecularly imprinted polymer.

The analysis of alkyl methylphosphonic acids (AMPAs) constitutes an important subject for verifying the compliance to the Chemical Weapons Convention (CWC). Indeed, alkyl methylphosphonic acids are the degradation products of V and G nerve agents such as VX, sarin or soman. Lowering the limits of detection of analytical methods for complex aqueous matrices implies the introduction of concentration and clean-up steps in the whole analytical process. Therefore a molecular imprinted polymer (MIP) has been previously developed for the selective extraction and the concentration of the alkyl methylphosphonic acids. Unfortunately, the selective retention process on this MIP has involved the development of hydrogen bonds and so does not allow the direct percolation of aqueous samples. A change of solvent is then necessary and can be performed using solid-phase extraction (SPE) with conventional non selective hydrophobic sorbents. Two polymeric sorbents, Oasis HLB and HR-P resins, were selected for their high specific surface area. The extraction recoveries obtained on both sorbents were compared and the Oasis HLB sorbent was further selected and used for the percolation of acidified aqueous samples. An optimised SPE procedure was then applied to concentrate an aqueous soil extract spiked with isobutyl methylphosphonic acid (iBMPA) and cyclopentyl methylphosphonic acid (cPMPA) that was further cleaned-up by passing through the MIP. The resulting LC-MS full scan chromatograms highlight the clean-up effect of the SPE-MIP association by the removal of the matrix substances and the preservation of 95% of the compounds of interest.

Separation and identification of isomeric acidic degradation products of organophosphorus chemical warfare agents by capillary electrophoresis-ion trap mass spectrometry.

Capillary electrophoresis (CE) coupled to ion trap mass spectrometry (MS) was evaluated for the separation and identification of chemical warfare agent degradation products (alkylphosphonic acids and alkyl alkylphosphonic acids). Different analytical parameters were optimized in negative ionization mode such as electrolyte composition (15 mM CH(3)COONH(4), pH 8.8), sheath liquid composition (MeOH/H(2)O/NH(3), 75:25:2, v/v/v), nebulization and ion trapping conditions. A standard mixture of five alkylphosphonic (di)acids and five alkyl alkylphosphonic (mono)acids containing isomeric compounds was used in order to evaluate CE selectivity and MS identification capability. The obtained electropherograms revealed that CE selectivity was very limited in the case of alkyl alkylphosphonic acid positional isomers, whereas isomeric isopropylphosphonic and propylphosphonic acids were baseline-separated. CE-MS-MS experiments provided an unambiguous identification of each isomeric co-migrating alkyl alkylphosphonic acids thanks to the presence of specific fragment ions. On the other hand, CE separation was mandatory for the identification of isomeric alkylphosphonic acids, which led to the same fragment ion and could not be differentiated by MS-MS. The developed method was applied to the analysis of soil extracts spiked with the analytes (before or after extraction treatment) and appeared to be very promising since resolution and sensitivity were similar to those observed in deionized water. Especially, analytes were detected and identified in soil extract spiked at 5 microg mL(-1) with each compound before extraction treatment.

Applications of deactivated GC columns for analysis of nitrogen-containing chemicals related to the chemical weapons convention.

Nitrogen-containing chemicals are one of the important families of compounds relevant to the purposes of the Chemical Weapons Convention (CWC). Several applications, using various injection modes, of new deactivated columns specially designed for basic compounds are presented. These columns prove remarkably well-suited to the gas chromatographic (GC) analysis of the chemicals of interest, even to underivatized amino-alcohols, whose analysis on conventional GC columns is often difficult and hindered by poor resolution and high detection limits. Such a deactivated phase can even replace the typical GC phases used for CWC verification purposes.

Selective extraction of organophosphorus nerve agent degradation products by molecularly imprinted solid-phase extraction.

The analysis of alkyl alkylphosphonic acids, the degradation products of V and G nerve agents as VX, Sarin or Soman, is an important task for the verification of compliance to the Chemical Weapons Convention. The detection of these contaminants at low concentration levels is often difficult in complex matrices due to the amount of interfering substances. Molecularly imprinted solid-phase extraction technique should allow a selective extraction of these compounds from complex samples, and thus make their detection easier. Two molecularly imprinted polymers (MIPs) prepared with methacrylic acid (MAA) as monomer and pinacolyl methylphosphonic acid (PMPA) as template molecule were synthesised and tested. The first polymer, MIP A, was prepared with ethylene glycol dimethacrylate (EGDMA) in dichloromethane. The second polymer, MIP B, was synthesised using trimethylolpropane trimethacrylate (TRIM) in acetonitrile. To evaluate the selectivity provided by these MIPs, the retention of the ethyl methylphosphonic acid (EMPA) target molecule was studied in parallel on a non-imprinted polymer (NIP). While MIP A does not show any difference compared to NIP A, a good selectivity was obtained for MIP B. After the optimisation of the extraction process, 60% of EMPA can be removed from the NIP B without affecting the retention on the MIP B. A recovery of extraction of 93% was then obtained on the MIP B. Its capacity was then measured and corresponds to 97 microg of EMPA per gram of MIP. Finally, the selectivity of MIP B was clearly demonstrated by applying it to the clean-up of a soil extract spiked with EMPA.

Investigation of compound-independent calibration and partial molecular formula determination by gas chromatography-atomic-emission detection for characterisation of organophosphorus and organosulfur agents related to the chemical weapons convention.

Atomic-emission detection (AED) is a technique particularly-well suited to screening complex samples for multiple compounds containing heteroatoms such as phosphorus, sulfur, or nitrogen, which are especially relevant in verification of chemical disarmament. Among other GC detectors, AED has unique characteristics such as compound-independent calibration and possible raw-formula determination. Because contradictory results have been reported on these points, we set up a study with the objectives not only of applying these techniques to chemical weapons convention-related chemicals but of determining under which conditions they would yield satisfactory results. The extensive data collected in this study are evidence that the response of the detector, particularly for the phosphorus line, is very dependent on the molecular mass and concentration of the chemicals analysed whereas molecular structure seems to have less effect on the AED signal. Most interestingly, compound-independent calibration and subsequent partial molecular formula determination usually seem satisfactory when the reference compounds used to calibrate the system have GC retention times and molecular masses close to those of the unknown analytes (whose molecular mass may be determined by GC-CI-MS). We therefore suggest the use of a reference set of compounds covering a large chromatographic window, which enables the selection, within this set, of the most appropriate reference compound for calibration and for determination of the raw formula of an unknown analyte. For optimal performance, the use of a new discharge tube is also recommended.

Optimisation of sorbent trapping and thermal desorption-gas chromatography-mass spectrometric conditions for sampling and analysis of hydrogen cyanide in air.

Among the chemicals belonging to the schedules of the Chemical Weapons Convention (CWC), sampling and analysis of highly volatile compounds such as hydrogen cyanide (HCN) require special consideration. The latter is present in numerous old chemical weapons that are stockpiled awaiting destruction in Northeastern France: thus, sampling on stockpile area and subsequent verification of HCN levels is compulsory to ensure safety of workers on these areas. The ability of several commercial sorbents to trap hydrogen cyanide at various concentration levels and in various humidity conditions, was evaluated. Furthermore, thermal desorption of the corresponding samples, followed by analysis by gas chromatography-mass spectrometry was also optimised. Carbosieve S-III, a molecular sieve possessing a very high specific area, proved the most efficient sorbent for HCN sampling in all conditions tested. Conversely, the presented results show that Tenax, albeit generally considered as the reference sorbent for air monitoring and analysis of CWC-related chemicals, is not suitable for HCN trapping.

Extraction of nerve agent VX from soils.

The development and optimization of a method allowing the extraction of intact organophosphorus chemical warfare agent O-ethyl S-(2-diisopropylaminoethyl) methylphosphonothiolate (VX) from several types of soils are presented here. This involved the selection of an appropriate buffer to bring the sample to a pH close to the pK(a) of VX but sufficiently low to avoid its basic hydrolysis. Buffering with Tris (pH 9) and subsequent extraction of the aqueous layer by a 85:15 (v/v) hexane/dichloromethane mixture allows rapid and sensitive flame photometric detection of VX at spiking levels lower than 10 microg x g(-1), even after 3 months of aging. Extraction yields were close to 60% in complex matrixes. This method also allows recovery and identification of a characteristic degradation product of VX, bis(2-diisopropylaminoethyl) disulfide, which appears to be formed during the aging process. The performance of this method is far better than that of OPCW reference operating procedure, which does not allow extraction of detectable amounts of VX (spiked at 10 microg x g(-1)) in one of the soils used for this study.