Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 3 de 3
Filtrar
Mais filtros











Base de dados
Intervalo de ano de publicação
1.
Opt Express ; 20(11): 11806-12, 2012 May 21.
Artigo em Inglês | MEDLINE | ID: mdl-22714168

RESUMO

We present and demonstrate a simple and cost-effective technique for improving the modulation bandwidth of electroabsorption-modulated laser (EML). This technique utilizes the RF resonance caused by the EML chip (i.e., junction capacitance) and bonding wire (i.e, wire inductance). We analyze the effects of the lengths of the bonding wires on the frequency responses of EML by using an equivalent circuit model. To verify this analysis, we package a lumped EML chip on the sub-mount and measure its frequency responses. The results show that, by using the proposed technique, we can increase the modulation bandwidth of EML from ~16 GHz to ~28 GHz.


Assuntos
Lasers , Absorção , Campos Eletromagnéticos , Desenho de Equipamento , Análise de Falha de Equipamento
2.
Opt Express ; 17(11): 9401-7, 2009 May 25.
Artigo em Inglês | MEDLINE | ID: mdl-19466192

RESUMO

We have fabricated modules of 8-channel multi-wavelength lasers (MWLs) with a wavelength separation of 200 GHz for the wavelength division multiplexed-passive optical network (WDM-PON) optical line terminal sources. The variation in the output power is minimized by inserting silicone between the superluminescent diode (SLD) and the silica waveguide. The wavelength shift of each channel is less than 0.21 nm from the ITU grid and can be controlled in the range of 0.36 nm without any reductions of the output power by a tuning heater. MWLs operated successfully in the direct modulation for 1.25 Gbit/s transmissions over 20 km.


Assuntos
Lasers , Iluminação/instrumentação , Processamento de Sinais Assistido por Computador , Telecomunicações/instrumentação , Desenho Assistido por Computador , Desenho de Equipamento , Análise de Falha de Equipamento , Micro-Ondas , Reprodutibilidade dos Testes , Semicondutores , Sensibilidade e Especificidade
3.
Opt Express ; 17(25): 22838-46, 2009 Dec 07.
Artigo em Inglês | MEDLINE | ID: mdl-20052209

RESUMO

We investigate theoretically and experimentally the effect of the physical length of gain medium on dynamic mode stability in semiconductor lasers with an intra-cavity filter. In simulation, two types of analysis models were used to examine the lasing properties and to analyze the dynamic mode stability of the external-cavity system, respectively. In experiment, two different kinds of the structures were fabricated and their spectra were analyzed. Both simulation and measurement results show clearly the length of the gain medium has a critical influence on the stability around the peak wavelength of the filter.


Assuntos
Amplificadores Eletrônicos , Lasers Semicondutores , Modelos Teóricos , Refratometria/instrumentação , Simulação por Computador , Desenho Assistido por Computador , Desenho de Equipamento , Análise de Falha de Equipamento
SELEÇÃO DE REFERÊNCIAS
DETALHE DA PESQUISA