RESUMO
OBJECTIVE: This study aimed to analyze the effect of irradiation on the push-out bond strength of mineral trioxide aggregate (MTA) and Biodentine to radicular dentin. METHODOLOGY: A total of 60 extracted mature human teeth with single root canals were categorized into two groups (irradiated and non-irradiated) (n=30). Each group was further divided into two sub-groups based on cements used (Biodentine and MTA). Then, a cumulative radiation dose of 60 Gy was divided into 30 fractions (two Gy for every fraction) and administered for five successive days per week over six weeks. Obturation was then performed using MTA and Biodentine. Afterwards, 1.5 mm thick horizontal sections were procured from the middle one-third of all the specimens and then subjected to push-out bond test. Results were analyzed using one-way analysis of variance with post-hoc Tukey's test. RESULTS: The bond strength of Biodentine and MTA to irradiated teeth was lower than non-irradiated teeth. Highest push-out bond strength was observed in non-irradiated specimens filled with Biodentine (p=0), followed by irradiated specimens filled with Biodentine (p=0); non-irradiated specimens filled with MTA (p=0); and irradiated specimens filled with MTA (p=0.9). CONCLUSION: The push-out bond strength of Biodentine and MTA to root canal dentin decreased significantly post irradiation.
Assuntos
Cemento Dentário , Raiz Dentária , Humanos , Silicatos , DentinaRESUMO
Abstract Objective This study aimed to analyze the effect of irradiation on the push-out bond strength of mineral trioxide aggregate (MTA) and Biodentine to radicular dentin. Methodology A total of 60 extracted mature human teeth with single root canals were categorized into two groups (irradiated and non-irradiated) (n=30). Each group was further divided into two sub-groups based on cements used (Biodentine and MTA). Then, a cumulative radiation dose of 60 Gy was divided into 30 fractions (two Gy for every fraction) and administered for five successive days per week over six weeks. Obturation was then performed using MTA and Biodentine. Afterwards, 1.5 mm thick horizontal sections were procured from the middle one-third of all the specimens and then subjected to push-out bond test. Results were analyzed using one-way analysis of variance with post-hoc Tukey's test. Results The bond strength of Biodentine and MTA to irradiated teeth was lower than non-irradiated teeth. Highest push-out bond strength was observed in non-irradiated specimens filled with Biodentine (p=0), followed by irradiated specimens filled with Biodentine (p=0); non-irradiated specimens filled with MTA (p=0); and irradiated specimens filled with MTA (p=0.9). Conclusion The push-out bond strength of Biodentine and MTA to root canal dentin decreased significantly post irradiation.
RESUMO
ABSTRACT Objective: To assess the efficacy of 5% Glycolic Acid (GA), 17% ethylenediaminetetraacetic acid (EDTA) and 7% maleic acid (MA), in removing the smear layer (SL). Material and Methods: For the experiment, forty single-rooted human teeth were selected. To perform the chemo‑mechanical preparation, the root canals were instrumented to an apical size of #30, along with simultaneous irrigation of 2.5% NaOCl. The samples were allotted to the experimental groups based on the final irrigating solution (n=10): (1) The GA group: 05%, (2) the EDTA group: 17%, (3) the MA group: 7%, and (4) the control group: Distilled water. The teeth were evaluated for the presence or absence of SL using SEM. Results: Comparing the 5% GA, 7% MA and 17% EDTA groups, no statistically significant differences were found at the coronal and middle thirds (p>0.05). However, in the apical third, MA had greater efficacy than EDTA (p=0.002) and GA (p=0.041), with a significant difference in the SL removal, while there was no significant difference between the latter (p=0.148). Conclusion: Thus, it was concluded that 7% maleic acid as a final irrigating solution is more efficacious than 17% EDTA and 5% glycolic acid in eliminating the smear layer from the apical portion of the root canal.
Assuntos
Humanos , Camada de Esfregaço , Ácido Edético/química , Preparo de Canal Radicular/instrumentação , Cavidade Pulpar , Microscopia Eletrônica de Varredura/instrumentação , Distribuição de Qui-Quadrado , Estatísticas não ParamétricasRESUMO
Objective: Endodontically obturated teeth have lower fracture resistance depending on the obturating material and technique. The purpose of this study was therefore to evaluate the influence of ProRoot MTA (Dentsply Sirona, Tulsa Division) and OrthoMTA III (BioMTA, Daejeon, Korea) as an obturating material on the fracture resistance of endodontically treated teeth. Material and Methods: Thirty extracted human maxillary central incisors were decoronated and instrumented using Protaper instruments (size F5). Irrigation was performed with 2.5% sodium hypochlorite between each instrument change followed by 7% maleic acid for one minute. Finally, canals were flushed with 5 ml of PBS solution for one minute. Samples were then divided into three groups. Group I- positive control (no root canal filling); Group II- obturation with ProRoot MTA; Group III- obturation with OrthoMTA III. Ten teeth were randomly selected as a negative control in which no treatment was performed. All the specimens were then subjected to fracture strength testing using universal testing machine. For evaluation of biomineralization, six maxillary central incisors were divided into two groups. Group I obturated with ProRoot MTA and group II obturated with OrthoMTA III. These samples were subjected to SEM analysis. Results: Positive control group demonstrated the least fracture resistance, while OrthoMTA III group showed the highest fracture resistance. There was no significant difference between negative control group and ProRoot MTA groups (p=0.821). OrthoMTA III group showed better tubular biomineralization when compared to ProRoot MTA. Conclusions: Root canals obturated with OrthoMTA III had better fracture resistance and increased tubular biomineralization compared to ProRoot MTA. Since root canals obturated with OrthoMTA III had better fracture resistance, it can be used as a promising obturating material.(AU)
Objetivo: Dentes obturados endodonticamente apresentam menor resistência à fratura, dependendo do material e da técnica de obturação. Portanto, o objetivo deste estudo foi avaliar a influência do ProRoot MTA (Dentsply Sirona, Tulsa Division) e OrthoMTA III (BioMTA, Daejeon, Coréia) como material obturador na resistência à fratura de dentes tratados endodonticamente. Material e Métodos: Trinta incisivos centrais superiores humanos extraídos foram decoronados e instrumentados com instrumentos Protaper (tamanho F5). A irrigação foi realizada com hipoclorito de sódio a 2,5% entre cada troca de instrumento, seguida por ácido maleico a 7% por um minuto. Finalmente, os canais foram lavados com 5 ml de solução de PBS por um minuto. As amostras foram então divididas em três grupos. Grupo I - controle positivo(sem preenchimento do canal radicular); Grupo II - obturação com ProRoot MTA; Grupo III -obturação com OrthoMTA III. Dez dentes foram selecionados aleatoriamente como controle negativo, no qual nenhum tratamento foi realizado. Todas as amostras foram então submetidas atestes de resistência à fratura usando uma máquina de teste universal. Para avaliação da biomineralização, seis incisivos centrais superiores foram divididos em dois grupos: grupo Iobturado com ProRoot MTA e grupo II obturado com OrthoMTA III. Essas amostras foram submetidas à análise SEM. Resultados: O grupo controle positivo demonstrou a menor resistência à fratura, enquanto o grupo OrthoMTA III apresentou a maior resistência à fratura. Não houve diferença significativa entre o grupo controle negativo e os grupos ProRoot MTA (p= 0,821). O grupo OrthoMTA III apresentou melhor biomineralização tubular quando comparado ao ProRoot MTA. Conclusões: Os canais radiculares obturados com OrthoMTA III apresentaram melhor resistência à fratura e maior biomineralização tubular em comparação como ProRoot MTA. Como os canais radiculares obturados com OrthoMTA III apresentaram melhor resistência à fratura, podendo ser utilizado como um material obturador promissor.(AU)