Temperature modulation of a catalytic gas sensor.

The use of catalytic gas sensors usually offers low selectivity, only based on their different sensitivities for various gases due to their different heats of reaction. Furthermore, the identification of the gas present is not possible, which leads to possible misinterpretation of the sensor signals. The use of micro-machined catalytic gas sensors offers great advantages regarding the response time, which allows advanced analysis of the sensor response. By using temperature modulation, additional information about the gas characteristics can be measured and drift effects caused by material shifting or environmental temperature changes can be avoided. In this work a miniaturized catalytic gas sensor which offers a very short response time (<150 ms) was developed. Operation with modulated temperature allows analysis of the signal spectrum with advanced information content, based on the Arrhenius approach. Therefore, a high-precise electronic device was developed, since theory shows that harmonics induced by the electronics must be avoided to generate a comprehensible signal.

Effect of surface chemistry on the stability of gold nanostructures.

Understanding the role of surface chemistry in the stability of nanostructured noble-metal materials is important for many technological applications but experimentally difficult to access and thus little understood. To develop a fundamental understanding of the effect of surface chemistry on both the formation and stabilization of self-organized gold nanostructures, we performed a series of controlled-environment annealing experiments on nanoporous gold (np-Au) and ion-bombarded Au(111) single-crystal surfaces. The annealing experiments on np-Au in ambient ozone were carried out to study the effect of adsorbed oxygen under dynamic conditions, whereas the ion-bombarded Au single-crystal surfaces were used as a model system to obtain atomic-scale information. Our results show that adsorbed oxygen stabilizes nanoscale gold structures at low temperatures whereas oxygen-induced mobilization of Au surface atoms seems to accelerate the coarsening under dynamic equilibrium conditions at higher temperatures.

Ultralow loading Pt nanocatalysts prepared by atomic layer deposition on carbon aerogels.

Using atomic layer deposition (ALD), we show that Pt nanoparticles can be deposited on the inner surfaces of carbon aerogels (CA). The resultant Pt-loaded materials exhibit high catalytic activity for the oxidation of CO even at loading levels as low as approximately 0.05 mg Pt/cm2. We observe a conversion efficiency of nearly 100% in the 150-250 degrees C temperatures range, and the total conversion rate seems to be limited only by the thermal stability of the CA support in ambient oxygen. The ALD approach described here is universal in nature, and can be applied to the design of new catalytic materials for a variety of applications, including fuel cells, hydrogen storage, pollution control, green chemistry, and liquid fuel production.